scholarly journals Pore Water Pressure Response Around Pile and its Effects on P-Y behavior During Soil Liquefaction

2004 ◽  
Vol 44 (6) ◽  
pp. 101-110 ◽  
Author(s):  
Kohji Tokimatsu ◽  
Hiroko Suzuki
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Soil Liquefaction ◽  
Pressure Response

Prediction of pore-water pressure response to rainfall using support vector regression

2016 ◽  
Vol 24 (7) ◽  
pp. 1821-1833 ◽  
Author(s):  
Nuraddeen Muhammad Babangida ◽  
Muhammad Raza Ul Mustafa ◽  
Khamaruzaman Wan Yusuf ◽  
Mohamed Hasnain Isa
Keyword(s):  
Support Vector Regression ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Pressure Response ◽  
Support Vector

Prediction of liquefaction potential and pore water pressure beneath machine foundations

2014 ◽  
Vol 4 (3) ◽  
Author(s):  
Mohammed Fattah ◽  
Mohammed Al-Neami ◽  
Nora Jajjawi
Keyword(s):  
Pore Water ◽  
Sandy Soil ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Soil Liquefaction ◽  
Elastic Model ◽  
Liquefaction Resistance ◽  
Overburden Pressure ◽  
Liquefaction Potential ◽  
Frequency Changes

AbstractThe present research is concerned with predicting liquefaction potential and pore water pressure under the dynamic loading on fully saturated sandy soil using the finite element method by QUAKE/W computer program. As a case study, machine foundations on fully saturated sandy soil in different cases of soil densification (loose, medium and dense sand) are analyzed. Harmonic loading is used in a parametric study to investigate the effect of several parameters including: the amplitude frequency of the dynamic load. The equivalent linear elastic model is adopted to model the soil behaviour and eight node isoparametric elements are used to model the soil. Emphasis was made on zones at which liquefaction takes place, the pore water pressure and vertical displacements develop during liquefaction. The results showed that liquefaction and deformation develop fast with the increase of loading amplitude and frequency. Liquefaction zones increase with the increase of load frequency and amplitude. Tracing the propagation of liquefaction zones, one can notice that, liquefaction occurs first near the loading end and then develops faraway. The soil overburden pressure affects the soil liquefaction resistance at large depths. The liquefaction resistance and time for initial liquefaction increase with increasing depths. When the frequency changes from 5 to 10 rad/sec. (approximately from static to dynamic), the response in displacement and pore water pressure is very pronounced. This can be attributed to inertia effects. Further increase of frequency leads to smaller effect on displacement and pore water pressure. When the frequency is low; 5, 10 and 25 rad/sec., the oscillation of the displacement ends within the period of load application 60 sec., while when ω = 50 rad/sec., oscillation continues after this period.

scholarly journals Soil liquefaction as an identification test

2019 ◽  
Vol 92 ◽  
pp. 08008
Author(s):  
Bozana Bacic ◽  
Ivo Herle
Keyword(s):  
Pore Water ◽  
Laboratory Testing ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Initial Density ◽  
Soil Liquefaction ◽  
Triaxial Tests ◽  
Cyclic Triaxial ◽  
Cyclic Triaxial Tests ◽  
Identification Test

Time-consuming and complicated investigations of soil liquefaction in cyclic triaxial tests are the most common way of laboratory analysis of this phenomenon. Moreover, the necessary equipment for the performance of cyclic triaxial tests is very expensive. Much simpler method for laboratory testing of the soil liquefaction has been developed at the Institute of Geotechnical Engineering at the TU Dresden. This method takes into account the pore water pressure build-up during cyclic shearing within a short time period. During the test, the soil sample is subjected to horizontal cyclic loading and the generated pore water pressure is measured. In the first series of these experiments, a dependence of the pore water pressure buildup on the initial density of soil could be observed, as expected. When comparing different soils, it is shown that the tendency to liquefaction depends also on the granulometric properties (e.g. grain size distribution) of the soil. The aim of the further development is to establish a simple identification test for laboratory testing of the soil liquefaction.

Influences on Liquefaction-Induced Damage of Pore Water Seepage into an Unsaturated Surface Layer

2020 ◽  
Vol 15 (6) ◽  
pp. 754-764
Author(s):  
Yohsuke Kawamata ◽  
Hiroshi Nakazawa ◽  
◽  
Keyword(s):  
Surface Layer ◽  
Pore Water ◽  
Groundwater Level ◽  
Water Movement ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Lateral Spreading ◽  
Soil Liquefaction ◽  
Water Seepage ◽  
Long Duration

Various studies have examined soil liquefaction and the resultant structure damage. The 1995 Southern Hyogo Prefecture Earthquake, a near-field earthquake, caused significant damage when the ground was liquified due to the rapidly increased pore water pressure in several cycles of major motions. Therefore, the effect of pore water movement during earthquakes has been assumed to be limited, and liquefaction has mainly been evaluated in undrained conditions. Additionally, the ground and building settlement or inclination caused by liquefaction are deemed to result from pore water drainage after earthquakes. Meanwhile, in the 2011 Tohoku Earthquake, off the Pacific Coast, a subduction-zone earthquake, long-duration motions were observed for over 300 s with frequent aftershocks. Long-duration motions with frequent aftershocks are also anticipated in a future Nankai Trough Earthquake. The effect of pore water movement not only after but during an earthquake should be considered in cases where pore water pressure gradually increases in long-duration motion. The movement of pore water during and after an earthquake typically results in simultaneous dissipation and buildup of water pressure, as well as volumetric changes associated with settlement and lateral spreading. Such effects must reasonably be considered in liquefaction evaluation and building damage prediction. This research focuses on pore water seepage into the unsaturated surface layer caused by the movement of pore water. Seepage experiments were performed based on parameters such as height of test ground, ground surface permeability, and liquefaction duration. In the tests, water pressure when the saturated ground below the groundwater level is fully liquified was applied to the bottom of the specimen representing an unsaturated surface layer. Seepage behaviors into the unsaturated surface layer were then evaluated based on the experiment data. The results show that the water level rises due to pore water seepage from the liquefied ground into the unsaturated surface layer right above the liquefied ground. For this reason, a ground shallower than the original groundwater level can be liquified.

Earthquake-induced deformation analyses of the Upper San Fernando Dam under the 1971 San Fernando Earthquake

2001 ◽  
Vol 38 (1) ◽  
pp. 1-15 ◽  
Author(s):  
Guoxi Wu
Keyword(s):  
Finite Element ◽  
Pore Water ◽  
Effective Stress ◽  
Pore Water Pressure ◽  
Ground Deformation ◽  
Water Pressure ◽  
Soil Liquefaction ◽  
Shear Stresses ◽  
Cyclic Shear ◽  
San Fernando

A nonlinear effective stress finite element approach for dynamic analysis of soil structure is described in the paper. Major features of this approach include the use of a third parameter in the two-parameter hyperbolic stress-strain model, a modified expression for unloading–reloading modulus in the Martin–Finn–Seed pore-water pressure model, and an additional pore-water pressure model based on cyclic shear stress. The additional pore-water pressure model uses the equivalent number of uniform cyclic shear stresses for the assessment of pore-water pressure. Dynamic analyses were then conducted to simulate the seismically induced soil liquefaction and ground deformation of the Upper San Fernando Dam under the 1971 San Fernando Earthquake. The analyses were conducted using the finite element computer program VERSAT. The computed zones of liquefaction and deformation are compared with the measured response and with results obtained by others.Key words: effective stress method, finite element analysis, Upper San Fernando Dam, earthquake deformation, VERSAT.

Soil Liquefaction Assessment by Anisotropic Cyclic Triaxial Test

2018 ◽  
pp. 631-664
Author(s):  
Koray Ulamis
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Axial Strain ◽  
Water Pressure ◽  
Sandy Soils ◽  
Soil Liquefaction ◽  
Cyclic Triaxial ◽  
Loading Case ◽  
Anisotropic Consolidation ◽  
Assessment Standard

Liquefaction of saturated sandy soils is one of the most significant aspects of earthquake triggered natural hazards. The main mechanism deals with the loss of effective stress due to rapid pore water pressure generation during earthquake shaking. This chapter involves with the fundamental mechanism and impacts of liquefaction. Liquefaction susceptibility of geological environments are briefly represented for preliminary assessment. Standard procedures of liquefaction are summarized. The dynamic response of sands are also reviewed. A case of anisotropic loading is considered, using three different particle sized sands below a shallow footing. Such sandy soils are subjected to anisotropic consolidation before performing undrained cyclic triaxial testing along limited cycles. Variation of axial strain, pore water pressure and related parameters are investigated. Main outcome of this study is to review the initial liquefaction state of sands by anisotropic loading case.

Pore Water Pressure Response during Tsunami Loading

2020 ◽  
Vol 146 (3) ◽  
pp. 04020004
Author(s):  
Abbas Abdollahi ◽  
H. Benjamin Mason
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Pressure Response

Pore-Water Pressure Changes during Soil Liquefaction

1976 ◽  
Vol 102 (4) ◽  
pp. 323-346 ◽  
Author(s):  
H. Bolton Seed ◽  
Philippe P. Martin ◽  
John Lysmer
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Soil Liquefaction ◽  
Pressure Changes
Sign in / Sign up

Export Citation Format

Share Document