149. A Study of Effective Protection Factor (EPF) at a Primary Lead Smelter

1999 ◽  
Author(s):  
T. Spear ◽  
J. Bootland ◽  
J. Dumond ◽  
C. Lloyd
2000 ◽  
Vol 15 (2) ◽  
pp. 235-244 ◽  
Author(s):  
Terry M. Spear ◽  
James DuMond ◽  
Carrie Lloyd ◽  
James H. Vincent

Marine Drugs ◽  
2019 ◽  
Vol 17 (1) ◽  
pp. 55 ◽  
Author(s):  
Francisca de la Coba ◽  
José Aguilera ◽  
Nathalie Korbee ◽  
María de Gálvez ◽  
Enrique Herrera-Ceballos ◽  
...  

The safety and stability of synthetic UV-filters and the procedures for evaluating the photoprotective capability of commercial sunscreens are under continuous review. The influence of pH and temperature stressors on the stability of certain Mycosporine-like amino acids (MAAs) isolated at high purity levels was examined. MAAs were highly stable at room temperature during 24 h at pH 4.5–8.5. At 50 °C, MAAs showed instability at pH 10.5 while at 85 °C, progressive disappearances were observed for MAAs through the studied pH range. In alkaline conditions, their degradation was much faster. Mycosporine-serinol and porphyra-334 (+shinorine) were the most stable MAAs under the conditions tested. They were included in four cosmetically stable topical sunscreens, of which the Sun Protection Factor (SPF) and other Biological Effective Protection Factors (BEPFs) were calculated. The formulation containing these MAAs showed similar SPF and UVB-BEPFs values as those of the reference sunscreen, composed of synthetic UV absorbing filters in similar percentages, while UVA-BEPFs values were slightly lower. Current in vitro data strongly suggest that MAAs, as natural and safe UV-absorbing and antioxidant compounds, have high potential for protection against the diverse harmful effects of solar UV radiation. In addition, novel complementary in vitro tests for evaluation of commercial sunscreens efficacy are proposed.


AIHAJ ◽  
1984 ◽  
Vol 45 (10) ◽  
pp. 681-688 ◽  
Author(s):  
W.R. MYERS ◽  
M.J. PEACH ◽  
K. CUTRIGHT ◽  
W. ISKANDER

AIHAJ ◽  
1984 ◽  
Vol 45 (4) ◽  
pp. 236-241 ◽  
Author(s):  
WARREN R. MYERS ◽  
MICHAEL J. PEACH ◽  
JOAN ALLENDER

Author(s):  
W. C. Bigelow ◽  
F. B. Drogosz ◽  
S. Nitschke

High vacuum systems with oil diffusion pumps usually have a pressure switch to protect against Insufficient cooling water; however, If left unattended for long periods of time, failure of the mechanical fore pump can occur with equally serious results. The device shown schematically in Fig. 1 has been found to give effective protection against both these failures, yet it is inexpensive and relatively simple to build and operate.With this system, pressure in the fore pump line is measured by thermocouple vacuum gage TVG (CVC G.TC-004) whose output is monitored by meter relay MRy (Weston 1092 Sensitrol) which is set to close if the pressure rises above about 0.2 torr. This energizes control relay CRy (Potter & Brumfield KA5Y 120VAC SPDT) cutting off power to solenoid-operated fore line valve Vf (Cenco 94280-4 Norm. Closed) which closes to prevent further leakage of air into the diffusion pump


Diabetes ◽  
2020 ◽  
Vol 69 (Supplement 1) ◽  
pp. 1571-P
Author(s):  
BERT B. LITTLE ◽  
ROBERT F. REILLY ◽  
BRAD WALSH

Sign in / Sign up

Export Citation Format

Share Document