NUMERICAL SIMULATIONS OF GROWTH KINETICS AND SPINODAL DECOMPOSITION IN FLUIDS

Author(s):  
Turab Lookman
2011 ◽  
Vol 172-174 ◽  
pp. 443-448
Author(s):  
Orlando Soriano Vargas ◽  
Erika O. Avila Davila ◽  
Victor M. Lopez-Hirata ◽  
Maribel L. Saucedo-Muñoz

The hardening behavior of precipitation was studied during aging of Fe-Cr alloys. This mechanical behavior is associated with the nanometric modulation structure of the coherent decomposed Fe-rich and Cr-rich phases formed by the spinodal decomposition of the supersaturated solid solution. The growth kinetics of spinodal decomposition was very slow and it increased during coarsening stage. The morphology of decomposed phases consisted of an interconnected irregular shape with no preferential alignment for short aging times and a further aging caused the change to a plate shape of the decomposed Cr-rich phase aligned in the <110> directions of the Fe-rich matrix. The rapid increase in hardness and embrittlement seem to be associated with the coherency and nanometer size of the spinodally-decomposed phases in the aged alloys.


1989 ◽  
Vol 40 (1) ◽  
pp. 379-383 ◽  
Author(s):  
Gene F. Mazenko ◽  
Oriol T. Valls ◽  
Marco Zannetti

1993 ◽  
Vol 48 (1) ◽  
pp. 634-637 ◽  
Author(s):  
F. J. Alexander ◽  
S. Chen ◽  
D. W. Grunau

Author(s):  
Shiro Fujishiro ◽  
Harold L. Gegel

Ordered-alpha titanium alloys having a DO19 type structure have good potential for high temperature (600°C) applications, due to the thermal stability of the ordered phase and the inherent resistance to recrystallization of these alloys. Five different Ti-Al-Ga alloys consisting of equal atomic percents of aluminum and gallium solute additions up to the stoichiometric composition, Ti3(Al, Ga), were used to study the growth kinetics of the ordered phase and the nature of its interface.The alloys were homogenized in the beta region in a vacuum of about 5×10-7 torr, furnace cooled; reheated in air to 50°C below the alpha transus for hot working. The alloys were subsequently acid cleaned, annealed in vacuo, and cold rolled to about. 050 inch prior to additional homogenization


2020 ◽  
Author(s):  
Dork Sahagian ◽  
Tamara Carley ◽  
Anja Allabar ◽  
James Gardner ◽  
Ed Lewellin ◽  
...  

2020 ◽  
Vol 640 ◽  
pp. A53
Author(s):  
L. Löhnert ◽  
S. Krätschmer ◽  
A. G. Peeters

Here, we address the turbulent dynamics of the gravitational instability in accretion disks, retaining both radiative cooling and irradiation. Due to radiative cooling, the disk is unstable for all values of the Toomre parameter, and an accurate estimate of the maximum growth rate is derived analytically. A detailed study of the turbulent spectra shows a rapid decay with an azimuthal wave number stronger than ky−3, whereas the spectrum is more broad in the radial direction and shows a scaling in the range kx−3 to kx−2. The radial component of the radial velocity profile consists of a superposition of shocks of different heights, and is similar to that found in Burgers’ turbulence. Assuming saturation occurs through nonlinear wave steepening leading to shock formation, we developed a mixing-length model in which the typical length scale is related to the average radial distance between shocks. Furthermore, since the numerical simulations show that linear drive is necessary in order to sustain turbulence, we used the growth rate of the most unstable mode to estimate the typical timescale. The mixing-length model that was obtained agrees well with numerical simulations. The model gives an analytic expression for the turbulent viscosity as a function of the Toomre parameter and cooling time. It predicts that relevant values of α = 10−3 can be obtained in disks that have a Toomre parameter as high as Q ≈ 10.


Sign in / Sign up

Export Citation Format

Share Document