Grain-oriented electrical steel strip and sheet delivered in the fully processed state

2014 ◽  
Keyword(s):  
Electrical Steel ◽  
Steel Strip

Effect of Hot-Rolled Microstructure on the Recrystallization Texture of Cold-Rolled Non-Oriented Electrical Steel

2011 ◽  
Vol 298 ◽  
pp. 203-208 ◽  
Author(s):  
Zi Li Jin ◽  
Wei Li ◽  
Yi Ming Li
Keyword(s):  
Cold Rolling ◽  
Electrical Steel ◽  
Texture Evolution ◽  
Steel Strip ◽  
Silicon Steel ◽  
Grain Structure ◽  
Recrystallization Annealing ◽  
Rolled Sheet ◽  
Cold Rolled ◽  
Hot Rolled

With the help of orientation distribution function (ODF) analysis, experiments of different hot band grain microstructure 0.33% silicon steel were cold-rolled and annealed in the laboratory，to study the effect of the microstructure hot-rolled steel strip for cold rolled non-oriented silicon steel microstructure and texture of recrystallization annealing. The results show that hot rolled microstructure on cold rolled Non-Oriented Electrical Steel cold-rolled sheet evolution of texture and recrystallization have important influence, the quiaxed grain structure of steel by cold rolling and recrystallization annealing, the recrystallization speed than the fiber grain-based mixed crystals recrystallization fast , With the equiaxed grains made of cold rolled silicon steel after annealing the {110}<UVW> texture components was enhanced and {100}<uwv> texture components weakened. Different microstructure condition prior to cold rolling in the recrystallization annealing process the texture evolution has the obvious difference, the equiaxial grain steel belt cold rolling and annealing, has the strong crystal orientation. This shows that the equiaxed grain when hot microstructure is detrimental to the magnetic properties of cold-rolled non-oriented silicon steel to improve and increase.

Mechanism of Grain Growth During Annealing of Si-Al Electrical Steel Strips Deformed in Tension

2010 ◽  
Vol 1276 ◽  
Author(s):  
J. Salinas B ◽  
A. Salinas R
Keyword(s):  
Grain Size ◽  
Grain Growth ◽  
Electrical Steel ◽  
Electron Backscatter Diffraction ◽  
Steel Strip ◽  
Boundary Migration ◽  
Primary Recrystallization ◽  
Steel Strips ◽  
Grain Orientation Spread ◽  
Quality Maps

AbstractThe mechanism of recrystallization as a result of annealing during 600–7200 seconds at 700 °C of a Si-Al, low C electrical steel strip is investigated in samples deformed in tension. The evolution of grain size during annealing is evaluated by optical microscopy and electron backscatter diffraction in the scanning electron microscope. It is found that grain growth starts after an incubation time of 600 s with no apparent evidence of primary recrystallization. After that, the grain size-time relationship exhibits two different stages. Initially, the grain size increases linearly with time up to about 3600 s. During this time, some selected grains grow until they consume the deformed microstructure. In the second stage, the rate of growth decreases significantly and a final grain size of about 150 m is reached after 7200 seconds of annealing. Grain orientation spread maps obtained from EBSD data of deformed and partially recrystallized samples during the stage of linear growth reveals that the growing grains exhibit lower misorientation and therefore smaller stored energy than the non-recrystallized matrix grains. Analysis of image quality maps reveal that the IQ values for {100}<uvw>orientations are higher than those observed for {111}<uvw>orientations thus suggesting that the {100}<uvw>orientations grow at the expense of {111}<uvw>orientations by a mechanism of strain-induced boundary migration.

Anticorrosion protection for electrical steel strip

Metallurgist ◽  
1979 ◽  
Vol 23 (9) ◽  
pp. 639-640
Author(s):  
A. K. Solovkov ◽  
G. S. Bykovskii ◽  
L. N. Voinikonis ◽  
V. A. Alekseev ◽  
A. N. Tsatsina ◽  
...  
Keyword(s):  
Electrical Steel ◽  
Steel Strip ◽  
Anticorrosion Protection

Potentials of the Rotary Cutting Process for Electrical Steel Strip

2018 ◽  
Author(s):  
M. Ziegler ◽  
M. Schneider ◽  
M. Hubert ◽  
J. Franke
Keyword(s):  
Electrical Steel ◽  
Steel Strip ◽  
Cutting Process ◽  
Rotary Cutting

The Effects of High-Speed Steel Roll and Lubrication on Work Roll Wear and Fatigue During Electrical Steel Strip Hot Rolling

2020 ◽  
Vol 20 (2) ◽  
pp. 432-437
Author(s):  
Qiang Dong ◽  
Jianshui Zhang ◽  
Huahan Liu
Keyword(s):  
Hot Rolling ◽  
High Speed ◽  
Electrical Steel ◽  
Steel Strip ◽  
High Speed Steel ◽  
Work Roll ◽  
Steel Roll ◽  
Roll Wear

A test method for the determination of the cyclic material properties of electrical steel strip under strain-controlled loading

2019 ◽  
Vol 61 (11) ◽  
pp. 1045-1049
Author(s):  
Markus Thum ◽  
Peter Haefele
Keyword(s):  
Material Properties ◽  
Electrical Steel ◽  
Steel Strip ◽  
Test Method
Sign in / Sign up

Export Citation Format

Share Document