Improving the lubricant properties of low-sulfur diesel fuel

2009 ◽  
Vol 29 (10) ◽  
pp. 983-985 ◽  
Author(s):  
A. P. Perekrestov
Keyword(s):  
2013 ◽  
Vol 116 ◽  
pp. 257-264 ◽  
Author(s):  
Mohammad Teymouri ◽  
Abdolraouf Samadi-Maybodi ◽  
Amir Vahid ◽  
Aliakbar Miranbeigi

Author(s):  
Steven G. Fritz ◽  
John C. Hedrick ◽  
Brian E. Smith

This paper documents results from an experimental study performed to determine the effects of several ultra-low sulfur diesel (ULSD) fuels (< 15 ppm S) on exhaust emissions from a 1,500 kW EMD 16-645-E, roots-blown, diesel locomotive engine. U.S. EPA-regulated emission levels of hydrocarbons (HC), carbon monoxide (CO), oxides of nitrogen (NOx), and particulate (PM) were measured using U.S. EPA locomotive test procedures while operating on four ULSD fuels, plus a fifth baseline fuel which was a commercially-available Federal on-highway diesel fuel (< 500 ppm). The four ULSD fuels were (1) a ULSD California motor vehicle diesel fuel (CARB fuel) with an aromatic content of less than 10 percent, (2) a ULSD “equivalent” California motor vehicle diesel fuel with an aromatic content of 24 percent, (3 and 4) two custom blended “2006 ULSD Federal” diesel fuels with relatively low Cetane Numbers and higher aromatic levels. This paper reports the changes observed in the regulated exhaust emission levels between the ULSD CARB diesel fuels and the ULSD Federal diesel fuels.


Fuel ◽  
2011 ◽  
Vol 90 (3) ◽  
pp. 951-957 ◽  
Author(s):  
M. Farahani ◽  
D.J.Y.S. Pagé ◽  
M.P. Turingia

Author(s):  
Fred W. Girshick

Diesel fuel with a maximum of 500 parts per million sulfur became mandatory for United States railroads in June 2007, with another reduction to 15 parts per million expected by 2012. These levels are significantly lower than the pre-2007 level of 5000 parts per million maximum. The use of these fuels will have several effects on locomotive engine operation, some good, some bad, and some merely different. This paper examines the possible effects of lower sulfur diesel fuel on locomotive engine operation, shares experiences from other parts of the world when lower sulfur fuel was introduced, and speculates on possible subsequent changes, including lubricant composition and the use of fuel-borne additives.


Sign in / Sign up

Export Citation Format

Share Document