Summary
This paper discusses the performance and productivity of fractured horizontal wells in heterogeneous, tight-gas formations. Production characteristics and flow regimes of unfractured and fractured horizontal wells are documented. The results show that if hydraulic fracturing affects stress distribution to create or rejuvenate natural fractures around the well, the productivity of the system is significantly increased. Unless there is significant contrast between the conductivities of the hydraulic and natural fractures, hydraulic fractures may not significantly contribute to the productivity. For extremely tight formations, the effective drainage area may be limited to the naturally fractured region around the well and the hydraulic fractures. It is also shown that very long transient flow periods govern the productivity and economics of fractured horizontal wells in tight formations. The results of this study are also applicable to oil production from fractured shale.
Introduction
Economic gas and oil production from low permeability reservoirs has been a challenge for the oil and gas industry. Because most of the high permeability reservoirs have been exploited and many low permeability reservoirs remain undeveloped, the latter have taken the industry attention recently. Particular attention has been given to tight-gas reservoirs with permeability in the range of micro-Darcies or below and to oil accumulation in fractured shale.
Hydraulically fractured horizontal wells are the proven technology to produce oil and gas from tight formations. Hydraulic fractures reduce well drawndown, increase the productivity of horizontal wells by increasing the surface area in contact with formation, and provide high conductivity paths to the wellbore. Depending on in-situ stress orientation, hydraulic fractures can be parallel (longitudinal) or perpendicular (transverse) to horizontal well axis. Project economics in tight formations, however, depends strongly on well spacing and the number of hydraulic fractures required to drain the reservoir efficiently. Field evidence indicates that the drainage areas of fractured horizontal wells in tight formations may be limited to a rectangular region confining the horizontal well and the transverse hydraulic fractures. Also, there has been evidence that hydraulic fracturing in tight formations changes stresses in fracture drainage area, which could create or rejuvenate natural fractures in the near-vicinity of the horizontal well. This fracture network, which may be characterized as a dual-porosity system, may contribute significantly to improve productivity of the fractured horizontal well.
Much work has been done (Soliman et al. 1990; Larsen and Hegre 1994; Temeng and Horne 1995; Raghavan et al. 1997; Wan and Aziz 1999; Al-Kobaisi et al. 2006) to investigate pressure-transient analysis and short- and long-term productivity of horizontal wells with single or multiple hydraulic fractures. The effect of a dual-porosity zone surrounding hydraulic fractures, however, has not been considered in the previous studies. The main objective of this study is to investigate the combined effects of a dual-porosity region and hydraulic fractures on the productivity of horizontal wells.
The results presented in this work are based on a semianalytical model developed by Medeiros et al. (2006). The model was derived from the Green's function formulation of the solution for the diffusivity equation (Gringarten and Ramey, 1974, Ozkan and Raghavan, 1991a, 1991b) and has the capability to incorporate local heterogeneities. In this work, we use the semianalytical model to incorporate induced finite-conductivity fractures (transverse and longitudinal) along the horizontal well and naturally fractured zones around the hydraulically fractured horizontal well by using the dual-porosity idealization. We use the example data sets given in Tables 1 through 3 to consider different cases of horizontal wells with and without induced and natural fractures.