scholarly journals A Waste Heat-Driven Cooling System Based on Combined Organic Rankine and Vapour Compression Refrigeration Cycles

2019 ◽  
Vol 9 (20) ◽  
pp. 4242 ◽  
Author(s):  
Youcai Liang ◽  
Zhibin Yu ◽  
Wenguang Li
Keyword(s):  
Power Plant ◽  
Internal Combustion Engines ◽  
Waste Heat ◽  
Cooling System ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Internal Combustion ◽  
Combustion Engines ◽  
Compression Cycle ◽  
Vapour Compression

In this paper, a heat driven cooling system that essentially integrated an organic Rankine cycle power plant with a vapour compression cycle refrigerator was investigated, aiming to provide an alternative to absorption refrigeration systems. The organic Rankine cycle (ORC) subsystem recovered energy from the exhaust gases of internal combustion engines to produce mechanical power. Through a transmission unit, the produced mechanical power was directly used to drive the compressor of the vapour compression cycle system to produce a refrigeration effect. Unlike the bulky vapour absorption cooling system, both the ORC power plant and vapour compression refrigerator could be scaled down to a few kilowatts, opening the possibility for developing a small-scale waste heat-driven cooling system that can be widely applied for waste heat recovery from large internal combustion engines of refrigerated ships, lorries, and trains. In this paper, a model was firstly established to simulate the proposed concept, on the basis of which it was optimized to identify the optimum operation condition. The results showed that the proposed concept is very promising for the development of heat-driven cooling systems for recovering waste heat from internal combustion engines’ exhaust gas.

Waste Heat Recovery From Internal Combustion Engines: Feasibility Study on an Organic Rankine Cycle With Application to the Ohio State EcoCAR PHEV

2012 ◽  
Author(s):  
Philipp Skarke ◽  
Shawn Midlam-Mohler ◽  
Marcello Canova
Keyword(s):  
Heat Recovery ◽  
Hybrid Electric Vehicle ◽  
Waste Heat Recovery ◽  
Internal Combustion Engines ◽  
Waste Heat ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Internal Combustion ◽  
Combustion Engines ◽  
Driving Conditions

This paper presents a feasibility analysis on the application of Organic Rankine Cycles as a Waste Heat Recovery system for automotive internal combustion engines. The analysis is conducted considering the Ohio State University EcoCAR, a student prototype plug-in hybrid electric vehicle, as a case study for preliminary fuel economy evaluation. Starting from a energy-based powertrain simulation model validated on experimental data from the prototype vehicle, a first and second-law analysis was conducted to identify the potential for engine waste heat recovery, considering a variety of driving cycles and assuming the vehicle operating in charge-sustaining (HEV) mode. Then, a quasi-static thermodynamic model of an Organic Rankine Cycle (ORC) was designed, calibrated from data available in literature and optimized to fit the prototype vehicle. Simulations were then carried out to evaluate the amount of energy recovered by the ORC system, considering both urban and highway driving conditions. The results of the simulations show that a simple ORC system is able to recover up to 10% of the engine waste heat on highway driving conditions, corresponding to a potential 7% improvement in fuel consumption, with low penalization of the added weight to the vehicle electric range.

scholarly journals A comprehensive study on waste heat recovery from internal combustion engines using organic Rankine cycle

2013 ◽  
Vol 17 (2) ◽  
pp. 611-624 ◽  
Author(s):  
Mojtaba Tahani ◽  
Saeed Javan ◽  
Mojtaba Biglari
Keyword(s):  
Fuel Consumption ◽  
Heat Recovery ◽  
Waste Heat Recovery ◽  
Internal Combustion Engines ◽  
Waste Heat ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Internal Combustion ◽  
Exhaust Gas ◽  
Combustion Engines

There are a substantial amount of waste heat through exhaust gas and coolant of an Internal Combustion Engine. Organic Rankine cycle is one of the opportunities in Internal Combustion Engines waste heat recovery. In this study, two different configurations of Organic Rankine cycle with the capability of simultaneous waste heat recovery from exhaust gas and coolant of a 12L diesel engine were introduced: Preheat configuration and Two-stage. First, a parametric optimization process was performed for both configurations considering R-134a, R-123, and R-245fa as the cycle working fluids. The main objective in optimization process was maximization of the power generation and cycle thermal efficiency. Expander inlet pressure and preheating temperature were selected as design parameters. Finally, parameters like hybrid generated power and reduction of fuel consumption were studied for both configurations in different engine speeds and full engine load. It was observed that using R-123 as the working fluid, the best performance in both configurations was obtained and as a result the 11.73% and 13.56% reduction in fuel consumption for both preheat and Two-stage configurations were found respectively.

Sign in / Sign up

Export Citation Format

Share Document