Abstract
As an effective method of improving the attractiveness of urban public transport and alleviating urban traffic congestion, bus lanes play an important role in the urban public transport system. The research on the capacity of bus lanes is conducive to improve the operation efficiency of urban bus roads and improve the service level of urban public transport. To obtain the maximum capacity of the bus lane, on one hand, the empirical formula can be used for theoretical calculation, and on the other hand, the simulation model can be established for analysis and verification. Based on the idea of simulation, a method using Vissim is proposed, called MTCS (Minimum Traffic Capacity Substitution Method). The method divides the bus lane into different sections by intersections and stops, establishes simulation model of the bus lane to calculate the traffic capacity of each section such as vehicle speed and flow and select the minimum traffic capacity of the sections as the traffic capacity of the bus lane, which is verified by using the road saturation. The simulation process uses the actual travel speed and traffic flow of the bus lane as evaluation indicators, with the aim of maximizing the road traffic flow while the actual speed of vehicles on the road is close to the desired speed, thus achieving the desired road traffic state. To verify and improve the effectiveness of the method, its analysis results are compared with the empirical formula, and various methods of enhancing traffic capacity are quantitatively simulated. The parameters of the simulation model are set by the actual bus lane example, and the experimental results show that by the methods of modifying the stop-station mode and the signal-lamp cycle, 10% and 14% improvements can be achieved, respectively. This has a good reference value for the construction of bus lanes and the adjustment of road facilities.
A SIMULATION MODEL FOR U-TURN TRAFFIC CAPACITY