CNES Gaia Data Processing Centre: A Complex Operation Plan

Author(s):  
Veronique Valette
2016 ◽  
Vol 53 (5) ◽  
pp. 5-16
Author(s):  
F. Bushuev ◽  
M. Kaliuzhnyi ◽  
Y. Sybiryakova ◽  
O. Shulga ◽  
S. Moskalenko ◽  
...  

Abstract The results of the ongoing monitoring of the position of geostationary telecommunication satellite Eutelsat-13B (13° East) are presented in the article. The results were obtained using a radio engineering complex (RC) of four stations receiving digital satellite television and a data processing centre. The stations are located in Kyiv, Mukachevo, Kharkiv and Mykolaiv. The equipment of each station allows synchronous recording (by the GPS) of fragments of DVB-S signal from the quadrature detector output of the satellite television receiver. Samples of the complex signal are archived and sent to the data processing center through the Internet. Here three linearly independent slant range differences (Δr) for three pairs of the stations are determined as a result of correlation processing of received signals. Every second measured values of Δr are used to calculate Cartesian coordinates (XYZ) of the satellite in the coordinate system WGS84 by multilateration method. The time series of Δr, X, Y and Z obtained during continuous observations from March to May 2015 are presented in the article. Single-measurement errors of Δr, X, Y and Z are equal to 2.6 m, 3540 m, 705 m and 455 m, respectively. The complex is compared with known analogues. Ways of reduction of measurement errors of satellite coordinates are considered. The radio engineering complex could be considered a prototype of a system of independent ongoing monitoring of the position of geostationary telecommunication satellites.


2009 ◽  
Vol 27 (3) ◽  
pp. 121-130 ◽  
Author(s):  
Roberto Ambrosini ◽  
Pietro Bolli ◽  
Claudio Bortolotti ◽  
Francesco Gaudiomonte ◽  
Filippo Messina ◽  
...  

1974 ◽  
Vol 13 (03) ◽  
pp. 125-140 ◽  
Author(s):  
Ch. Mellner ◽  
H. Selajstder ◽  
J. Wolodakski

The paper gives a report on the Karolinska Hospital Information System in three parts.In part I, the information problems in health care delivery are discussed and the approach to systems design at the Karolinska Hospital is reported, contrasted, with the traditional approach.In part II, the data base and the data processing system, named T1—J 5, are described.In part III, the applications of the data base and the data processing system are illustrated by a broad description of the contents and rise of the patient data base at the Karolinska Hospital.


1978 ◽  
Vol 17 (01) ◽  
pp. 36-40 ◽  
Author(s):  
J.-P. Durbec ◽  
Jaqueline Cornée ◽  
P. Berthezene

The practice of systematic examinations in hospitals and the increasing development of automatic data processing permits the storing of a great deal of information about a large number of patients belonging to different diagnosis groups.To predict or to characterize these diagnosis groups some descriptors are particularly useful, others carry no information. Data screening based on the properties of mutual information and on the log cross products ratios in contingency tables is developed. The most useful descriptors are selected. For each one the characterized groups are specified.This approach has been performed on a set of binary (presence—absence) radiological variables. Four diagnoses groups are concerned: cancer of pancreas, chronic calcifying pancreatitis, non-calcifying pancreatitis and probable pancreatitis. Only twenty of the three hundred and forty initial radiological variables are selected. The presence of each corresponding sign is associated with one or more diagnosis groups.


Metrologiya ◽  
2020 ◽  
pp. 16-24
Author(s):  
Alexandr D. Chikmarev

A single program has been developed to ensure that the final result of the data processing of the measurement calibration protocol is obtained under normal conditions. The calibration result contains a calibration function or a correction function in the form of a continuous sedate series and a calibration chart based on typical additive error probabilities. Solved the problem of the statistical treatment of the calibration protocol measuring in normal conditions within a single program “MMI–calibration 3.0” that includes identification of the calibration function in a continuous power series of indications of a measuring instrument and chart calibration. An example of solving the problem of calibration of the thermometer by the working standard of the 3rd grade with the help of the “MMI-calibration 3.0” program.


Sign in / Sign up

Export Citation Format

Share Document