Fuel Cell for Portable Use : Hydrogen Supply Using Borohydride and Prototyping of Small Cells

2002 ◽  
Vol 2002.1 (0) ◽  
pp. 273-274
Author(s):  
Shuji TANAKA ◽  
Asa HIGASHITANI ◽  
Kei SUGIE ◽  
Masayoshi ESASHI
2021 ◽  
Vol 1 ◽  
pp. 477-486
Author(s):  
Vahid Douzloo Salehi

AbstractHydrogen is a promising fuel to fulfil climate goals and future legislation requirements due to its carbon-free property. Especially hydrogen fueled buses and heavy-duty vehicles (HDVs) strongly move into the foreground. In contrast to the hydrogen-based fuel cell technology, which is already in commercial use, vehicles with hydrogen internal combustion engines (H2-ICE) are also a currently pursued field of research, representing a potentially holistic carbon-free drive train. Real applications of H2-ICE vehicles are currently not known but can be expected, since their suitability is put to test in a few insolated projects at this time. This paper provides a literature survey to reflect the current state of H2-ICEs focused on city buses. An extended view to HDVs and fuel cell technology allows to recognize trends in hydrogen transport sector, to identify further research potential and to derive useful conclusion. In addition, within this paper we apply green MAGIC as a holistic approach and discuss Well-to-Tank green hydrogen supply in relation to a H2-ICE city bus. Building on that, we introduce the upcoming Hydrogen-bus project, where tests of H2-ICE buses in real driving mode are foreseen to investigate Tank-to-Wheel.


2005 ◽  
Vol 2005 (0) ◽  
pp. 275-276
Author(s):  
Izuru Fujisawa ◽  
Kuniyuki Hirano ◽  
Takashi Saika ◽  
Shigehiko Yamamoto

Author(s):  
Lubica Bednarova ◽  
Lukáš Tóth ◽  
Tomáš Brestovič ◽  
Natália Jasminská ◽  
Marián Lázár ◽  
...  

The present article deals with the material and energy balance of a fuel cell during hydrogen supply from a metal hydride tank. It describes potential utilisation of heat from a fuel cell for heating a tank in order to achieve the required kinetics of the process. The concluding part hereof contains a numerical calculation of the thermal field of the designed tank during the fuel cell operation.


Author(s):  
Yasushi Ichikawa ◽  
Nobuyuki Oshima

In a polymer electrolyte fuel cell (PEFC), the catalyst degradation on cathodic side is one of the fatal problems caused by mal-distributed hydrogen supply into each channel on active area in a fuel cell, especially in a fuel cell stack for automotive fuel cell systems which consist of several hundreds of fuel cells stacked. For example, before getting the fuel cell system started-up, the gas in all the anodic flow passage including channels in each fuel cell is occupied by air instead of hydrogen due to cross leak from cathodic side to anodic side through the membrane employed as an electrolyte. In this situation, if hydrogen is supplied partially or unevenly between cells to start up the system, a concentration interface of air and hydrogen will be made within a fuel cell. This causes a state of local cell within a single fuel cell and the catalyst degradation (carbon corrosion or Pt dissolution) occurs. In this paper, to avoid this catalyst degradation, the gas distribution is investigated with pressurized hydrogen supply into channels located on the hundreds stacked fuel cells statically filled with air initially. A transient computational fluid analysis was applied to the flow fields of anodic side which consist of channels on fuel cells, both distributing and collecting manifold connected to the fuel cells under parameters: 1) number of stacked fuel cells (i.e. manifold length), 2) the rate of pressure rising (Pa/sec.) which makes the gas flow velocity. A gas analysis experiment was also carried out for a validation with mass spectrometer taking gas sample from several points along the gas channels on alternative fuel cells which are made of transparent acrylic resin. The results show that the uniform distribution in concentration between cells and its profile within the channels along the flow direction are strongly affected by flow field formed within the distributing manifold located upstream of stacked plates with channels.


2017 ◽  
Vol 2 ◽  
pp. 11
Author(s):  
Yusuke Ono ◽  
Takahide Haneda ◽  
Takashi Ikegami ◽  
Atsushi Akisawa

Sign in / Sign up

Export Citation Format

Share Document