Index, engineering properties and classification of tropical residual soils

Author(s):  
Suhaimi Jamaludin ◽  
Bujang Huat ◽  
Shukri Maail
2019 ◽  
Vol 1 (5) ◽  
Author(s):  
Olabode Olabanji Olofinyo ◽  
Oluwaseun Franklin Olabode ◽  
Imoleayo Oluwatoyin Fatoyinbo

2002 ◽  
Vol 8 (2) ◽  
pp. 121-135 ◽  
Author(s):  
Adnan Aydin ◽  
Nurdan S. Duzgoren-Aydin

Abstract This paper presents a critical review of microfabric, physical and chemical indices for scaling and predicting weathering-induced changes in rock properties. The common goal of these indices is mainly to condense complexities to numbers that can be plotted against each other and against engineering properties or weathering grades to determine if trends exist. However, a purely statistical evaluation to establish smooth trends in such highly variable properties is deceptive. No single index is valid or remains unaffected over the whole spectrum of weathered states. Combination of indices aimed at determining grade boundaries may also be misleading unless accompanied by detailed descriptions of microfabric and mineralogical observations. The presented index classifications highlight the nature and scope of indices and provide guidance for compatible and complementary combinations. The meaning and adequacy of criteria used in classifications of residual soils and weathered rocks are reexamined from the point of view of the fundamental differences inherent in their microfabric.


Landslides ◽  
2022 ◽  
Author(s):  
A. S. M. Maksud Kamal ◽  
Farhad Hossain ◽  
Md. Zillur Rahman ◽  
Bayes Ahmed ◽  
Peter Sammonds

AbstractThe Forcibly Displaced Myanmar Nationals (FDMN), historically known as ‘Rohingya’ who fled the 2017 ethnic atrocities and genocide in the Northern Rakhine State of Myanmar, took shelter in Cox’s Bazar District of Bangladesh. The camp network, known as Kutupalong Rohingya Camp (KRC), is situated in the tectonically active tertiary hilly terrain. The KRC has been experiencing hydrometeorological hazards, where landslides are frequent. This study investigated the slopes’ geological condition, engineering properties and human interventions, which influence the landslides. The exposed slopes were relatively high (> 10 m) and steep ranging from 40° to 60° that have numerous polygonal tension cracks and fissures. From the geological and geotechnical aspects, there are three successive units of slope materials: (1) residual soils of sandy silt with clay, (2) highly weathered silty sandstones and (3) shale/clay with silt and fine sand intercalations at the bottom of the slopes. Field observations revealed that most slope failures occurred in the residual soil and weathered silty sandstone units. The residual soils have a bulk density of 1.49–1.97 g/cm3, a liquid limit of 25–48%, a plasticity index of 5–16% and an undrained shear strength of 23–46 kPa. The silty sandstones have a bulk density of 1.44–1.94 g/cm3, an internal friction angle of 34°–40° and a cohesion of 0.5–13 kPa. The mineralogical composition determined by the X-ray diffraction shows low clay mineral content, which does not affect landslides. However, the slope geometry, low shear strength with strain softening properties and torrential rainfall accompanied by anthropogenic factors cause numerous landslides every year. This study will help take proper mitigation and preparedness measures for slope protection in the KRC area and surroundings.


Sign in / Sign up

Export Citation Format

Share Document