Segmenting Ultrasound Images of the Prostate Using Neural Networks

1992 ◽  
Vol 14 (2) ◽  
pp. 159-185 ◽  
Author(s):  
James S. Prater ◽  
William D. Richard

This paper describes a method for segmenting transrectal ultrasound images of the prostate using feedforward neural networks. Segmenting two-dimensional images of the prostate into prostate and nonprostate regions is required when forming a three-dimensional image of the prostate from a set of parallel two-dimensional images. Three neural network architectures are presented as examples and discussed. Each of these networks was trained using a small portion of a training image segmented by an expert sonographer. The results of applying the trained networks to the entire training image and to adjacent images in the two-dimensional image set are presented and discussed. The final network architecture was also trained with additional data from two other images in the set. The results of applying this retrained network to each of the images in the set are presented and discussed.

Micromachines ◽  
2021 ◽  
Vol 12 (8) ◽  
pp. 929
Author(s):  
Xudong Yang ◽  
Zexiao Li ◽  
Linlin Zhu ◽  
Yuchu Dong ◽  
Lei Liu ◽  
...  

Taper-cutting experiments are important means of exploring the nano-cutting mechanisms of hard and brittle materials. Under current cutting conditions, the brittle-ductile transition depth (BDTD) of a material can be obtained through a taper-cutting experiment. However, taper-cutting experiments mostly rely on ultra-precision machining tools, which have a low efficiency and high cost, and it is thus difficult to realize in situ measurements. For taper-cut surfaces, three-dimensional microscopy and two-dimensional image calculation methods are generally used to obtain the BDTDs of materials, which have a great degree of subjectivity, leading to low accuracy. In this paper, an integrated system-processing platform is designed and established in order to realize the processing, measurement, and evaluation of taper-cutting experiments on hard and brittle materials. A spectral confocal sensor is introduced to assist in the assembly and adjustment of the workpiece. This system can directly perform taper-cutting experiments rather than using ultra-precision machining tools, and a small white light interference sensor is integrated for in situ measurement of the three-dimensional topography of the cutting surface. A method for the calculation of BDTD is proposed in order to accurately obtain the BDTDs of materials based on three-dimensional data that are supplemented by two-dimensional images. The results show that the cutting effects of the integrated platform on taper cutting have a strong agreement with the effects of ultra-precision machining tools, thus proving the stability and reliability of the integrated platform. The two-dimensional image measurement results show that the proposed measurement method is accurate and feasible. Finally, microstructure arrays were fabricated on the integrated platform as a typical case of a high-precision application.


1990 ◽  
Vol 26 (Supplement) ◽  
pp. 248-249
Author(s):  
Am CHO ◽  
Kageyu NORO ◽  
Shinya KOSHIE ◽  
Atsuko HONDO ◽  
Sakae YAMAMOTO

Sign in / Sign up

Export Citation Format

Share Document