Experimental Study on Shearing Properties of Concrete Sheet Reinforced by Steel Mesh and Fiber Fabric Mesh

2019 ◽  
Vol 08 (03) ◽  
pp. 830-835
Author(s):  
凌青 邓
2016 ◽  
Vol 121 ◽  
pp. 60-68 ◽  
Author(s):  
Han Li ◽  
Shengze Tian ◽  
Xinzhi Dang ◽  
Wancheng Yuan ◽  
Kai Wei

2012 ◽  
Vol 193-194 ◽  
pp. 847-851
Author(s):  
Yong Heng Yang ◽  
Den Rong Li ◽  
Yong Hui Liu ◽  
Ling Yun Li

In this paper, conducted a systematic study of thermal performance of steel mesh frame sandwich insulation board. The thermal performance of steel mesh frame sandwich insulation board was determined under different conditions. Proposed the insulation effect on oblique inserting wire in the steel mesh frame sandwich insulation board and provided the basis for engineering design and application.


2020 ◽  
Vol 90 ◽  
pp. 89-97 ◽  
Author(s):  
Chenming Zhou ◽  
Bruce G. Whisner ◽  
Jacob L. Carr ◽  
Justin Srednicki

2016 ◽  
Vol 158 ◽  
pp. 422-427 ◽  
Author(s):  
Nicola Mazzon ◽  
Francesco Ferraiolo ◽  
Marco Vicari

2010 ◽  
Vol 177 ◽  
pp. 562-565
Author(s):  
Jian Yang ◽  
Qiang Du ◽  
Yi Wang Bao

Bond behavior plays an important role in developing load carrying capacity and ductility for concrete structures. Studies on bond behavior of single bars have been extensively conducted and whereas those on steel meshes are rather limited. This paper reports an experimental study on the bond behavior of concrete blocks with steel meshes. By varying the rib pattern and bar size of the steel mesh, their influence was examined.


Author(s):  
Norio Baba ◽  
Norihiko Ichise ◽  
Syunya Watanabe

The tilted beam illumination method is used to improve the resolution comparing with the axial illumination mode. Using this advantage, a restoration method of several tilted beam images covering the full azimuthal range was proposed by Saxton, and experimentally examined. To make this technique more reliable it seems that some practical problems still remain. In this report the restoration was attempted and the problems were considered. In our study, four problems were pointed out for the experiment of the restoration. (1) Accurate beam tilt adjustment to fit the incident beam to the coma-free axis for the symmetrical beam tilting over the full azimuthal range. (2) Accurate measurements of the optical parameters which are necessary to design the restoration filter. Even if the spherical aberration coefficient Cs is known with accuracy and the axial astigmatism is sufficiently compensated, at least the defocus value must be measured. (3) Accurate alignment of the tilt-azimuth series images.


Sign in / Sign up

Export Citation Format

Share Document