Different statistical methods to predict sulfur dioxide concentration and ozone concentration at Tung Chung

2005 ◽  
Author(s):  
Ka Fai Chan
2012 ◽  
Vol 534 ◽  
pp. 289-292
Author(s):  
Yan Jun Zhao ◽  
Dong Xing Wang ◽  
Yi Chen Lu ◽  
Rui Kun Gong

The non-dispersive infrared absorption spectrum method is one of the important sulfur dioxide concentration measurement method. If the soot particles attach on the protection windows surface, the original measurement light intensity is attenuated because of the absorption and scattering of the soot particle and the sulfur dioxide concentration measurement accuracy is decreased. The protection window pollution question caused by the monodispersion soot particles is discussed in the paper. The numerical simulation results show that the sulfur dioxide concentration measurement accuracy is related to the protection window pollution. The solution method is brought out and the measurement accuracy can be improved.


2016 ◽  
Vol 78 (6-4) ◽  
Author(s):  
Rattapong Tritippayanon ◽  
Veeraya Jiradilok ◽  
Pornpote Piumsomboon ◽  
Benjapon Chalermsinsuwan

The unsteady state computational fluid dynamics model for gas-solid particle flow in industrial scale circulating fluidized bed boiler combining with combustion and desulfurization (using limestone solid sorbent) chemical reactions, both homogeneous and heterogeneous, was developed in this study. The effects of solid sorbent feeding position and solid sorbent particle size on sulfur dioxide concentration were investigated. The results showed that both the solid sorbent feeding position and solid sorbent particle size had an effect on the sulfur dioxide capture. Entering solid sorbent at the upper secondary air position gave lower sulfur dioxide concentration than the one at the lower secondary air position and fuel feed position, respectively. This can be explained by the influence of suitable temperature at the upper secondary air position for desulfurization chemical reaction. About the solid sorbent particle size, the sulfur dioxide capture was the lowest when using the largest solid sorbent particle size due to the system hydrodynamics. 


2015 ◽  
Vol 15 (13) ◽  
pp. 7203-7216 ◽  
Author(s):  
A. Franchin ◽  
S. Ehrhart ◽  
J. Leppä ◽  
T. Nieminen ◽  
S. Gagné ◽  
...  

Abstract. We present the results of laboratory measurements of the ion–ion recombination coefficient at different temperatures, relative humidities and concentrations of ozone and sulfur dioxide. The experiments were carried out using the Cosmics Leaving OUtdoor Droplets (CLOUD) chamber at CERN, the walls of which are made of conductive material, making it possible to measure small ions. We produced ions in the chamber using a 3.5 GeV c−1 beam of positively charged pions (π+) generated by the CERN Proton Synchrotron (PS). When the PS was switched off, galactic cosmic rays were the only ionization source in the chamber. The range of the ion production rate varied from 2 to 100 cm−3 s−1, covering the typical range of ionization throughout the troposphere. The temperature ranged from −55 to 20 °C, the relative humidity (RH) from 0 to 70 %, the SO2 concentration from 0 to 40 ppb, and the ozone concentration from 200 to 700 ppb. The best agreement of the retrieved ion–ion recombination coefficient with the commonly used literature value of 1.6 × 10−6 cm3 s−1 was found at a temperature of 5 °C and a RH of 40 % (1.5 ± 0.6) × 10−6 cm3 s−1. At 20 °C and 40 % RH, the retrieved ion–ion recombination coefficient was instead (2.3 ± 0.7) × 10−6 cm3 s−1. We observed no dependency of the ion–ion recombination coefficient on ozone concentration and a weak variation with sulfur dioxide concentration. However, we observed a more than fourfold increase in the ion–ion recombination coefficient with decreasing temperature. We compared our results with three different models and found an overall agreement for temperatures above 0 °C, but a disagreement at lower temperatures. We observed a strong increase in the recombination coefficient for decreasing relative humidities, which has not been reported previously.


2011 ◽  
Vol 55 (2) ◽  
pp. 297-304 ◽  
Author(s):  
L. Hao ◽  
Y. Wang ◽  
J. Xu ◽  
S.-D. Feng ◽  
C.-Y. Ma ◽  
...  

2002 ◽  
Author(s):  
Zhenjiang He ◽  
Guanling Yang ◽  
Jianwen Xiong ◽  
Zuohua Huang ◽  
Hongzhong Chen ◽  
...  

2013 ◽  
Vol 718-720 ◽  
pp. 424-428
Author(s):  
Yan Jun Zhao ◽  
Shou Guang Cheng ◽  
Bin Qu

The non-dispersive infrared absorption method (NDIR) is one of the important sulfur dioxide concentration measurement methods. If the soot particles are in the measurement light path, the original measurement light intensity is attenuated because of the soot particles absorption and scattering and the sulfur dioxide concentration is increasing, so the accuracy of the sulfur dioxide concentration is decreased. The single soot particle interference caused by the dissipative and the non-dissipative soot scattering and absorption is discussed in the paper. The numerical simulation results show that the sulfur dioxide concentration measurement accuracy is related to the soot particle diameter. The solution method is brought out and the measurement accuracy can be improved.


2014 ◽  
Vol 886 ◽  
pp. 232-235
Author(s):  
Yan Jun Zhao ◽  
Shou Guang Cheng

NDIR method is one of the important sulfur dioxide concentration measurement methods. The original and the transmission light intensity on the sulfur dioxide attached on the protection windows is attenuated because of the soot absorption and scattering and the received light intensity of the sulfur dioxide characteristic absorption wavelength is deviated from the theoretical absorption light intensity, so the sulfur dioxide concentration measurement result is error. The protection window soot pollution interference caused by the multidispersion soot is discussed in this paper. The numerical simulation results based on the Mie theory show that the sulfur dioxide concentration measurement result is related to the multidispersion soot average diameter, soot diameter distribution and soot dissipativity. The solution method of the windows pollution soot interference is brought out and sulfur dioxide concentration measurement accuracy can be improved.


Sign in / Sign up

Export Citation Format

Share Document