Monitoring localised corrosion in inhibited solutions using wire beam electrode–noise signatures method

2006 ◽  
Vol 41 (3) ◽  
pp. 263-272 ◽  
Author(s):  
N. N. Aung ◽  
Y.-J. Tan
Author(s):  
Cheng-qun Pan ◽  
Qing-dong Zhong ◽  
Jian Yang ◽  
Y. Frank Cheng ◽  
Chuan Chen

Circulation ◽  
2015 ◽  
Vol 132 (suppl_3) ◽  
Author(s):  
Junaid A Zaman ◽  
Gautam G Lalani ◽  
Tina Baykaner ◽  
Shirley Park ◽  
David E Krummen ◽  
...  

Introduction: The mechanisms maintaining human persistent AF are elusive. It is striking how most optical mapping studies in animal and recently human AF show rotors and focal sources, while most classical activation mapping studies of electrograms do not. We tested the hypothesis that sites in human persistent AF showing rotors by phase analysis may, due to precession (‘wobble’) and fibrillatory collision, rarely reveal sources in activation maps. Methods: We studied 25 patients with persistent AF (LA 47 mm, CHADS2=1.9), in whom phase-mapping of electrograms from 64 pole baskets revealed rotors/focal sources where ablation terminated AF. Electrograms (fig A) were annotated (Matlab) using minimum dV/dt (unipoles, fig B) and peak amplitude criteria (bipoles) to create contours (isochrones), that were classified into a) complete, b) partial or c) unresolvable sources. Results: In each case, ablation at phase-identified rotors/sources (4.0±5.7 mins) terminated persistent AF to sinus rhythm (fig C, 64%) or atrial tachycardia. Notably, isochrones detected sources in only 5/25 (20%) of cases (fig D), more easily in unipolar than bipolar signals. Isochrones revealed partial sources in 11 (44%) and were unresolvable in 9 (36%). Source detection in classical maps was obscured by low signal: noise, varying sequence (rotor precession), or electrode noise that phase analysis resolved by analyzing neighboring sites (fig E). The figure summarizes these steps for a case with perfect agreement between activation and phase maps. Conclusions: Rotors and focal sources for human persistent AF detected by phase analysis were mostly undetected in activation maps, due to rotor precession and fibrillatory conduction. These data may inform approaches to revise classical criteria to better map AF.


2021 ◽  
pp. 2150014
Author(s):  
QINGDONG ZHONG

To study the corrosion behavior of carbon steel in seawater at different temperatures, a novel electrochemical method called gradient-distributed wire beam electrode technique with high temporal and spatial resolution has been employed. This new wire beam electrode was prepared by three kinds of carbon steel with different carbon contents so that it can evaluate three materials simultaneously in the same corrosion medium (3.5[Formula: see text]wt.% NaCl solution) and improve the accuracy of tests results. After the gradient-distributed wire beam electrode soaked in 3.5[Formula: see text]wt.% NaCl solution for 8[Formula: see text]h, compared with measured at room temperature, the corrosion rate was accelerated greatly and polarity reversal of potential-current was also observed.


2006 ◽  
Vol 48 (1) ◽  
pp. 67-78 ◽  
Author(s):  
Tie Liu ◽  
Yong-Jun Tan ◽  
Bernice Zee Mei Lin ◽  
Naing Naing Aung

2011 ◽  
Vol 480-481 ◽  
pp. 443-447
Author(s):  
Yan Hua Wang ◽  
Yuan Yuan Liu

The distributions of corrosion potential and galvanic current of 304 stainless steel under a NaCl droplet were studied by using the wire beam electrode (WBE). It was found that the distributions of the electrochemical parameters were heterogeneous with isolated anodic and cathodic zones appeared randomly. During the corrosion process, the polarity of some anodes changed with the evolution of time. The localized corrosion rate and heterogeneity increased firstly, and then decreased afterward with the increase of time, which can be attributed to the cooperative effects of the aggressive ions and the corrosion products.


2011 ◽  
Vol 239-242 ◽  
pp. 1195-1198 ◽  
Author(s):  
Liu Bin Song ◽  
Dao Wu Yang ◽  
Zhong Liang Xiao ◽  
Feng Zhang

The corrosion behavior of reinforcing bars in concrete was studied by simulating the 4×4 wire-beam electrode array. Different inhibitors were added to reinforced concrete. By measuring the open-circuit potential of an iron wire, the impact of different inhibitors on the corrosion of rebar in the concretes was studied after immersion in NaCl solution. The result showed that best protection was achieved by adding NaNO2 and aniline as inhibitors jointly to the concrete, as this combination maintained the open-circuit potential within the passivation range at all times, so ensuring the integrity of the passive membrane. By addition of this combination of the inhibitors, the compactibility of the cement concrete structure can be increased, thereby protecting the reinforcing bar against the external corrosive media.


Sign in / Sign up

Export Citation Format

Share Document