Plastics Injection Molding

2020 ◽  
Author(s):  
José R. Lerma Valero
Keyword(s):  
Injection Molding ◽  
Plastics Injection Molding

Comparative study of rapid and conventional tooling for plastics injection molding

2017 ◽  
Vol 23 (2) ◽  
pp. 344-352 ◽  
Author(s):  
Gabriel Antonio Mendible ◽  
Jack A. Rulander ◽  
Stephen P. Johnston
Keyword(s):  
Injection Molding ◽  
Lower Cost ◽  
Rapid Tooling ◽  
Content Type ◽  
Part Quality ◽  
Molded Part ◽  
Molded Parts ◽  
Plastics Injection Molding ◽  
Rate Of Cooling ◽  
Manufacturing Techniques

Purpose This study aims to evaluate the performance of injection molding inserts produced via rapid and conventional manufacturing techniques considering the mechanical and thermal performance of the tools as well as the resulting molded part quality. Design/methodology/approach Three insert materials and manufacturing techniques were evaluated, jetted photopolymer (PolyJet) 3D printing using digital ABS, direct metal laser sintering (DMLS) using bronze and machining using stainless steel. Molding trials were performed, and the insert surface temperature, longevity and part properties were evaluated. Complementary information was acquired using computer simulation. Findings Similar behavior and part quality were observed in machined and DMLS inserts. The latter were used for 500 cycles without any signs of failure. PolyJet inserts had increased cycle time and slower rate of cooling which increased shrinkage and crystallinity in the molded parts. PolyJet inserts could be produced quickly at a lower cost than machined or DMLS inserts. Research limitations/implications Cooling within the insert was not studied; inserts were cooled indirectly by the mold plates behind them. Subsequent studies will incorporate cooling lines directly into the inserts. Originality/value Little research has been done to understand the thermal behavior of inserts manufactured via rapid tooling techniques. This study provides a direct comparison between rapid tooling techniques, which is supported by simulation results and analysis of the actual molding properties.

The Applied Study Based on the Injection Molding Mechanism of Microcellular Foamed Plastics (MCFP)

2014 ◽  
Vol 709 ◽  
pp. 374-379
Author(s):  
Yi Jun Huang
Keyword(s):  
Injection Molding ◽  
Engineering Application ◽  
Injection Pressure ◽  
Injection Molding Process ◽  
Injection Time ◽  
Molding Process ◽  
Melt Temperature ◽  
Applied Study ◽  
Foamed Plastics ◽  
Plastics Injection Molding

Injection molding is one of several molding technology of microcellular foamed plastics. This paper mainly discusses the injection molding mechanism and applications of microcellular foamed plastics here, and analyzes the influence of microcellular foamed plastics injection molding process parameters, including injection pressure, melt temperature, injection time, etc.; At the same time, this paper makes a more systematic discussions for the injection molding technology of microcellular foamed plastics, and the typical cases of microcellular foamed plastics in engineering application are introduced in detail.

Sign in / Sign up

Export Citation Format

Share Document