scholarly journals Stability and Thermo-Physical Properties of Ethylene Glycol Based Nanofluids for Solar Thermal Applications

2021 ◽  
Vol 39 (1) ◽  
pp. 137-144
Author(s):  
Raviteja Surakasi ◽  
Jaikumar Sagari ◽  
Krishna Bharath Vinjamuri ◽  
Bhanuteja Sanduru ◽  
Srinivas Vadapalli
Keyword(s):  
Thermal Conductivity ◽  
Carbon Nanotubes ◽  
Ethylene Glycol ◽  
Physical Properties ◽  
Dynamic Viscosity ◽  
Temperature Range ◽  
Multi Walled Carbon Nanotubes ◽  
Walled Carbon Nanotubes ◽  
Thermo Physical Properties ◽  
Surfactant Assisted

This article summarizes research involving the evaluation of the thermo-physical properties of ethylene- glycol-based solar thermic fluids oxidized multi-walled carbon nanotubes. Nanofluids were prepared with Ethylene glycol and water as base fluids in 100:0, 90:10 and 80:20 ratios. Base fluids of three categories were dispersed with surfactant-assisted multi-walled carbon nanotubes (MWCNTs) and oxidized MWCNTs in the weight fractions of 0.125, 0.25, and 0.5 percentages to check the influence of surface modification technique on the thermophysical properties. The variation in zeta potential is studied to examine the dispersion stability during 2 months. Thermal conductivity and dynamic viscosity were measured by hot disk method and Anton paar viscometer, respectively. Significant enhancement of thermal conductivity by 15 to 24 % was observed when the base fluids are dispersed with oxidized MWCNTs. In the case of nanofluids dispersed with surfactant-assisted MWCNTs, the improvement is significantly less compared to oxidized MWCNTs. Nanofluids' dynamic viscosity is found to be higher compared to base fluids in the temperature range of 50 to 70 oC. A comprehensive mathematical equation suitable for all weight fraction of MWCNTs and volume percentages of Ethylene glycol was developed, which can forecast the temperature range. The correlation could fit well with the experimental data in reasonable limits.

scholarly journals Experimental Investigation of Thermo-Physical Properties of Tri-Hybrid Nanoparticles in Water-Ethylene Glycol Mixture

2021 ◽  
Vol 18 (8) ◽  
Author(s):  
Anwar Ilmar RAMADHAN ◽  
Wan Hamzah AZMI ◽  
Rizalman MAMAT
Keyword(s):  
Heat Transfer ◽  
Thermal Conductivity ◽  
Ethylene Glycol ◽  
Physical Properties ◽  
Dynamic Viscosity ◽  
Volume Concentration ◽  
Hybrid Nanoparticles ◽  
Maximum Enhancement ◽  
Hybrid Nanofluids ◽  
Thermo Physical Properties

In recent years, research has focused on enhancing the thermo-physical properties of a single component nanofluid. Therefore, hybrid or composite nanofluids have been developed to improve heat transfer performance. The thermo-physical properties of the Al2O3-TiO2-SiO2 nanoparticles suspended in a base of water (W) and ethylene glycol (EG) at constant volume ratio of 60:40 and different volume concentrations were investigated. The experiment was conducted for the volume concentrations of 0.05, 0.1, 0.2, and 0.3% of Al2O3-TiO2-SiO2 nanofluids at different temperatures of 30, 40, 50, 60, and 70 °C. Thermal conductivity and dynamic viscosity measurements were carried out at temperatures ranging from 30 to 70 °C by using KD2 Pro Thermal Properties Analyzer and Brookfield LVDV III Ultra Rheometer, respectively. The highest thermal conductivity for tri-hybrid nanofluids was obtained at 0.3% volume concentration, and the maximum enhancement was increased up to 9% higher than the base fluid (EG/W). Tri-hybrid nanofluids with a volume concentration of 0.05% gave the lowest effective thermal conductivity of 4.8 % at 70 °C temperature. Meanwhile, the dynamic viscosity of the tri-hybrid nanofluids was influenced by volume concentration and temperature. Furthermore, tri-hybrid nanofluids behaved as a Newtonian fluid for volume concentrations from 0.05 to 3.0%. The properties enhancement ratio (PER) estimated that the tri-hybrid nanofluids will aid in heat transfer for all samples in the present. The new correlations for thermal conductivity and dynamic viscosity of tri-hybrid nanofluids were developed with minimum deviation. As a conclusion, the combination of the enhancement in thermal conductivity and dynamic viscosity for tri-hybrid at 0.3% volume concentration was found the optimum condition with more advantage for heat transfer than other concentrations.

scholarly journals Thermophysical Properties of Nanofluids Composed of Ethylene Glycol and Long Multi-Walled Carbon Nanotubes

Fluids ◽  
2020 ◽  
Vol 5 (4) ◽  
pp. 241
Author(s):  
Karolina Brzóska ◽  
Bertrand Jóźwiak ◽  
Adrian Golba ◽  
Marzena Dzida ◽  
Sławomir Boncel
Keyword(s):  
Thermal Conductivity ◽  
Carbon Nanotubes ◽  
Ethylene Glycol ◽  
Chemical Vapor ◽  
Step Method ◽  
Mwcnt Content ◽  
Multi Walled Carbon Nanotubes ◽  
The Stability ◽  
Walled Carbon Nanotubes ◽  
Rotary Viscometer

In this work, thermal conductivity, viscosity, isobaric heat capacity, and density of stable carbon-based nanofluids are presented. The nanofluids under study are composed of 1,2-ethanediol (ethylene glycol, EG) and long multi-walled carbon nanotubes (MWCNTs), so-called ‘in-house 16h’ (synthesized in our laboratory via catalytic chemical vapor deposition during 16 h with a diameter of 60–80 nm and length of 770 μm). Poly(N-vinylpyrrolidone) (PVP) was used to increase the stability of nanofluids. The nanofluids were prepared via an ultrasonication-assisted, three-step method while their key thermophysical characteristics were obtained using the hot-wire technique and rotary viscometer. As a result, the addition of MWCNTs significantly improved the thermal conductivity of nanofluids by 31.5% for the highest 1.0 wt% (0.498 vol%) long MWCNT content, leaving the Newtonian character of the nanofluids practically intact.

Sign in / Sign up

Export Citation Format

Share Document