RELATIONSHIPS BETWEEN THE PROXIMITY OF WASTEWATER DISPOSAL AND HYDRAULIC FRACTURING TO CRYSTALLINE BASEMENT AND INDUCED SEISMICITY, CENTRAL AND EASTERN UNITED STATES

2016 ◽  
Author(s):  
Brian S. Currie ◽  
◽  
Michael Brudzinski ◽  
Robert Skoumal
2020 ◽  
Vol 110 (5) ◽  
pp. 2272-2282 ◽  
Author(s):  
Rosamiel Ries ◽  
Michael R. Brudzinski ◽  
Robert J. Skoumal ◽  
Brian S. Currie

ABSTRACT Injection-induced seismicity became an important issue over the past decade, and although much of the rise in seismicity is attributed to wastewater disposal, a growing number of cases have identified hydraulic fracturing (HF) as the cause. A recent study identified regions in Oklahoma where ≥75% of seismicity from 2010 to 2016 correlated with nearly 300 HF wells. To identify factors associated with increased probability of induced seismicity, we gathered publicly available information about the HF operations in these regions including: injected volume, number of wells on a pad, injected fluid (gel vs. slickwater), vertical depth of the well, proximity of the well to basement rock, and the formation into which the injection occurred. To determine the statistical strength of the trends, we applied logistic regression, bootstrapping, and odds ratios. We see no trend with total injected volume in our Oklahoma dataset, in contrast to strong trends observed in Alberta and Texas, but we note those regions have many more multiwell pads leading to larger cumulative volumes within a localized area. We found a ∼50% lower probability of seismicity with the use of gel compared to slickwater. We found that HF wells targeting older formations had a higher probability of seismicity; however, these wells also tend to be deeper, and we found the trend with well depth to be stronger than the trend with age of formation. When isolated to the Woodford formation, well depth produced the strongest relationship, increasing from ∼5% to ∼50% probability from 1.5 to 5.5 km. However, no trend was seen in the proximity to basement parameter. Based on previously measured pore pressure gradients, we interpret the strong absolute depth relationship to be a result of the increasing formation overpressure measured in deeper portions of the basin that lower the stress change needed to induce seismicity.


Technologies ◽  
2020 ◽  
Vol 8 (4) ◽  
pp. 67
Author(s):  
Munshi Md. Shafwat Yazdan ◽  
Md Tanvir Ahad ◽  
Ishrat Jahan ◽  
Mozammel Mazumder

This paper scrutinized hydraulic fracturing applications mainly in the United States with regard to both groundwater and surface water contamination with the purpose of bringing forth objective analysis of research findings. Results from previous studies are often unconvincing due to the incomplete database of chemical additives; after and before well-founded water samples to define the change in parameters; and specific sources of water pollution in a particular region. Nonetheless, there is a superior chance of both surface and groundwater contamination induced by improper and less monitored wastewater disposal and management practices. This report has documented systematic evidence for total dissolved solids, salinity, and methane contamination regarding drinking water correlated with hydraulic fracturing. Methane concentrations were found on an average rate of 19.2 mg/L, which is 17 times higher than the acceptance rate and the maximum value was recorded as 64.2 mg/L near the active hydraulic fracturing drilling and extraction zones than that of the nonactive sites (1.1 mg/L). The concentration of total dissolved solids (350 g/L) was characterized as a voluminous amount of saline wastewater, which was quite unexpectedly high. The paper concludes with plausible solutions that should be implemented to avoid further contamination.


2020 ◽  
Author(s):  
Alessandro Verdecchia ◽  
Bei Wang ◽  
Yajing Liu ◽  
Rebecca Harrington ◽  
Marco Roth ◽  
...  

<p>The Dawson-Septimus area near the towns of Dawson Creek and Fort St. John, British Columbia, Canada has experienced a drastic increase in seismicity in the last ~ 6 years, from no earthquakes reported by Natural Resources Canada (NRCan) prior to 2013 to a total of ~ 200 cataloged events in 2013 – 2019. The increase follows the extensive horizontal drilling and multistage hydraulic fracturing activity that started to extract shale gas from the unconventional siltstone resource of the Montney Formation. In addition to hydraulic fracturing, ongoing wastewater disposal in the permeable sandstones and carbonates located stratigraphically above and below the Montney formation may also be contributing to elevated seismicity in the region. Earthquakes occur in close spatial and temporal proximity to hydraulic fracturing wells, at distances up to ~ 10 km. The expected diffusion time scales in the low-diffusivity siltstone rock units and the temporal and spatial scale of seismic activity beg questions about the possible processes controlling the location and timing of earthquakes.</p><p> </p><p>Here, we investigate the causative mechanisms for two of the largest events in the Montney Basin, British Columbia: the August 2015 M4.6 earthquake near Fort St. John, and the November 2018 M4.5 earthquake near Dawson Creek. Both events are thought to have occurred within the crystalline basement, ~2 km below the injected shale units (Montney formation).  We use a finite-element 3D poroelastic model to calculate the coupled evolution of elastic stress and pore pressure due to injection at several hydraulic fracturing stages. Initially, we consider a simple layered model with differing hydraulic parameters based on lithology. Subsequently, also considering the seismicity distribution for each sequence, we introduce hypothetic hydraulic conduits connecting the injection intervals with the crystalline basement, where the respective mainshock occurred. We test a range of permeability values (10<sup>-15</sup> m<sup>2</sup>– 10<sup>-12</sup> m<sup>2</sup>) commonly implemented for fault zones.</p><p> </p><p>Our results show that, for both cases, the poroelastic stress perturbation may be not sufficient to trigger events in the basement. Instead, a scenario with a high-permeability (10<sup>-13</sup> m<sup>2</sup>– 10<sup>-12</sup> m<sup>2</sup>) conduits connecting the Montney formation to the fault responsible for the mainshock could better explain the relationship between the hydraulic stimulation and the timing of the two M > 4 earthquakes. For the 2018 M4.5 event, aftershock distribution can be mainly attributed to earthquake-earthquake interaction via static Coulomb stress transfer from the mainshock slip. In addition to the modeling of single well/event sequences, future work will include the long-term poroelastic effect due to multiple disposal wells located in the region.</p>


2020 ◽  
Vol 110 (5) ◽  
pp. 2441-2453 ◽  
Author(s):  
Ganyu Teng ◽  
Jack W. Baker

ABSTRACT This project introduces short-term hazard assessment frameworks for regions with induced seismicity. The short-term hazard is the hazard induced during the injection for hydraulic-fracturing-induced earthquakes. For wastewater-disposal-induced earthquakes, it is the hazard within a few days after an observed earthquake. In West Texas, hydraulic-fracturing-induced earthquakes cluster around the injection activities, and the earthquake occurrence varies greatly in time and space. We develop a method to estimate the hazard level at the production site during the injection, based on past injection and earthquake records. The results suggest that the injection volume has a negligible effect on short-term earthquake occurrence in this case, because injection volumes per well fall within a relatively narrow range, whereas the regional variations in seismic productivity of wells and b-values are important. The framework could be easily modified for implementation in other regions with hydraulic-fracturing-induced earthquakes. We then compare the framework with wastewater-disposal-induced earthquakes in Oklahoma–Kansas and natural earthquakes in California. We found that drivers of short-term seismic hazard differ for the three cases. In West Texas, clustered earthquakes dominate seismic hazards near production sites. However, for Oklahoma–Kansas and California, the short-term earthquake occurrence after an observed mainshock could be well described by the mainshock–aftershock sequence. For Stillwater in Oklahoma, aftershocks contribute less to the hazard than San Francisco in California, due to the high Poissonian mainshock rate. For the rate of exceeding a modified Mercalli intensity of 3 within 7 days after an M 4 earthquake, the aftershock sequence from natural earthquakes contributed 85% of the hazard level, whereas the aftershock contribution was only 60% for induced earthquakes in Oklahoma. Although different models were implemented for hazard calculations in regions with hydraulic fracturing versus wastewater injection, injection activities could be drivers of short-term hazard in both cases.


1977 ◽  
Author(s):  
Alfred Jennings ◽  
Wallace Darden ◽  
Ray Wenzel ◽  
Robert Shrut ◽  
John Foster

2017 ◽  
Vol 89 (1) ◽  
pp. 118-126 ◽  
Author(s):  
Edward M. Brooks ◽  
Seth Stein ◽  
Bruce D. Spencer ◽  
Leah Salditch ◽  
Mark D. Petersen ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document