scholarly journals Thermal hydrolysis of olive leaves and stems to obtain fermentable sugars

2021 ◽  
Vol 29 ◽  
pp. 325-334
Author(s):  
Fabiele Schaefer Rodrigues ◽  
Norton Marozo Silveira ◽  
Alexandre Gonçalves Kury ◽  
Jefferson Fagundes Silva ◽  
Estêvão Santos Laureano Cunha ◽  
...  

Subcritical water hydrolysis was used for the pre-treatment of residues generated in olive groves. Fermentable sugars were produced from the lignocellulosic material found in olive leaves and stems. Firstly, moisture, ash, particle average diameter, and total extracts were measured. Afterward, subcritical water hydrolysis was carried out at 20 MPa in a 50 mL reactor. The influences of two temperatures (180 and 220 °C) and two water flow rates (10 and 20 mL min-1) on the sugars yields were evaluated. The concentration of sugars was 31.3 g L-1 at 180 °C and 10 mL min-1 in a reaction for 3 min, of which glucose was the major sugar (27.64 g L-1). Statistical analysis was performed using Sisvar® 5.6 software and the averages were compared through Tukey’s test, considering a significance level of 95% (p<0.05). For the treatments evaluated in this work, only xylose was statistically different in the treatments with different water flow rates. The highest values of xylose were obtained with 10 mL min-1, which were 1.82 g L-1 (180 °C) and 2.18 g L-1 (220 °C). The total inhibitors were high at 220 °C for all water flow rates, with a significant difference from the averages obtained at 180 °C.

2019 ◽  
Vol 272 ◽  
pp. 510-520 ◽  
Author(s):  
Ederson R. Abaide ◽  
Gustavo Ugalde ◽  
Marco Di Luccio ◽  
Regina de F.P.M. Moreira ◽  
Marcus V. Tres ◽  
...  

Author(s):  
Crisleine P. Draszewski ◽  
Carolina A. Bragato ◽  
Daniel Lachos-Perez ◽  
Dian Celante ◽  
Clarissa P. Frizzo ◽  
...  

2021 ◽  
Vol 167 ◽  
pp. 105043
Author(s):  
Felipe Vedovatto ◽  
Gustavo Ugalde ◽  
Charline Bonatto ◽  
Suzana F. Bazoti ◽  
Helen Treichel ◽  
...  

2012 ◽  
Vol 48 (1) ◽  
pp. 23-27
Author(s):  
TOMONAO MIYASHIRO ◽  
QINGHONG WANG ◽  
YINGNAN YANG ◽  
KAZUYA SHIMIZU ◽  
NORIO SUGIURA ◽  
...  

Author(s):  
Henrique Di Domenico Ziero ◽  
Larissa Castro Ampese ◽  
William G. Sganzerla ◽  
Paulo C. Torres-Mayanga ◽  
Michael T. Timko ◽  
...  

2020 ◽  
Vol 225 ◽  
pp. 113380
Author(s):  
Mark Polikovsky ◽  
Amichai Gillis ◽  
Efraim Steinbruch ◽  
Arthur Robin ◽  
Michael Epstein ◽  
...  

BioResources ◽  
2016 ◽  
Vol 11 (2) ◽  
Author(s):  
Yuting Tu ◽  
Jichuan Huang ◽  
Peizhi Xu ◽  
Xuena Wu ◽  
Linxiang Yang ◽  
...  

2015 ◽  
Vol 7 (1) ◽  
pp. 29-37 ◽  
Author(s):  
Adi Purnomo ◽  
Yulius Andy Wibowo Yudiantoro ◽  
Jindrayani Nyoo Putro ◽  
Adi Tama Nugraha ◽  
Wenny Irawaty ◽  
...  

2003 ◽  
Vol 125 (1) ◽  
pp. 52-58 ◽  
Author(s):  
Akihiko Hirano ◽  
Michiyoshi Yamamoto ◽  
Katsumi Sakaguchi ◽  
Tetsuo Shoji ◽  
Kunihiro Iida

The flow rate of water flowing on a steel surface is considered to be one of the important factors strongly influencing the fatigue life of the steel, because the water flow produces difference in the local environmental conditions. The effect of the water flow rate on the fatigue life of a carbon steel was thus investigated experimentally. Fatigue testing of the carbon steel was performed at 289°C for various dissolved oxygen contents (DO) of less than 0.01 and 0.05, 0.2, and 1 ppm, and at various water flow rates. Three different strain rates of 0.4, 0.01, and 0.001 %/s were used in the fatigue tests. At the strain rate of 0.4 %/s, no significant difference in fatigue life was observed under the various flow rate conditions. On the other hand, at 0.01 %/s, the fatigue life increased with increasing water flow rate under all DO conditions, such that the fatigue life at a 7 m/s flow rate was about three times longer than that at a 0.3 m/s flow rate. This increase in fatigue life is attributed to increases in the crack initiation life and small-crack propagation life. The major mechanism producing these increases is considered to be the flushing effect on locally corrosive environments at the surface of the metal and in the cracks. At the strain rate of 0.001 %/s, the environmental effect seems to be diminished at flow rates higher than 0.1 m/s. This behavior does not seem to be explained by the flushing effect alone. Based on this experimental evidence, it was concluded that the existing fatigue data obtained for carbon steel under stagnant or relatively low flow rate conditions may provide a conservative basis for fatigue life evaluation. This approach seems useful for characterizing fatigue life evaluation by expressing increasing fatigue life in terms of increasing water flow rate.


2016 ◽  
Vol 108 ◽  
pp. 69-78 ◽  
Author(s):  
D. Lachos-Perez ◽  
F. Martinez-Jimenez ◽  
C.A. Rezende ◽  
G. Tompsett ◽  
M. Timko ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document