FIELD OBSERVATIONS AND NUMERICAL SIMULATIONS FOR THE RESPONSE PROPERTIES OF PORE WATER PRESSURES IN THE SEABED BENEATH A COMPOSITE BREAKWATER

Author(s):  
Tomotsuka Takayama ◽  
Tomohiro Yasuda ◽  
Daiki Tsujio ◽  
Shotaro Taniguchi
1992 ◽  
Vol 29 (1) ◽  
pp. 67-79 ◽  
Author(s):  
C.B. Crawford ◽  
R. J. Fannin ◽  
L. J. Deboer ◽  
C. B. Kern

This case record describes the performance of two test embankments constructed over a soft compressible clay, one with prefabricated vertical drains and one without. The measured settlements were significantly different from the predicted settlements, and the pore-water pressures were inconsistent with the observed consolidation. The observed performance of the vertical drains is compared with theoretical predictions to assess the sensitivity of the predicted rate of consolidation to input parameters. Key words : case record, consolidation, field observations, prefabricated vertical drains, wick drains, preloading, settlements, test embankments.


1994 ◽  
Vol 31 (5) ◽  
pp. 773-778 ◽  
Author(s):  
Jianhua Yin ◽  
James Graham ◽  
Jack I. Clark ◽  
Longjun Gao

Field observations in thin soft clay layers may show pore-water pressures that increase for some time after the loading is applied. Reasons for these observations are not well understood. The paper shows how an elastic viscoplastic constitutive model incorporated into the consolidation equation can predict these pore-water pressure increases in soils that exhibit significant creep behaviour (or secondary compression). The phenomenon has been related to relaxation in regions of the profile from which drainage has not yet begun. Key words : clay, consolidation, creep, secondary compression, viscous, relaxation, pore-water pressure, elastic–plastic.


2019 ◽  
Vol 2019 ◽  
pp. 1-19 ◽  
Author(s):  
El Mustapha Jaouhar ◽  
Li Li

The pore water pressures (PWPs) and total stresses during the placement of a slurried backfill in underground mine stopes are the key parameters for the design of barricades, built to retain the backfill in the stopes. They can be affected by the drainage and consolidation of the backfill. Over the years, several studies have been reported on the pressure and stresses in backfilled stopes by accounting for the drainage and consolidation. Most of them focused on the pressure and stresses in the stopes, few specifically on the barricades. The effect of the number of draining holes commonly installed through the barricade has never been studied. In this paper, the influence of hydraulic properties and filling rate of the backfill, stope size, barricade location, and number of draining holes is systematically investigated with numerical simulations. The results show that the stresses in the backfilled stope and on the barricade largely depend on the filling rate, hydraulic conductivity, and Young’s modulus of the backfill. The draining holes can significantly decrease the PWP, but only slightly the total stresses on the barricades in short term.


1987 ◽  
Vol 24 (2) ◽  
pp. 308-317
Author(s):  
C. B. Crawford ◽  
L. J. DeBoer

This paper presents a 15-year record of consolidation settlements under an earth embankment where maximum settlements have exceeded 3 m since 1971. The rate of settlement was greatly accelerated by the use of sand drains under areas of maximum load. During construction, pore pressures in the subsoil were monitored and used to control the rate of loading, which had to be decreased to avoid failure. Settlements were underestimated and stability was overestimated on the basis of laboratory and field tests. Consolidation characteristics measured in the laboratory are compared with those calculated from field observations. Key words: settlements, consolidation, embankment, pore-water pressures, monitoring, in situ.


1980 ◽  
Vol 17 (4) ◽  
pp. 607-612 ◽  
Author(s):  
Luis E. Vallejo

A new approach to the stability analysis of thawing slopes at shallow depths, taking into consideration their structure (this being a mixture of hard crumbs of soil and a fluid matrix), is presented. The new approach explains shallow mass movements such as skin flows and tongues of bimodal flows, which usually take place on very low slope inclinations independently of excess pore water pressures or increased water content in the active layer, which are necessary conditions in the methods available to date to explain these movements.


2000 ◽  
Vol 37 (2) ◽  
pp. 449-462 ◽  
Author(s):  
Charles Harris ◽  
Antoni G Lewkowicz

Active-layer detachment slides are locally common on Fosheim Peninsula, Ellesmere Island, where permafrost is continuous, the active layer is 0.5-0.75 m thick, and summer temperatures are unusually high in comparison with much of the Canadian High Arctic. In this paper we report pore-water pressures at the base of the active layer, recorded in situ on two slopes in late July and early August 1995. These data form the basis for slope stability analyses based on effective stress conditions. During fieldwork, the factor of safety within an old detachment slide on a slope at Hot Weather Creek was slightly greater than unity. At "Big Slide Creek," on a slope showing no evidence of earlier detachment failures, the factor of safety was less than unity on a steep basal slope section but greater than unity elsewhere. In the upper slope, pore-water pressures were only just subcritical. Sensitivity analyses demonstrate that the stability of the shallow active layer is strongly influenced by changes in soil shear strength. Possible mechanisms for reduction in shear strength through time include weathering of soils and gradual increases in basal active layer ice content. However, we suggest here that soil shearing during annual gelifluction movements is most likely to progressively reduce shear strengths at the base of the active layer from peak values to close to residual, facilitating the triggering of active-layer detachment failures.Key words: detachment slides, Ellesmere Island, pore-water pressures, gelifluction.


1986 ◽  
Vol 32 (110) ◽  
pp. 20-30 ◽  
Author(s):  
E. M. Shoemaker

AbstractSubglacial hydrology is investigated for an ice sheet where the substrate consists of a deformable aquifer resting on an aquitard. If sliding velocities are low or absent, subglacial melt-water drainage is dominated by drainage through the aquifer to water channels. Drainage along the bed is negligible. Efficient melt-water drainage requires that a system of subglacial water channels exists; otherwise, pore-water pressures will exceed the overburden pressure. In general, aquifer deformation near (away from) the terminus is most likely to occur during the winter (summer). The effect of short-term high channel pressures is, in general, not critical to aquifer deformation because the pressure pulse does not propagate far into the aquifer. (For aquifers of high permeability, short periods of high channel pressures constitute the most critical condition.) Aquifer deformation at the terminus is very likely to occur if the terminus ice slope exceeds tan ϕ, where ϕ is the Coulomb friction angle of the aquifer material. Upwelling of basal melt water near the terminus will normally cause soil dilation if the aquifer has a low permeability (e.g. till). Maximal profiles are computed corresponding to various aquifer materials using channel spacings which provide efficient drainage. (A maximal profile is the highest ice profile which the aquifer can sustain without deformation.) In general, maximal profiles lie well above observed profiles (such as h(x) = 3x1/2 (m)) except near the terminus. However, if channel spacings are sufficiently large, pore-water pressures are increased and maximal profiles can lie well below h(x) = 3x1/2.


Sign in / Sign up

Export Citation Format

Share Document