scholarly journals The influence of magnetic field and cathode dimensions on plasma characteristics in hollow cathode system

2018 ◽  
Vol 16 (38) ◽  
pp. 26-34
Author(s):  
Qusay Adnan Abbas

Experimental study on the effect of cylindrical hollow cathode, working pressure and magnetic field on spatial glow distribution and the characteristics of plasma produced by dc discharge in Argon gas, were investigated by image analyses for the plume within the plasma. It was found that the emission intensity appears as a periodic structure with many peaks appeared between the electrodes. Increasing the pressure leads to increase the number of intensity peaks finally converted to continuous form at high pressure, especially with applied of magnetic field, i.e. the plasma is more stable with the presence of magnetic field. The emission intensity study of plasma showed that the intensity has a maximum value at 1.07 mbar pressure and decrease with more pressure.

1972 ◽  
Vol 27 (10) ◽  
pp. 1425-1433 ◽  
Author(s):  
F. Howorka ◽  
M. Pähl

Abstract The negative glow plasma of a cylindrical hollow cathode dc discharge (0.05 - 1 Torr Argon, 1-30 mA) is investigated as to the position of the glow edge, the axial dependence of the cathode current density, the axial and radial potential distributions, the density and energy of electrons (from Langmuir probe measurements) as dependent on pressure, discharge current and position, etc. It is found that two groups of electrons exist whose energies are < 0.5 eV ~ 3 eV and the ratio of their denisties being 3 up to 20. A phenomenological explanation is given for the relatively high denisty of the fast group, The results are compared with those of other auhors concerning hollow-cathode and linear discharges.


2015 ◽  
Vol 834 ◽  
pp. 61-70
Author(s):  
Aleksander Sergeevich Metel ◽  
Sergey Nikolaevich Grigoriev ◽  
Vasilii Petrovich Bolbukov ◽  
Yury Andreevich Melnik

Results of a target sputtering investigation have been obtained, the target being positioned on the bottom of a cylindrical hollow cathode covered by a grid. It was shown that influence on the glow discharge of a nonuniform magnetic field with lines crossing the target center as well as the grid, the hollow cathode and the target periphery, where the field lines are arc-shaped, depends on the magnetic induction on the target edge. Due to ionization by electrons emitted by the cathode and forced by the magnetic field to approach to the target more frequently the plasma density near the target grows up and more than a half of all ions produced in the discharge quite uniformly sputter the target


2021 ◽  
Vol 25 ◽  
pp. 125-130
Author(s):  
S.V. Klad’ko ◽  
◽  
N.P. Poluektov ◽  
I.I. Usatov ◽  
◽  
...  

The effect of magnetic field on plasma characteristics in a magnetron with a hollow cathode was carried out. The magnetic field in this device is of complex geometry, since it consists of many permanent magnets and an electromagnet. The calculated geometries of the magnetic field were used in experimental studies. Measurements have shown that the magnitude and geometry of the magnetic field have a strong effect on the plasma parameters.


1979 ◽  
Vol 40 (C7) ◽  
pp. C7-229-C7-230
Author(s):  
N. N. Rykalin ◽  
A. V. Nikolaev ◽  
A. P. Borzhov

2020 ◽  
Vol 60 (1) ◽  
pp. 015501
Author(s):  
Shoki Abe ◽  
Katsuyuki Takahashi ◽  
Seiji Mukaigawa ◽  
Koichi Takaki ◽  
Ken Yukimura

2006 ◽  
Vol 512 ◽  
pp. 195-200 ◽  
Author(s):  
Nariaki Okamoto ◽  
Takashi Fukuda ◽  
Tomoyuki Kakeshita ◽  
Tetsuya Takeuchi

Ni2MnGa alloy with 10M martensite exhibits rearrangement of martensite variants (RMV) by magnetic field, but Ni2.14Mn0.92Ga0.94 with 2M martensite does not. In order to explain the difference, we measured uniaxial magnetocrystalline anisotropy constant Ku and the stress required for twinning plane movement τreq in these alloys. Concerning the former alloy, the maximum value of magnetic shear stress acting across twinning plane τmag, which is evaluated as |Ku| divided by twinning shear, becomes larger than τr eq. On the other hand, concerning the latter alloy, the maximum of τmag is only one-tenth of τreq at any temperature examined. Obviously, the relation, τmag> τr eq, is satisfied when RMV occurs by magnetic field and vice versa. In this martensite, the large twinning shear of 2M martensite is responsible for small τmag and large τreq.


Author(s):  
Giulia Becatti ◽  
Francesco Burgalassi ◽  
Fabrizio Paganucci ◽  
Matteo Zuin ◽  
Dan M Goebel

Abstract A significant number of plasma instabilities occur in the region just outside of hollow cathodes, depending on the injected gas flow, the current level and the application of an external magnetic field. In particular, the presence of an axial magnetic field induces a helical mode, affecting all the plasma parameters and the total current transported by the plasma. To explore the onset and behavior of this helical mode, the fluctuations in the plasma parameters in the current-carrying plume outside of a hollow cathode discharge have been investigated. The hollow cathode was operated at a current of 25 A, and at variable levels of propellant flow rate and applied magnetic fields. Electromagnetic probes were used to measure the electromagnetic fluctuations, and correlation analysis between each of the probe signals provided spatial-temporal characterization of the generated waves. Time-averaged plasma parameters, such as plasma potential and ion energy distribution function, were also collected in the near-cathode plume region by means of scanning emissive probe and retarding potential analyzer. The results show that the helical mode exists in the cathode plume at sufficiently high applied magnetic field, and is characterized by the presence of a finite electromagnetic component in the axial direction, detectable at discharge currents $\geq$ 25 A. A theoretical analysis of this mode reveals that one possible explanation is consistent with the hypotheses of resistive magnetohydrodynamics, which predicts the presence of helical modes in the forms of resistive kink. The analysis has been carried out by linear perturbation of the resistive MHD equations, from which it is possible to obtain the dispersion relation of the mode and find the $k-\omega$ unstable branch associated with the instability. These findings provided the basis for more detailed investigation of resistive MHD modes and their effect in the plume of hollow cathodes developed for electric propulsion application.


Vacuum ◽  
2019 ◽  
Vol 160 ◽  
pp. 70-74 ◽  
Author(s):  
Jianping Xu ◽  
Xiubo Tian ◽  
Haiqun Qi ◽  
Jiajie Wang ◽  
Chunzhi Gong ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document