Selection of an ultraviolet disinfection system for a municipal wastewater treatment plant

2004 ◽  
Vol 50 (7) ◽  
pp. 163-169 ◽  
Author(s):  
S.J. Kang ◽  
T.A. Allbaugh ◽  
J.W. Reynhout ◽  
T.L. Erickson ◽  
K.P. Olmstead ◽  
...  

As part of an expansion to an average flow of 45.9 million gallons per day (174 mld), the Ypsilanti Community Utilities Authority wastewater treatment plant in the State of Michigan, USA, elected to install ultraviolet disinfection as a replacement for the existing chlorination process. This paper presents a unique methodology used in selecting the best system based on not only the life cycle costs, and O & M considerations but also the participation of the stakeholders. The Team members consisted of representatives of all departments at the Authority, and these Team members made the decision. The Team evaluated all criteria in the office, which was followed by verification at selected sites with similar types of equipment. The selected equipment then was pilot tested for validation of the dose-kill relationship under normal operation and also under reduced irradiation conditions. A low-pressure, high intensity system was selected, based on life-cycle cost, reliability, safety, and ease of operation. This paper describes the unique methodologies used in making that decision. The full-scale system is scheduled for start-up in Spring 2003.

Water ◽  
2021 ◽  
Vol 13 (10) ◽  
pp. 1339
Author(s):  
Javier Bayo ◽  
Sonia Olmos ◽  
Joaquín López-Castellanos

This study investigates the removal of microplastics from wastewater in an urban wastewater treatment plant located in Southeast Spain, including an oxidation ditch, rapid sand filtration, and ultraviolet disinfection. A total of 146.73 L of wastewater samples from influent and effluent were processed, following a density separation methodology, visual classification under a stereomicroscope, and FTIR analysis for polymer identification. Microplastics proved to be 72.41% of total microparticles collected, with a global removal rate of 64.26% after the tertiary treatment and within the average retention for European WWTPs. Three different shapes were identified: i.e., microfiber (79.65%), film (11.26%), and fragment (9.09%), without the identification of microbeads despite the proximity to a plastic compounding factory. Fibers were less efficiently removed (56.16%) than particulate microplastics (90.03%), suggesting that tertiary treatments clearly discriminate between forms, and reporting a daily emission of 1.6 × 107 microplastics to the environment. Year variability in microplastic burden was cushioned at the effluent, reporting a stable performance of the sewage plant. Eight different polymer families were identified, LDPE film being the most abundant form, with 10 different colors and sizes mainly between 1–2 mm. Future efforts should be dedicated to source control, plastic waste management, improvement of legislation, and specific microplastic-targeted treatment units, especially for microfiber removal.


Sign in / Sign up

Export Citation Format

Share Document