scholarly journals Calculation of Nitrogen Absorption into Austenitic Stainless Steel Plate and Wire

2004 ◽  
Vol 44 (6) ◽  
pp. 1121-1123 ◽  
Author(s):  
Toshihiro Tsuchiyama ◽  
Taishiro Fukumaru ◽  
Makoto Egashira ◽  
Setsuo Takaki
Keyword(s):  
Stainless Steel ◽  
Austenitic Stainless Steel ◽  
Steel Plate ◽  
Nitrogen Absorption ◽  
Stainless Steel Plate

scholarly journals Cryogenic Fracture Toughness and Temperature Rise of Thick Section Weldment in Forged JJ1 Type Austenitic Stainless Steel Plate.

1997 ◽  
Vol 15 (2) ◽  
pp. 370-375 ◽  
Author(s):  
Yasuhide SHINDO ◽  
Tomotaka TAKAHASHI ◽  
Katsumi HORIGUCHI ◽  
Tomoyuki KOBORI ◽  
Kazuaki SANADA
Keyword(s):  
Fracture Toughness ◽  
Stainless Steel ◽  
Austenitic Stainless Steel ◽  
Temperature Rise ◽  
Steel Plate ◽  
Thick Section ◽  
Stainless Steel Plate

Numerical Simulation of a Single Bead on Plate and Three Pass Slot Welds in Austenitic Stainless Steel

2011 ◽  
Author(s):  
Jijin Xu ◽  
Philippe Gilles
Keyword(s):  
Residual Stress ◽  
Stainless Steel ◽  
Austenitic Stainless Steel ◽  
Structural Integrity ◽  
Steel Plate ◽  
Task Group ◽  
Stress Fields ◽  
Stainless Steel Plate ◽  
First Case ◽  
Welding Processes

This paper provides the numerical simulations of two welding benchmark cases defined in the frame of the European Network on Neutron Techniques Standardization for Structural Integrity. The network involves over 35 organizations from industry and promotes the application of modern experimental and numerical techniques to problems related to the determination of residual stress and distortion in components. The first case issued by Task Group 1, addresses the estimation of residual stress fields around a single weld bead deposited on an austenitic stainless steel plate. The second case issued by Task Group 4, deals with the estimation of residual stress fields in a three-pass slot weld in an austenitic stainless steel plate. In both cases, the welding processes and types of material are same: tungsten-inert-gas welding and AISI 316 stainless steel. It is therefore of interest to compare these two studies in terms of differences between calculated / measured and in terms of the influences of the number of welding pass and heat input.

Sign in / Sign up

Export Citation Format

Share Document