scholarly journals Strain-Release Arylations for the Bis-Functionalization of Azetidines

Author(s):  
Florian Trauner ◽  
Felix Reiners ◽  
Kodjo-Edmond Apaloo-Messan ◽  
Benedikt Nißl ◽  
Muhammad Shahbaz ◽  
...  

The addition of nucleophilic organometallic species onto in situ generated azabicyclobutanes enables the selective formation of 3-arylated azetidine intermediates through strain-release. Single pot strategies were further developed for the N-arylation of resulting azetidines, employing either SNAr reactions or Buchwald-Hartwig couplings.

2019 ◽  
Vol 123 (17) ◽  
pp. 10967-10973 ◽  
Author(s):  
Dandan Li ◽  
Congcong Wei ◽  
Qiang Wang ◽  
Lin Liu ◽  
Dazhong Zhong ◽  
...  

Molecules ◽  
2021 ◽  
Vol 26 (8) ◽  
pp. 2378
Author(s):  
Paola S. Hellwig ◽  
Jonatan S. Guedes ◽  
Angelita M. Barcellos ◽  
Gelson Perin ◽  
Eder J. Lenardão

We describe herein an alternative transition-metal-free procedure to access 3,4-bis(butylselanyl)selenophenes and the so far unprecedented 3-(butylselanyl)-4-alkoxyselenophenes. The protocol involves the 5-endo-dig electrophilic cyclization of 1,3-diynes promoted by electrophilic organoselenium species, generated in situ through the oxidative cleavage of the Se-Se bond of dibutyl diselenide using Oxone® as a green oxidant. The selective formation of the title products was achieved by controlling the solvent identity and the amount of dibutyl diselenide. By using 4.0 equiv of dibutyl diselenide and acetonitrile as solvent at 80 °C, four examples of 3,4-bis(butylselanyl)selenophenes were obtained in moderate to good yields (40–78%). When 3.0 equiv of dibutyl diselenide were used, in the presence of aliphatic alcohols as solvent/nucleophiles under reflux, 10 3-(butylselanyl)-4-alkoxyselenophenes were selectively obtained in low to good yields (15–80%).


2020 ◽  
Vol 92 (1) ◽  
pp. 49-62 ◽  
Author(s):  
Amin Ismael ◽  
Manabu Abe ◽  
Rui Fausto ◽  
Maria L. S. Cristiano

AbstractThe properties and applications of 2-methyl-(2H)-tetrazole-5-amino-saccharinate (2MTS) in catalysis and chelant-based chemotherapy stimulated investigations on its photostability. The photochemistry of monomeric 2MTS in solid argon (15 K) was compared with those of 2-methyl-(2H)-tetrazole-5-amine (2MT) and 1-methyl-(2H)-tetrazole-5-amine (1MT). Compounds were subjected to in situ narrowband UV-irradiation at different wavelengths. Reactions were followed by infrared spectroscopy, supported by B3LYP/6-311++G(d,p) calculations. Photochemical pathways for 2MT and 2MTS proved similar but photodegradation of 2MTS was 20× slower, unraveling the photostabilizing effect of the saccharyl moiety that extends into the nitrilimine formed from 2MTS and its antiaromatic 1H-diazirene isomer, which proved photostable at 290 nm, unlike the 1H-diazirene formed from 2MT. Analysis of the photochemistries of 2MTS/2MT (250 nm) and 1MT (222 nm), including energy trends calculated for the isomeric C2H5N3 species postulated/observed from photolysis and EPR results, enabled a deeper insight into the photodegradation mechanisms of 1,5-substituted and 2,5-substituted tetrazoles. We postulate a pivotal singlet state imidoylnitrene species, sN1, as common intermediate, which undergoes a Wolff-type isomerization to a stable carbodiimide. Photo-extrusion of N2 from 1,5-substituted tetrazoles generates sN1 directly but from 2,5-substituted tetrazoles it originates a nitrilimine, then a diazirene, which finally leads to sN1. Selective formation of cyanamide from 1MT requires photoisomerization between sN1 and sN2, accessible at 222 nm. EPR studies enabled the detection of methyl nitrene, arising from photolysis of 1H-diazirene intermediate.


2021 ◽  
Author(s):  
Rui-Han Dai ◽  
Lu Han ◽  
Qi Wang ◽  
Shi-Kai Tian

A new strategy has been established for the [2,3]-sigmatropic rearrangement of quaternary allylammonium ylides, generated in situ from tertiary allylamines and a bicyclo[1.1.0]butane via strain-release C-C bond cleavage. A range...


Carbon ◽  
2021 ◽  
Vol 172 ◽  
pp. 296-301 ◽  
Author(s):  
Zhiyu Zou ◽  
Laerte L. Patera ◽  
Giovanni Comelli ◽  
Cristina Africh

1984 ◽  
Vol 75 ◽  
pp. 743-759 ◽  
Author(s):  
Kerry T. Nock

ABSTRACTA mission to rendezvous with the rings of Saturn is studied with regard to science rationale and instrumentation and engineering feasibility and design. Future detailedin situexploration of the rings of Saturn will require spacecraft systems with enormous propulsive capability. NASA is currently studying the critical technologies for just such a system, called Nuclear Electric Propulsion (NEP). Electric propulsion is the only technology which can effectively provide the required total impulse for this demanding mission. Furthermore, the power source must be nuclear because the solar energy reaching Saturn is only 1% of that at the Earth. An important aspect of this mission is the ability of the low thrust propulsion system to continuously boost the spacecraft above the ring plane as it spirals in toward Saturn, thus enabling scientific measurements of ring particles from only a few kilometers.


Sign in / Sign up

Export Citation Format

Share Document