Mathematical characterization of pile-soil interface boundary for consolidation analysis of soil around permeable pipe pile

2020 ◽  
Author(s):  
Zheng Chen ◽  
Tao Xiao ◽  
Jianxue Feng ◽  
Pengpeng Ni ◽  
Deqiang Chen ◽  
...  
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Radius Ratio ◽  
Excess Pore Water Pressure ◽  
Pipe Pile ◽  
Drainage Hole ◽  
Opening Ratio ◽  
Soil Interface ◽  
Excess Pore

Permeable pipe pile is proposed to accelerate the dissipation of excess pore water pressure through drainage holes around the pile circumference into the pile’s cavity. This investigation generalizes the permeable pile-soil interface as an impeded boundary, based on which a mathematical model for soil consolidation around permeable pile is derived. Subsequently, the influence of opening pattern, drainage hole-to-pipe pile radius ratio, and opening ratio on the consolidation efficiency is numerically investigated. A total of 240 numerical cases with different drainage hole-to-pipe pile radius ratio, opening ratio, and hydraulic conductivity ratio are calculated to determine the permeable pile-soil interface parameter using back-analysis, and an approximate expression for interface parameter is obtained. Comparing against experimentally measured excess pore water pressure dissipation, the proposed technique with impeded drainage boundary can provide good evaluations for drainage characteristics at the permeable pile-soil interface and consolidation behavior of the surrounding soil. It is found that the spatial distribution pattern of drainage holes has negligible influence on the consolidation efficiency. Increasing the opening ratio (with constant opening size) or reducing the drainage hole-to-pipe pile radius ratio (with constant opening ratio) can both accelerate the consolidation efficiency.

scholarly journals Field Test of Excess Pore Water Pressure at Pile–Soil Interface Caused by PHC Pipe Pile Penetration Based on Silicon Piezoresistive Sensor

Sensors ◽  
2020 ◽  
Vol 20 (10) ◽  
pp. 2829
Author(s):  
Yonghong Wang ◽  
Xueying Liu ◽  
Mingyi Zhang ◽  
Suchun Yang ◽  
Songkui Sang
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Field Tests ◽  
Burial Depth ◽  
Excess Pore Water Pressure ◽  
Pipe Pile ◽  
Test Pile ◽  
Soil Interface ◽  
Excess Pore

Prestressed high-strength concrete (PHC) pipe pile with the static press-in method has been widely used in recent years. The generation and dissipation of excess pore water pressure at the pile–soil interface during pile jacking have an important influence on the pile’s mechanical characteristics and bearing capacity. In addition, this can cause uncontrolled concrete damage. Monitoring the change in excess pore water pressure at the pile–soil interface during pile jacking is a plan that many researchers hope to implement. In this paper, field tests of two full-footjacked piles were carried out in a viscous soil foundation, the laws of generation and dissipation of excess pore water pressure at the pile–soil interface during pile jacking were monitored in real time, and the laws of variation in excess pore water pressure at the pile–soil interface with the burial depth and time were analyzed. As can be seen from the test results, the excess pore water pressure at the pile–soil interface increased to the peak and then began to decline, but the excess pore water pressure after the decline was still relatively large. Test pile S1 decreased from 201.4 to 86.3 kPa, while test pile S2 decreased from 374.1 to 114.3 kPa after pile jacking. The excess pore water pressure at the pile–soil interface rose first at the initial stage of consolidation and dissipated only after the hydraulic gradient between the pile–soil interface and the soil surrounding the pile disappeared. The dissipation degree of excess pore water pressure reached about 75–85%. The excess pore water pressure at the pile–soil interface increased with the increase in buried depth and finally tended to stabilize.

Numerical Analysis on the Excess Pore Water Pressure of Pipe-Pile with Hole during the Static-Sinking Pile

2015 ◽  
Vol 744-746 ◽  
pp. 540-546
Author(s):  
Ke Lin Chen ◽  
Jin Bo Lei ◽  
Zhi Liu
Keyword(s):  
Numerical Analysis ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Effective Radius ◽  
Excess Pore Water Pressure ◽  
Pipe Pile ◽  
Time Space ◽  
Theory Research ◽  
Excess Pore

The time-space change rules of the environmental effects of the analysis of excess pore water pressure dissipation have also been studied during the static sinking-pile of the pipe-pile with hole. The results show: The excess pore water pressure will be dissipated with the time extending during the static sinking-pile of the 3 kinds of pipe-pole with hole. On the condition of the same effective radius, the depth of the observation dot is bigger, the excess pore water pressure will be bigger. On the contrast to the pipe-pole without hole, to some extent, the pipe-pole with hole can reduce the maximum of excess pore water pressure, and expedite the excess pore water pressure dissipation. This results can be provided the credible base for the theory research on the pipe-pole with hole and its application.

Stress–strain pattern–based criterion to assess cyclic shear resistance of soil from laboratory element tests

2016 ◽  
Vol 53 (9) ◽  
pp. 1460-1473 ◽  
Author(s):  
Dharma Wijewickreme ◽  
Achala Soysa
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Shear Stiffness ◽  
Large Strains ◽  
Fundamental Parameter ◽  
Stress Strain ◽  
Cyclic Shear ◽  
Excess Pore Water Pressure ◽  
Excess Pore

The cyclic shear response of soils is commonly examined using undrained (or constant-volume) laboratory element tests conducted using triaxial and direct simple shear (DSS) devices. The cyclic resistance ratio (CRR) from these tests is expressed in terms of the number of cycles of loading to reach unacceptable performance that is defined in terms of the attainment of a certain excess pore-water pressure and (or) strain level. While strain accumulation is generally commensurate with excess pore-water pressure, the definition of unacceptable performance in laboratory tests based purely on cyclic strain criteria is not robust. The shear stiffness is a more fundamental parameter in describing engineering performance than the excess pore-water pressure alone or shear strain alone; so far, no criterion has considered shear stiffness to determine CRR. Data from cyclic DSS tests indicate consistent differences inherent in the patterns between the stress–strain loops at initial and later stages of cyclic loading; instead of relatively “smooth” stress–strain loops in the initial parts of loading, nonsmooth changes in incremental stiffness showing “kinks” are notable in the stress–strain loops at large strains. The point of pattern change in a stress–strain loop provides a meaningful basis to determine the CRR (based on unacceptable performance) in cyclic shear tests.

Consolidation Theory for Composite Ground with Granular Columns Based on Different Calculation Models

2011 ◽  
Vol 261-263 ◽  
pp. 1534-1538
Author(s):  
Yu Guo Zhang ◽  
Ya Dong Bian ◽  
Kang He Xie
Keyword(s):  
Pore Water ◽  
Analytical Solutions ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Vertical Flow ◽  
Excess Pore Water Pressure ◽  
Consolidation Theory ◽  
Composite Ground ◽  
Granular Column ◽  
Excess Pore

The consolidation of the composite ground under non-uniformly distributed initial excess pore water pressure along depth was studied in two models which respectively considering both the radial and vertical flows in granular column and the vertical flow only in granular column, and the corresponding analytical solutions of the two models were presented and compared with each other. It shows that the distribution of initial excess pore water pressure has obvious influence on the consolidation of the composite ground with single drainage boundary, and the rate of consolidation considering the radial-vertical flow in granular column is faster than that considering the vertical flow only in granular column.

The Test Study to the Changes of Excess Pore Water Pressure during Precast Pile Construction

2012 ◽  
Vol 193-194 ◽  
pp. 1010-1013
Author(s):  
Shu Qing Zhao
Keyword(s):  
Pore Water ◽  
Clayey Soil ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Excess Pore Pressure ◽  
Soil Pressure ◽  
Excess Pore Water Pressure ◽  
Test Study ◽  
Excess Pore

The construct to precast pile in thick clayey soil can cause the accumulation of excess pore water pressure. The high excess pore pressure can make soil, buildings and pipes surrounded have large deflection, even make them injured. Combining with actual projects, this paper presents an in-situ model test on the changes of excess pore water pressure caused by precast pile construct. It is found that the radius of influence range for single pile driven is about 15m，the excess pore water pressure can reach or even exceed the above effective soil pressure, and there are two relatively stable stages.

A Practical Saturated Sand Elastic-Plastic Dynamic Constitutive Model and Application

2012 ◽  
Vol 446-449 ◽  
pp. 1621-1626 ◽  
Author(s):  
Yan Mei Zhang ◽  
Dong Hua Ruan
Keyword(s):  
Constitutive Model ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Stone Columns ◽  
Saturated Sand ◽  
Multidimensional Model ◽  
Excess Pore Water Pressure ◽  
Elastic Plastic ◽  
Excess Pore

A practical saturated sand elastic-plastic dynamic constitutive model was developed on the base of Handin-Drnevich class nonlinear lag model and multidimensional model. In this model, during the calculation of loading before soil reaches yielding, unloading and inverse loading, corrected Handin-Drnevich equivalent nonlinear model was adopted; after soil yielding, based on the idea of multidimensional model, the composite hardening law which combines isotropy hardening and follow-up hardening, corrected Mohr-Coulomb yielding criterion and correlation flow principle were adopted. A fully coupled three dimension effective stress dynamic analysis procedure was developed on the base of this model. The seismic response of liquefaction foundation reinforced by stone columns was analyzed by the developed procedure. The research shows that with the diameter of stone columns increasing, the excess pore water pressure in soil between piles decreases; with the spacing of columns increasing, the excess pore water pressure increases. The influence of both is major in middle and lower level of composite foundation.

Sign in / Sign up

Export Citation Format

Share Document