Macroscopic Magnetic Measurements on Microscopic Quantities of Materials

1997 ◽  
Vol 475 ◽  
Author(s):  
Simon Foner
Keyword(s):  
Thin Films ◽  
Magnetic Measurements ◽  
Magnetic Measurement ◽  
Measurement Techniques ◽  
Squid Magnetometer ◽  
Vibrating Sample Magnetometer ◽  
Small Particles ◽  
Controlled Systems ◽  
Magnetic Ions ◽  
Computer Controlled

ABSTRACTThe principles of several of the most popular macroscopic magnetic measurement techniques are discussed for the vibrating sample magnetometer, SQUID magnetometer, ac susceptometer, ac force magnetometer, and torque magnetometers. These types of instruments are available commercially as stand-alone computer-controlled systems, Selected examples of recent measurements on thin films, small particles, and clusters of magnetic ions are presented.

Effect of Annealing temperature on the Structural and Magnetic Properties of TbxY3-xFe5O12(x = 0.0, 1.0, 2.0) Thin Films Prepared by Sol-Gel Process

2012 ◽  
Vol 501 ◽  
pp. 236-241 ◽  
Author(s):  
Ftema W. Aldbea ◽  
Noor Bahyah Ibrahim ◽  
Mustafa Hj. Abdullah ◽  
Ramadan E. Shaiboub
Keyword(s):  
Thin Films ◽  
Magnetic Properties ◽  
Room Temperature ◽  
Annealing Temperature ◽  
Sol Gel ◽  
Vibrating Sample Magnetometer ◽  
X Ray ◽  
Garnet Phase ◽  
Sol Gel Process ◽  
Amorphous Structures

Thin films nanoparticles TbxY3-xFe5O12 (x=0.0, 1.0, 2.0) were prepared by the sol-gel process followed by annealing process at various annealing temperatures of 700° C, 800° C and 900° C in air for 2 h. The results obtained from X-ray diffractometer (XRD) show that the films annealed below 900°C exhibit peaks of garnet mixed with small amounts of YFeO3 and Fe2O3. Pure garnet phase has been detected in the films annealed at 900°C. Before annealing the films show amorphous structures. The particles sizes measurement using the field emission scanning electron microscope (FE-SEM) showed that the particles sizes increased as the annealing temperature increased. The magnetic properties were measured at room temperature using the vibrating sample magnetometer (VSM). The saturation magnetization (Ms) of the films also increased with the annealing temperature. However, different behavior of coercivity (Hc) has been observed as the annealing temperature was increased.

Magnetic Measurement Techniques for Locating Foreign Bodies in Humans

Biomag 96 ◽  
2000 ◽  
pp. 28-31
Author(s):  
E. Costa Monteiro ◽  
C. Kelber ◽  
E. Andrade Lima ◽  
P. Costa Ribeiro ◽  
A. C. Bruno ◽  
...  
Keyword(s):  
Foreign Bodies ◽  
Magnetic Measurement ◽  
Measurement Techniques

scholarly journals Spacecraft and interplanetary contributions to the magnetic environment on-board LISA Pathfinder

2020 ◽  
Vol 494 (2) ◽  
pp. 3014-3027
Author(s):  
M Armano ◽  
H Audley ◽  
J Baird ◽  
P Binetruy ◽  
M Born ◽  
...  
Keyword(s):  
Magnetic Field ◽  
New Technologies ◽  
Magnetic Measurements ◽  
Magnetic Measurement ◽  
Low Frequency ◽  
Lisa Pathfinder ◽  
Frequency Regime ◽  
The Magnetic Field ◽  
Instrument Sensitivity ◽  
Stationary Component

ABSTRACT LISA Pathfinder (LPF) has been a space-based mission designed to test new technologies that will be required for a gravitational wave observatory in space. Magnetically driven forces play a key role in the instrument sensitivity in the low-frequency regime (mHz and below), the measurement band of interest for a space-based observatory. The magnetic field can couple to the magnetic susceptibility and remanent magnetic moment from the test masses and disturb them from their geodesic movement. LPF carried on-board a dedicated magnetic measurement subsystem with noise levels of 10 $\rm nT \ Hz^{-1/2}$ from 1 Hz down to 1 mHz. In this paper we report on the magnetic measurements throughout LPF operations. We characterize the magnetic environment within the spacecraft, study the time evolution of the magnetic field and its stability down to 20 μHz, where we measure values around 200 $\rm nT \ Hz^{-1/2}$, and identify two different frequency regimes, one related to the interplanetary magnetic field and the other to the magnetic field originating inside the spacecraft. Finally, we characterize the non-stationary component of the fluctuations of the magnetic field below the mHz and relate them to the dynamics of the solar wind.

Effect of MWCNT addition on the optical band gap of PVA/CS transient biocomposites

2021 ◽  
pp. 002199832110370
Author(s):  
Ömer Bahadır Mergen
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Band Gap ◽  
Optical Band Gap ◽  
Rapid Development ◽  
Measurement Techniques ◽  
Resistivity Measurement ◽  
Optical Parameters ◽  
Optical And Electrical Properties ◽  
Biocomposite Films

In recent years, as a result of increasing environmental concerns, biodegradable materials have gained great attention. With the rapid development of electronic technology, the importance of innovation and development of low-cost, sustainable, transient bioelectronics materials is increasing. In this research, the preparation of Poly(Vinyl Alcohol) (PVA), Chitosan (CS), and Multi-Walled Carbon nanotube (MWCNT) biocomposite films have been described. The solution mixing, ultrasonic mixing, and spin coating techniques were used to prepare the PVA/CS/MWCNT biocomposite thin films. UV–Vis absorption spectroscopy and two-point probe resistivity measurement techniques were used to study the optical and electrical properties of the biocomposite thin films. Optical band gap energies ( Eg) of PVA/CS/MWCNT biocomposites were obtained using the Tauc and Absorbance Spectrum Fitting (ASF) methods. Results obtained with both methods were found to be exactly the same. Experimental results have shown that with increasing MWCNT concentration, electrical conductivity (σ) increases from 1.75x10−16 S to 2.94x10−3 S, and Eg decreases significantly. At the same time, the fundamental optical parameters such as band tail (Urbach) energy ( Eu), refractive index ( n), absorption ( α), and extinction ( k) coefficient of the PVA/CS/MWCNT biocomposites were investigated in the UV-VIS range. The improvement observed in the optical and electrical properties of PVA/CS/MWCNT biocomposite films shows that these composites could be used as bioelectronics materials.

Sign in / Sign up

Export Citation Format

Share Document