Flow Boiling Visualization of R-134a in a Vertical Channel of Small Diameter

2007 ◽  
Author(s):  
Claudi Marti´n-Callizo ◽  
Bjo¨rn Palm ◽  
Wahib Owhaib ◽  
Rashid Ali
Keyword(s):  
Flow Pattern ◽  
Annular Flow ◽  
Two Phase Flow ◽  
Flow Boiling ◽  
Bubbly Flow ◽  
Flow Patterns ◽  
Phase Flow ◽  
Two Phase ◽  
R 134A ◽  
Heated Length

The present work reports on flow boiling visualization of refrigerant R-134a in a vertical circular channel with internal diameter of 1.33 mm and 235 mm in heated length. Quartz tube with a homogeneous ITO-coating is used allowing heating and simultaneous visualization. Flow patterns have been observed along the heated length with the aid of a digital camera with close-up lenses. From the flow boiling visualization, seven distinct two-phase flow patterns have been observed: Isolated bubbly flow, confined bubbly flow, slug flow, churn flow, slug-annular flow, annular flow, and mist flow. Two-phase flow pattern observations are presented in the form of flow pattern maps. Finally, the experimental flow pattern map is compared to models developed for conventional sizes as well as to a microscale map for air-water mixtures available in the literature, showing a large discrepancy.

Flow Boiling Visualization of R-134a in a Vertical Channel of Small Diameter

2010 ◽  
Vol 132 (3) ◽  
Author(s):  
Claudi Martín-Callizo ◽  
Björn Palm ◽  
Wahib Owhaib ◽  
Rashid Ali
Keyword(s):  
Flow Pattern ◽  
Annular Flow ◽  
Two Phase Flow ◽  
Flow Boiling ◽  
Bubbly Flow ◽  
Flow Patterns ◽  
Phase Flow ◽  
Two Phase ◽  
R 134A ◽  
Heated Length

The present work reports on flow boiling visualization of refrigerant R-134a in a vertical circular channel with an internal diameter of 1.33 mm and 235 mm in heated length. A quartz tube with a homogeneous Indium Tin Oxide coating is used to allow heating and simultaneous visualization. Flow patterns have been observed along the heated length with the aid of high-speed complementary metal oxide semiconductor (CMOS) digital camera. From the flow boiling visualization, seven distinct two-phase flow patterns have been observed: isolated bubbly flow, confined bubbly flow, slug flow, churn flow, slug-annular flow, annular flow, and mist flow. Two-phase flow pattern observations are presented in the form of flow pattern maps. The effects of the saturation temperature and the inlet subcooling degree on the two-phase flow pattern transitions are elucidated. Finally, the experimental flow pattern map is compared with models developed for conventional sizes as well as to a microscale map for air-water mixtures available in literature, showing a large discrepancy.

Two-Phase Flow and Heat Transfer in Rectangular Micro-Channels

2004 ◽  
Vol 126 (3) ◽  
pp. 288-300 ◽  
Author(s):  
Weilin Qu ◽  
Seok-Mann Yoon ◽  
Issam Mudawar
Keyword(s):  
Heat Transfer ◽  
Pressure Drop ◽  
Flow Pattern ◽  
Two Phase Flow ◽  
Flow Boiling ◽  
Flow Patterns ◽  
Heat Sinks ◽  
Phase Flow ◽  
Micro Channel ◽  
Two Phase

Knowledge of flow pattern and flow pattern transitions is essential to the development of reliable predictive tools for pressure drop and heat transfer in two-phase micro-channel heat sinks. In the present study, experiments were conducted with adiabatic nitrogen-water two-phase flow in a rectangular micro-channel having a 0.406×2.032mm2 cross-section. Superficial velocities of nitrogen and water ranged from 0.08 to 81.92 m/s and 0.04 to 10.24 m/s, respectively. Flow patterns were first identified using high-speed video imaging, and still photos were then taken for representative patterns. Results reveal the dominant flow patterns are slug and annular, with bubbly flow occurring only occasionally; stratified and churn flow were never observed. A flow pattern map was constructed and compared with previous maps and predictions of flow pattern transition models. Features unique to two-phase micro-channel flow were identified and employed to validate key assumptions of an annular flow boiling model that was previously developed to predict pressure drop and heat transfer in two-phase micro-channel heat sinks. This earlier model was modified based on new findings from the adiabatic two-phase flow study. The modified model shows good agreement with experimental data for water-cooled heat sinks.

An Experimental Study on Air-Water Two-Phase Flow Patterns in Pebble Beds

2010 ◽  
Vol 132 (4) ◽  
Author(s):  
Bai Bofeng ◽  
Liu Maolong ◽  
Su Wang ◽  
Zhang Xiaojie
Keyword(s):  
Experimental Study ◽  
Flow Pattern ◽  
Test Section ◽  
Slug Flow ◽  
Annular Flow ◽  
Two Phase Flow ◽  
Flow Patterns ◽  
Phase Flow ◽  
Two Phase ◽  
Flow Pattern Transition

An experimental study was conducted on the air-water two-phase flow patterns in the bed of rectangular cross sections containing spheres of regular distribution. Three kinds of glass spheres with different diameters (3 mm, 6 mm, and 8 mm) were used for the establishment of the test section. By means of visual observations of the two-phase flow through the test section, it was discovered that five different flow patterns occurred within the experimental parameter ranges, namely, bubbly flow, bubbly-slug flow, slug flow, slug-annular flow, and annular flow. A correlation for the bubble and slug diameter in the packed beds was proposed, which was an extended expression of the Tung/Dhir model, Jamialahmadi’s model, and Schmidt’s model. Three correlations were proposed to calculate the void friction of the flow pattern transition in bubble flow, slug flow, and annular flow based on the bubble model in the pore region. The experimental result showed that the modified Tung and Dhir model of the flow pattern transition was in better agreement with the experimental data compared with Tung and Dhir’s model.

The Visualization of Flow Boiling in a Uniformly Heated Micro Capillary Tube

2006 ◽  
Author(s):  
X. H. Yan ◽  
J. Z. Xu ◽  
D. W. Tang
Keyword(s):  
Pressure Drop ◽  
Slug Flow ◽  
Annular Flow ◽  
Capillary Tube ◽  
Flow Boiling ◽  
Bubbly Flow ◽  
Flow Patterns ◽  
Phase Flow ◽  
Two Phase ◽  
Inner Diameter

This work presents experiments on the visualization of flow boiling of water in a horizontally placed and uniformly heated micro capillary tube. Three micro capillary tubes of quartz glass with inner diameters of 520, 315 and 242 μm are prepared. Experiments are performed with deionized water over a mass flux range from 39.3 to 362.5kg/m2s, and the inlet temperatures of 30, 45, and 60 °C respectively. By a video system with microscope and high-speed camera, the vapor-water two-phase flow’s patterns are recorded and analyzed. It has been found that periodic change of two-phase flow patterns and dramatic fluctuations of pressure drop occur in the micro capillary tubes. A new arch flow pattern, liquid film evaporating, and liquid droplet have been observed firstly. Bubbly flow has not been observed during our visual experiments for the inner diameter of 242 μm, the flow patterns are only made up of single liquid phase flow and two-phase elongate slug flow. The main flow regimes in these micro-tubes are single-liquid flow, slug flow, and annular flow with liquid film surrounded in the micro-tube with inner diameter of 520 and 315μm. Trends of pressure drop and flow patterns’ transition are compared and the results show that the increasing process of pressure drop is approximately in the single-liquid flow and bubbly flow, while the decreasing process of pressure drop is in the state of annular flow.

Co-Current Air-Water Two Phase Flow Patterns in Horizontal and Vertical Circular Tube Under Various Inlet Conditions

2011 ◽  
Author(s):  
S. Zeguai ◽  
S. Chikh ◽  
O. Rahli ◽  
L. Tadrist
Keyword(s):  
Annular Flow ◽  
Two Phase Flow ◽  
Bubbly Flow ◽  
Flow Patterns ◽  
Phase Flow ◽  
Transition Flow ◽  
Two Phase ◽  
Experimental Apparatus ◽  
Inner Diameter ◽  
Inlet Conditions

An experimental apparatus is setup to analyze a co-current air-water two phase flow in a 3 mm inner diameter tube with horizontal and vertical orientations. Air is axially injected through a nozzle of 260 μm of inner diameter. Air and water flow rates are accurately controlled at the inlet, covering a range of apparent velocities JL = 0.00118 to 0.0786 m/s, JG = 0.002 to 3.538 m/s for the horizontal tube and JL = 0.00078 to 0.0589 m/s, JG = 0.003 to 3.538 m/s for the upward flow. A fast camera with 250 fps is utilized to visualize the flow patterns. The experiments showed that the flow structures are very sensitive to inlet conditions. Within the covered range of velocities, several flow patterns were observed, namely bubbly flow, bubbly-slug transition flow, slug flow, slug-annular transition flow, annular flow, wavy annular flow and annular flow with dry zones. In the bubbly flow regime, a particular bubbly helical flow is observed before the dispersed bubbly flow.

Micro-Scale Flow Pattern Classification Based on the K-Means Clustering Algorithm

2010 ◽  
Author(s):  
Daniel Sempe´rtegui ◽  
Gherhardt Ribastki
Keyword(s):  
Flow Pattern ◽  
High Speed ◽  
Clustering Algorithm ◽  
Two Phase Flow ◽  
Flow Boiling ◽  
Saturation Temperature ◽  
Flow Patterns ◽  
Statistical Characteristics ◽  
Phase Flow ◽  
Two Phase

In the present work, an objective method to characterize two-phase flow pattern was developed and implemented. The method is based on the characteristics of the signals provided by transducers measuring local temperature and pressure plus the intensity of a laser beam crossing the two-phase flow. The statistical characteristics of these signals were used as input features for the k-means clustering method. In order to implement the method, experimental flow patterns were obtained during flow boiling of R245fa in a 2.32 mm ID tube. Experiments were performed for mass velocities from 100 to 700kg/m2s, saturation temperature of 31 °C and vapor qualities up to 0.99. The cluster classification was compared against flow patterns segregated based on high speed camera images (8000 images/s) and a reasonable agreement was obtained.

Upward Vertical Two-Phase Flow Through an Annulus—Part II: Modeling Bubble, Slug, and Annular Flow

1992 ◽  
Vol 114 (1) ◽  
pp. 14-30 ◽  
Author(s):  
E. F. Caetano ◽  
O. Shoham ◽  
J. P. Brill
Keyword(s):  
Flow Pattern ◽  
Annular Flow ◽  
Two Phase Flow ◽  
Flow Behavior ◽  
Bubble Flow ◽  
Phase Flow ◽  
Two Phase ◽  
Flow Through ◽  
Physical Phenomena ◽  
Good Agreement

Mechanistic models have been developed for each of the existing two-phase flow patterns in an annulus, namely bubble flow, dispersed bubble flow, slug flow, and annular flow. These models are based on two-phase flow physical phenomena and incorporate annulus characteristics such as casing and tubing diameters and degree of eccentricity. The models also apply the new predictive means for friction factor and Taylor bubble rise velocity presented in Part I. Given a set of flow conditions, the existing flow pattern in the system can be predicted. The developed models are applied next for predicting the flow behavior, including the average volumetric liquid holdup and the average total pressure gradient for the existing flow pattern. In general, good agreement was observed between the experimental data and model predictions.

Two-Phase Flow and Heat Transfer in Rectangular Micro-Channels

2003 ◽  
Author(s):  
Weilin Qu ◽  
Seok-Mann Yoon ◽  
Issam Mudawar
Keyword(s):  
Heat Transfer ◽  
Pressure Drop ◽  
Flow Pattern ◽  
Two Phase Flow ◽  
Flow Patterns ◽  
Heat Sinks ◽  
Phase Flow ◽  
Micro Channel ◽  
Two Phase ◽  
Micro Channels

Knowledge of flow pattern and flow pattern transitions is essential to the development of reliable predictive tools for pressure drop and heat transfer in two-phase micro-channel heat sinks. In the present study, experiments were conducted with adiabatic nitrogen-water two-phase flow in a rectangular micro-channel having a 0.406 × 2.032 mm cross-section. Superficial velocities of nitrogen and water ranged from 0.08 to 81.92 m/s and 0.04 to 10.24 m/s, respectively. Flow patterns were first identified using high-speed video imaging, and still photos were then taken for representative patterns. Results reveal that the dominant flow patterns are slug and annular, with bubbly flow occurring only occasionally; stratified and churn flow were never observed. A flow pattern map was constructed and compared with previous maps and predictions of flow pattern transition models. Annual flow is identified as the dominant flow pattern for conditions relevant to two-phase micro-channel heat sinks, and forms the basis for development of a theoretical model for both pressure drop and heat transfer in micro-channels. Features unique to two-phase micro-channel flow, such as laminar liquid and gas flows, smooth liquid-gas interface, and strong entrainment and deposition effects are incorporated into the model. The model shows good agreement with experimental data for water-cooled heat sinks.

Sign in / Sign up

Export Citation Format

Share Document