Modeling the Dissolved Oxygen Desorption when Superheated Water Enters the Rarefaction Zone

2021 ◽  
Vol 68 (7) ◽  
pp. 570-576
Author(s):  
G. V. Ledukhovsky ◽  
V. P. Zhukov ◽  
Yu. E. Barochkin ◽  
E. V. Barochkin
Vestnik IGEU ◽  
2016 ◽  
pp. 5-10 ◽  
Author(s):  
Yu.E. Barochkin ◽  
◽  
V.P. Zhukov ◽  
G.V. Ledukhovsky ◽  
E.V. Barochkin ◽  
...  

1992 ◽  
Vol 114 (4) ◽  
pp. 246-253
Author(s):  
Ahmad A. Pesaran

This paper presents the results of scoping deaeration experiments conducted with warm surface seawater under open-cycle ocean thermal energy conversion (OC-OTEC) conditions. Concentrations of dissolved oxygen in seawater at three locations (in the supply water, water leaving the predeaerator, and discharge water from an evaporator) were measured and used to estimate oxygen desorption levels. The results suggest that 7 percent to 60 percent of the dissolved oxygen in the supply water was desorbed from seawater in the predeaerator for pressures ranging from 35 to 9 kPa. Bubble injection in the upcomer increased the oxygen desorption rate by 20 percent to 60 percent. The data also indicated that at typical OC-OTEC evaporator pressures, when flash evaporation in the evaporator occurred, 75 percent to 95 percent of the dissolved oxygen was desorbed overall from the warm seawater. The results were used to find the impact of a single-stage predeaeration scheme on the power to remove noncondensable gases in an OC-OTEC plant.


Author(s):  
S. R. Singh ◽  
H. J. Fan ◽  
L. D. Marks

Since the original observation that the surfaces of materials undergo radiation damage in the electron microscope similar to that observed by more conventional surface science techniques there has been substantial interest in understanding these phenomena in more detail; for a review see. For instance, surface damage in a microscope mimics damage in the space environment due to the solar wind and electron beam lithographic operations.However, purely qualitative experiments that have been done in the past are inadequate. In addition, many experiments performed in conventional microscopes may be inaccurate. What is needed is careful quantitative analysis including comparisons of the behavior in UHV versus that in a conventional microscope. In this paper we will present results of quantitative analysis which clearly demonstrate that the phenomena of importance are diffusion controlled; more detailed presentations of the data have been published elsewhere.As an illustration of the results, Figure 1 shows a plot of the shrinkage of a single, roughly spherical particle of WO3 versus time (dose) driven by oxygen desorption from the surface.


Sign in / Sign up

Export Citation Format

Share Document