scholarly journals On the Effect of Beating during Nonlinear Frequency Chirping

2021 ◽  
Vol 16 (0) ◽  
pp. 1403087-1403087
Author(s):  
Andreas BIERWAGE ◽  
Roscoe B. WHITE ◽  
Vinícius N. DUARTE
2010 ◽  
Vol 18 (22) ◽  
pp. 23413 ◽  
Author(s):  
Slaven Moro ◽  
Aleksandar Danicic ◽  
Nikola Alic ◽  
Bryan Stossel ◽  
Stojan Radic

2019 ◽  
Vol 62 (5) ◽  
pp. 1486-1505
Author(s):  
Joshua M. Alexander

PurposeFrequency lowering in hearing aids can cause listeners to perceive [s] as [ʃ]. The S-SH Confusion Test, which consists of 66 minimal word pairs spoken by 6 female talkers, was designed to help clinicians and researchers document these negative side effects. This study's purpose was to use this new test to evaluate the hypothesis that these confusions will increase to the extent that low frequencies are altered.MethodTwenty-one listeners with normal hearing were each tested on 7 conditions. Three were control conditions that were low-pass filtered at 3.3, 5.0, and 9.1 kHz. Four conditions were processed with nonlinear frequency compression (NFC): 2 had a 3.3-kHz maximum audible output frequency (MAOF), with a start frequency (SF) of 1.6 or 2.2 kHz; 2 had a 5.0-kHz MAOF, with an SF of 1.6 or 4.0 kHz. Listeners' responses were analyzed using concepts from signal detection theory. Response times were also collected as a measure of cognitive processing.ResultsOverall, [s] for [ʃ] confusions were minimal. As predicted, [ʃ] for [s] confusions increased for NFC conditions with a lower versus higher MAOF and with a lower versus higher SF. Response times for trials with correct [s] responses were shortest for the 9.1-kHz control and increased for the 5.0- and 3.3-kHz controls. NFC response times were also significantly longer as MAOF and SF decreased. The NFC condition with the highest MAOF and SF had statistically shorter response times than its control condition, indicating that, under some circumstances, NFC may ease cognitive processing.ConclusionsLarge differences in the S-SH Confusion Test across frequency-lowering conditions show that it can be used to document a major negative side effect associated with frequency lowering. Smaller but significant differences in response times for correct [s] trials indicate that NFC can help or hinder cognitive processing, depending on its settings.


Sensors ◽  
2021 ◽  
Vol 21 (8) ◽  
pp. 2840
Author(s):  
Hubert Milczarek ◽  
Czesław Leśnik ◽  
Igor Djurović ◽  
Adam Kawalec

Automatic modulation recognition plays a vital role in electronic warfare. Modern electronic intelligence and electronic support measures systems are able to automatically distinguish the modulation type of an intercepted radar signal by means of real-time intra-pulse analysis. This extra information can facilitate deinterleaving process as well as be utilized in early warning systems or give better insight into the performance of hostile radars. Existing modulation recognition algorithms usually extract signal features from one of the rudimentary waveform characteristics, namely instantaneous frequency (IF). Currently, there are a small number of studies concerning IF estimation methods, specifically for radar signals, whereas estimator accuracy may adversely affect the performance of the whole classification process. In this paper, five popular methods of evaluating the IF–law of frequency modulated radar signals are compared. The considered algorithms incorporate the two most prevalent estimation techniques, i.e., phase finite differences and time-frequency representations. The novel approach based on the generalized quasi-maximum likelihood (QML) method is also proposed. The results of simulation experiments show that the proposed QML estimator is significantly more accurate than the other considered techniques. Furthermore, for the first time in the publicly available literature, multipath influence on IF estimates has been investigated.


Author(s):  
Ruqia Ikram ◽  
Asif Israr

This study presents the vibration characteristics of plate with part-through crack at random angles and locations in fluid. An experimental setup was designed and a series of tests were performed for plates submerged in fluid having cracks at selected angles and locations. However, it was not possible to study these characteristics for all possible crack angles and crack locations throughout the plate dimensions at any fluid level. Therefore, an analytical study is also carried out for plate having horizontal cracks submerged in fluid by adding the influence of crack angle and crack location. The effect of crack angle is incorporated into plate equation by adding bending and twisting moments, and in-plane forces that are applied due to antisymmetric loading, while the influence of crack location is also added in terms of compliance coefficients. Galerkin’s method is applied to get time dependent modal coordinate system. The method of multiple scales is used to find the frequency response and peak amplitude of submerged cracked plate. The analytical model is validated from literature for the horizontally cracked plate submerged in fluid as according to the best of the authors’ knowledge, literature lacks in results for plate with crack at random angle and location in the presence of fluid following validation with experimental results. The combined effect of crack angle, crack location and fluid on the natural frequencies and peak amplitude are investigated in detail. Phenomenon of bending hardening or softening is also observed for different boundary conditions using nonlinear frequency response curves.


Sign in / Sign up

Export Citation Format

Share Document