scholarly journals Optimization of waste heat recovery system for mobile compressor unit for compressing natural gas

Author(s):  
I. D. Obukhov ◽  

This paper presents the methodology and results of optimization of the waste heat recovery system (WHRS) of a mobile compressor unit (MCU) designed to compress natural gas using a computer model in the MatLab with the CoolProp thermodynamic package. In the course of the study, a computer model of the WHRS is built, a criterion for the efficiency of recuperation is determined, an optimization problem is formulated and its solution is carried out. The boiling pressure and mass flow rate of the working fluid in the Rankine cycle are taken as the optimization parameters. With the optimal values of these parameters, the smallest value of the relative mass fuel consumption of the MCU is achieved, that is, the maximum recuperation efficiency is achieved.

Author(s):  
Jennifer Strehler ◽  
Scott Vandenburgh ◽  
Dave Parry ◽  
Tim Rynders

The Town of Avon Colorado and the Eagle River Water and Sanitation District have partnered to design, construct, and operate a mechanical “Community Heat Recovery System” which extracts low-grade waste heat from treated wastewater and delivers this heat for beneficial use. Immediate uses include heating of the community swimming pool, melting snow and ice on high pedestrian areas in an urban redevelopment zone in order to improve pedestrian safety, and space heating for project buildings and an adjacent water plant pump station building. Points of use are located within one mile of the treatment plant. The initial system is sized to extract heat from 170 m3/hr (1.08 mgd) of wastewater plant effluent with a 298 kW (400 hp) heat pump. The heat pump will deliver 1,026 kW (3,500,000 BTU/hr) energy to the heat recovery system. A supplemental natural gas boiler provided to meet peak demands will provide an additional 1,026 kW (3,500,000 BTU/hr) energy. The system is expandable allowing the installation of a second heat pump in the future and roof-mounted solar thermal panels. Power for the waste heat recovery system is provided by wind-generated electricity purchased from the local electric utility. The use of wind power with an electric-powered heat pump enables the agencies to fulfill energy needs while also reducing the carbon footprint. The system will achieve a reduction in the temperature of the treated wastewater, which is currently discharged to the Eagle River during low river flow, fish-sensitive periods. The agencies expect to save tax payers and rate payers money as a result of this project as compared to other alternatives or the status quo because it results in a more sustainable long-term operation. At 2008 utility commodities pricing, delivery of heat generated from this system was estimated to cost about one-third less than that from a conventional natural gas boiler system. This facility is the first of its kind in the U.S. and received a “New Energy Community” grant from the State of Colorado. This project shows how local agencies can work cooperatively for mutual benefit to provide infrastructure which accommodates growth and urban renewal and simultaneously demonstrate strong environmental leadership. The potential application of this technology is broad and global. The installed system is expected to cost about $5,000,000; construction will be completed in 2010.


2019 ◽  
Vol 14 (1) ◽  
Author(s):  
Gunabal S

Waste heat recovery systems are used to recover the waste heat in all possible ways. It saves the energy and reduces the man power and materials. Heat pipes have the ability to improve the effectiveness of waste heat recovery system. The present investigation focuses to recover the heat from Heating, Ventilation, and Air Condition system (HVAC) with two different working fluids refrigerant(R410a) and nano refrigerant (R410a+Al2O3). Design of experiment was employed, to fix the number of trials. Fresh air temperature, flow rate of air, filling ratio and volume of nano particles are considered as factors. The effectiveness is considered as response. The results were analyzed using Response Surface Methodology


2021 ◽  
Vol 234 ◽  
pp. 113947
Author(s):  
Alexandre Persuhn Morawski ◽  
Leonardo Rodrigues de Araújo ◽  
Manuel Salazar Schiaffino ◽  
Renan Cristofori de Oliveira ◽  
André Chun ◽  
...  

2012 ◽  
Vol 204-208 ◽  
pp. 4229-4233 ◽  
Author(s):  
Fang Tian Sun ◽  
Na Wang ◽  
Yun Ze Fan ◽  
De Ying Li

Drain water at 35°C was directly discharged into sewer in most of barbershop with Electric water heater. Heat utilization efficiency is lower, and energy grade match between input and output is not appropriate in most of barbershops. Two waste heat recovery systems were presented according to the heat utilization characteristics of barbershops and principle of cascade utilization of energy. One was the waste heat recovery system by water-to-water heat exchanger (WHR-HE), and the other is the waste heat recovery system by water-to-water heat exchanger and high-temperature heat pump (WHR-CHEHP). The two heat recovery systems were analyzed by the first and second Laws of thermodynamic. The analyzed results show that the energy consumption can be reduced about 75% for HR-HE, and about 98% for WHR-CHEHP. Both WHR-HE and WHR-CHEHP are with better energy-saving effect and economic benefits.


Author(s):  
Salman Abdu ◽  
Song Zhou ◽  
Malachy Orji

Highly increased fuel prices and the need for greenhouse emissions reduction from diesel engines used in marine engines in compliance with International Maritime Organization (IMO) on the strict regulations and guidelines for the Energy Efficiency Design Index (EEDI) make diesel engine exhaust gas heat recovery technologies attractive. The recovery and utilization of waste heat not only conserves fuel, but also reduces the amount of waste heat and greenhouse gases dumped to the environment .The present paper deals with the use of exergy as an efficient tool to measure the quantity and quality of energy extracted from waste heat exhaust gases in a marine diesel engine. This analysis is utilized to identify the sources of losses in useful energy within the components of the system for three different configurations of waste heat recovery system considered. The second law efficiency and the exergy destroyed of the components are investigated to show the performance of the system in order to select the most efficient waste heat recovery system. The effects of ambient temperature are also investigated in order to see how the system performance changes with the change of ambient temperature. The results of the analysis show that in all of the three different cases the boiler is the main source of exergy destruction and the site of dominant irreversibility in the whole system it accounts alone for (31-52%) of losses in the system followed by steam turbine and gas turbine each accounting for 13.5-27.5% and 5.5-15% respectively. Case 1 waste heat recovery system has the highest exergetic efficiency and case 3 has the least exergetic efficiency.


Sign in / Sign up

Export Citation Format

Share Document