409 Temperature Dependence of Bolted Joints Force with Stainless Steel Bolts and Al-Alloy Base Plate

2000 ◽  
Vol 2000.35 (0) ◽  
pp. 134-135
Author(s):  
Yoshinori Saito ◽  
Osamu kamiya ◽  
Norihiko Saga
Keyword(s):  
Stainless Steel ◽  
Temperature Dependence ◽  
Base Plate ◽  
Bolted Joints ◽  
Al Alloy ◽  
Alloy Base ◽  
Steel Bolts

Temperature Dependence of Oxide Layer Formation on Hydrogen Isotope Retention in Type 316 Stainless Steel

2009 ◽  
Vol 56 (2) ◽  
pp. 799-803 ◽  
Author(s):  
Kenji Okuno ◽  
Sachiko Suzuki ◽  
Hirotada Ishikawa ◽  
Takumi Hayashi ◽  
Toshihiko Yamanishi ◽  
...  
Keyword(s):  
Stainless Steel ◽  
Temperature Dependence ◽  
Oxide Layer ◽  
Hydrogen Isotope ◽  
Layer Formation ◽  
316 Stainless Steel

Diffusion of Ce-Al Melts Measured by Sliding Cell Technique

2017 ◽  
Vol 898 ◽  
pp. 679-683
Author(s):  
Cheng Chen ◽  
Jin Liang Hu ◽  
Lang Xiang Zhong ◽  
Bo Zhang
Keyword(s):  
Activation Energy ◽  
Temperature Dependence ◽  
Strong Interaction ◽  
Al Alloy ◽  
Diffusion Behavior ◽  
Diffusion Constants

The diffusion behavior of Ce-Al alloy melt at three temperatures of 943K, 953K and 963K was investigated by sliding shear method. The inter-diffusion constants D show Arrhenius-type temperature dependence in the investigated regimes. Compared with the previous results achieved in Ce-Cu melt, liquid Ce-Al displays a much slower diffusion behavior and rather higher activation energy ED, which was caused by the strong interaction between Ce and Al.

Investigation on Impact Energy of S30403 Austenitic Stainless Steel at Different Temperatures

2016 ◽  
Vol 138 (3) ◽  
Author(s):  
Zhiwei Chen ◽  
Caifu Qian ◽  
Guoyi Yang ◽  
Xiang Li
Keyword(s):  
Stainless Steel ◽  
Austenitic Stainless Steel ◽  
Cross Section ◽  
Test Temperature ◽  
Impact Energy ◽  
Welded Joint ◽  
Charpy Impact ◽  
Base Plate ◽  
Charpy Impact Energy ◽  
The Impact

In this paper, a series of impact tests on S30403 austenitic stainless steel at 20/−196/−269 °C were performed to determine the effects of cryogenic temperatures on the material properties. Both base plate and welded joint including weld and heat-affected zone were tested to obtain the Charpy impact energy KV2 and lateral expansion rate at the cross section. It was found that when the test temperature decreased from 20 °C to −196 °C or −269 °C, both the Charpy impact energy KV2 at the base plate and welded joint decreased drastically. Specifically, the impact energy KV2 decreased by 20% at the base plate and decreased by 54% at the welded joint from 20 °C to −196 °C, but the impact energy of base plate and welded joint did not decrease, even increased when test temperature decreased from −196 °C to −269 °C. Either at 20 °C or −196 °C, the impact energy KV2 with 5 × 10 × 55 mm3 specimens was about 0.53 times that of the 7.5 × 10 × 55 mm3 specimens, much lower than 2/3, the ratio of two specimens’ cross section areas.

Temperature dependence of swelling in type 316 stainless steel irradiated in HFIR

1988 ◽  
Vol 155-157 ◽  
pp. 838-844 ◽  
Author(s):  
S. Hamada ◽  
P.J. Maziasz ◽  
M.P. Tanaka ◽  
M. Suzuki ◽  
A. Hishinuma
Keyword(s):  
Stainless Steel ◽  
Temperature Dependence ◽  
316 Stainless Steel

scholarly journals Temperature dependence of corrosion of ferritic stainless steel in dual atmosphere at 600–800 °C

2018 ◽  
Vol 392 ◽  
pp. 129-138 ◽  
Author(s):  
Patrik Alnegren ◽  
Mohammad Sattari ◽  
Jan-Erik Svensson ◽  
Jan Froitzheim
Keyword(s):  
Stainless Steel ◽  
Temperature Dependence ◽  
Ferritic Stainless Steel ◽  
Dual Atmosphere

scholarly journals Complementary Measurements of Residual Stresses Before and After Base Plate Removal in an Intricate Additively-Manufactured Stainless-Steel Valve Housing

2020 ◽  
Vol 36 ◽  
pp. 101555
Author(s):  
Bjørn Clausen ◽  
Christopher R. D’Elia ◽  
Michael B. Prime ◽  
Michael R. Hill ◽  
Joseph E. Bishop ◽  
...  
Keyword(s):  
Stainless Steel ◽  
Residual Stresses ◽  
Base Plate ◽  
Plate Removal ◽  
Before And After ◽  
Valve Housing

Effect of corrosive media on galvanic corrosion of complicated tri-metallic couples of 2024 Al alloy/Q235 mild steel/304 stainless steel

2019 ◽  
Vol 35 (9) ◽  
pp. 1886-1893 ◽  
Author(s):  
Linjun Shi ◽  
Xiuying Yang ◽  
Yingwei Song ◽  
Dan Liu ◽  
Kaihui Dong ◽  
...  
Keyword(s):  
Stainless Steel ◽  
Mild Steel ◽  
Galvanic Corrosion ◽  
304 Stainless Steel ◽  
Al Alloy ◽  
Corrosive Media
Sign in / Sign up

Export Citation Format

Share Document