Moisture content of a piece of sawn timber

Keyword(s):  
2018 ◽  
Vol 168 ◽  
pp. 06004
Author(s):  
Ladislav Dzurenda

The effect of moisture content of black locust wood on the heating of sawn timber with the thickness of h = 32 mm in saturated water steam during the processes of colour modifications by modes: mode I – temperature of saturated water steam t = 112 ± 2.5 °C for τ = 5.5 hours, mode II – temperature of saturated water steam t = 127 ± 2.5 °C for τ = 6.5 hours, and mode III – temperature of saturated water steam t = 137 ± 2.5 °C for τ = 7.5 hours is analysed in the paper. The increase in moisture content affects the heating time, it lasts longer. When the moisture content of black locust wood ranges from W = 60 – 65 %, the heating time by modes I – III did not last longer than the time Δτ ≤ 0.5 min. and no negative impact on the final colour modification is observed.


2021 ◽  
pp. 97-110
Author(s):  
Goran Milic

The subject of this paper is the analysis of moisture content (MC) changes of beech and ash wood during two years in room conditions (heating during winter; no air conditioning during summer). The registered MC changes are primarily the result of changes in relative humidity of the air (measured by capacitive probes). The average relative humidity of the air in the interior is lower today than in the past, as also shown in this experiment (the average relative humidity of air during two years was 44%). The lowest wood MC was reached on very cold winter days when the heating was on even during the night - between 5% and 6%, and the highest one at the beginning of June: 10.4-10.9%. As expected, the wood did not reach equilibrium moisture content - during winter, MC is by about 1% higher, and in summer it is lower by up to 2.5% than the equilibrium. The recommendation that the sawn timber from which the interior products will be made should be dried at 7-8% MC was confirmed.


2014 ◽  
Vol 67 ◽  
pp. 66-74 ◽  
Author(s):  
T. Pranamornkith ◽  
M.K.D. Hall ◽  
A.R. Adlam ◽  
K.G. Somerfield ◽  
B.B.C. Page ◽  
...  

Ethanedinitrile (EDN syn cyanogen EDN Fumigas) is a relatively new fumigant with the potential to disinfest quarantine pests from radiata pine (Pinus radiata D Don) logs and sawn timber for export This research evaluated the effects of dose (20 g/m3 or 50 g/m3) timber moisture content (green or kiln dried sawn timber) endgrain sealing (sealed or unsealed timber endgrain) and load factor (11 or 44) on sorption of EDN fumigation chambers Chamber loading significantly influenced sorption with higher loading resulting in greater sorption Changes in the dose of EDN did not affect the sorption pattern Increased moisture content and endgrain sealing both reduced sorption but these effects were relatively small and the differences in sorption patterns caused by moisture content or endgrain sealing decreased over time


2003 ◽  
Vol 49 (4) ◽  
pp. 312-316 ◽  
Author(s):  
Jan Johansson ◽  
Olle Hagman ◽  
Bengt-Arne Fjellner

Sign in / Sign up

Export Citation Format

Share Document