Large-eddy simulations of the vortex-pair breakup in aircraft wakes

AIAA Journal ◽  
1996 ◽  
Vol 34 (11) ◽  
pp. 2337-2345 ◽  
Author(s):  
D. C. Lewellen ◽  
W. S. Lewellen
AIAA Journal ◽  
1998 ◽  
Vol 36 ◽  
pp. 1439-1445 ◽  
Author(s):  
D. C. Lewellen ◽  
W. S. Lewellen ◽  
L. R. Poole ◽  
C. A. Hostetler ◽  
R. J. DeCoursey ◽  
...  

Author(s):  
Aaron F. Shinn ◽  
S. Pratap Vanka

Large Eddy Simulations were performed to study the effect of a micro-ramp on an inclined turbulent jet interacting with a cross-flow in a film-cooling configuration. The micro-ramp vortex generator is placed downstream of the film-cooling jet. Changes in vortex structure and film-cooling effectiveness are evaluated and the genesis of the counter-rotating vortex pair in the jet is discussed. Results are reported with the jet modeled using a plenum/pipe configuration. This configuration was designed based on previous wind tunnel experiments at NASA Glenn Research Center, and the present results are meant to supplement those experiments. It is found that the micro-ramp improves film-cooling effectiveness by generating near-wall counter-rotating vortices which help entrain coolant from the jet and transport it to the surface. The pair of vortices generated by the micro-ramp are of opposite sense to the vortex pair embedded in the jet.


1999 ◽  
Vol 379 ◽  
pp. 71-104 ◽  
Author(s):  
LESTER L. YUAN ◽  
ROBERT L. STREET ◽  
JOEL H. FERZIGER

This paper reports on a series of large-eddy simulations of a round jet issuing normally into a crossflow. Simulations were performed at two jet-to-crossflow velocity ratios, 2.0 and 3.3, and two Reynolds numbers, 1050 and 2100, based on crossflow velocity and jet diameter. Mean and turbulent statistics computed from the simulations match experimental measurements reasonably well. Large-scale coherent structures observed in experimental flow visualizations are reproduced by the simulations, and the mechanisms by which these structures form are described. The effects of coherent structures upon the evolution of mean velocities, resolved Reynolds stresses, and turbulent kinetic energy along the centreplane are discussed. In this paper, the ubiquitous far-field counter-rotating vortex pair is shown to originate from a pair of quasi-steady ‘hanging’ vortices. These vortices form in the skewed mixing layer that develops between jet and crossflow fluid on the lateral edges of the jet. Axial flow through the hanging vortex transports vortical fluid from the near-wall boundary layer of the incoming pipe flow to the back side of the jet. There, the hanging vortex encounters an adverse pressure gradient and breaks down. As this breakdown occurs, the vortex diameter expands dramatically, and a weak counter-rotating vortex pair is formed that is aligned with the jet trajectory.


2012 ◽  
Vol 135 (1) ◽  
Author(s):  
Aaron F. Shinn ◽  
S. Pratap Vanka

Large eddy simulations were performed to study the effect of a micro-ramp on an inclined turbulent jet interacting with a cross-flow in a film-cooling configuration. The micro-ramp vortex generator is placed downstream of the film-cooling jet. Changes in vortex structure and film-cooling effectiveness are evaluated. Coherent turbulent structures characteristic of a jet in a cross-flow are analyzed and the genesis of the counter-rotating vortex pair in the jet is discussed. Results are reported for two film-cooling configurations, where the primary difference is the way the jet inflow boundary conditions are prescribed. In the first configuration, the jet conditions are prescribed using a precursor simulation and in the second the jet is modeled using a plenum/pipe configuration. The latter configuration was designed based on previous wind tunnel experiments at NASA Glenn Research Center, and the present results are meant to supplement those experiments. It is found that the micro-ramp improves film-cooling effectiveness by generating near-wall counter-rotating vortices which help entrain coolant from the jet and transport it to the surface. The pair of vortices generated by the micro-ramp are of opposite sense to the vortex pair embedded in the jet.


AIAA Journal ◽  
10.2514/2.535 ◽  
1998 ◽  
Vol 36 (8) ◽  
pp. 1439-1445 ◽  
Author(s):  
D. C. Lewellen ◽  
W. S. Lewellen ◽  
L. R. Poole ◽  
R. J. DeCoursey ◽  
G. M. Hansen ◽  
...  

Author(s):  
Sai Shrinivas Sreedharan ◽  
Danesh K. Tafti

A three-row leading edge film cooling geometry is investigated using Large-Eddy Simulations (LES) at a freestream Reynolds number of 32,000 and blowing ratio of 0.5 with lateral injection of 45° to the surface and 90° compound injection. The stagnation jet interacts with the mainstream through the generation of ring vortices which quickly breakdown and convect along the cylinder surface. The coolant penetrates the mainstream both laterally and normal to the surface resulting in increased mixing and turbulence generation. As the coolant loses transverse and lateral momentum it is pushed back to the surface in the stagnation region after which it convects downstream along the blade surface. Surface coverage is uniform but weak with spanwise-averaged effectiveness ranging from 0.1 to 0.3 in the stagnation region. The primary off-stagnation coolant and mainstream interaction is through the generation of a counter-rotating vortex pair in the immediate wake, but which quickly degenerates to a single vortex which entrains free-stream fluid near the surface at the aft-end of the jet. In contrast to the stagnation row, the coolant stays in close proximity to the surface and does not undergo a large lateral displacement along the spanwise pitch. As a consequence it provides good local coverage along its trajectory but barely covers half the lateral pitch. Hence, spanwise-averaged effectiveness is of the same order as at stagnation starting at 0.3 downstream of injection to 0.1 about 6d downstream.


2012 ◽  
Vol 39 (3) ◽  
pp. 272-289 ◽  
Author(s):  
Bahram Khalighi ◽  
Gianluca Iaccarino ◽  
Yaser Khalighi

Sign in / Sign up

Export Citation Format

Share Document