Combination of Seismic Refraction and Marine Surface Wave to Characterize Near Surface Marine Sediments

2014 ◽  
Author(s):  
E. Mouton ◽  
D. Robert
Keyword(s):  
Surface Wave ◽  
Marine Sediments ◽  
Seismic Refraction ◽  
Near Surface ◽  
Marine Surface

scholarly journals Geophysical investigations for stability and safety mitigation of regional crude-oil pipeline near abandoned coal mines

2021 ◽  
Vol 18 (1) ◽  
pp. 145-162
Author(s):  
B Butchibabu ◽  
Prosanta Kumar Khan ◽  
P C Jha
Keyword(s):  
High Resolution ◽  
Crude Oil ◽  
Seismic Refraction ◽  
High Resolution Imaging ◽  
Weak Zone ◽  
Near Surface ◽  
Oil Pipeline ◽  
Refraction Tomography ◽  
Geophysical Investigations ◽  
Resolution Imaging

Abstract This study aims for the protection of a crude-oil pipeline, buried at a shallow depth, against a probable environmental hazard and pilferage. Both surface and borehole geophysical techniques such as electrical resistivity tomography (ERT), ground penetrating radar (GPR), surface seismic refraction tomography (SRT), cross-hole seismic tomography (CST) and cross-hole seismic profiling (CSP) were used to map the vulnerable zones. Data were acquired using ERT, GPR and SRT along the pipeline for a length of 750 m, and across the pipeline for a length of 4096 m (over 16 profiles of ERT and SRT with a separation of 50 m) for high-resolution imaging of the near-surface features. Borehole techniques, based on six CSP and three CST, were carried out at potentially vulnerable locations up to a depth of 30 m to complement the surface mapping with high-resolution imaging of deeper features. The ERT results revealed the presence of voids or cavities below the pipeline. A major weak zone was identified at the central part of the study area extending significantly deep into the subsurface. CSP and CST results also confirmed the presence of weak zones below the pipeline. The integrated geophysical investigations helped to detect the old workings and a deformation zone in the overburden. These features near the pipeline produced instability leading to deformation in the overburden, and led to subsidence in close vicinity of the concerned area. The area for imminent subsidence, proposed based on the results of the present comprehensive geophysical investigations, was found critical for the pipeline.

DISPERSION IN SEISMIC SURFACE WAVES

Geophysics ◽  
1951 ◽  
Vol 16 (1) ◽  
pp. 63-80 ◽  
Author(s):  
Milton B. Dobrin
Keyword(s):  
Surface Waves ◽  
Water Waves ◽  
Seismic Refraction ◽  
Wave Theory ◽  
Wave Dispersion ◽  
Surface Zone ◽  
Surface Wave Dispersion ◽  
Near Surface ◽  
Arrival Times ◽  
Ground Roll

A non‐mathematical summary is presented of the published theories and observations on dispersion, i.e., variation of velocity with frequency, in surface waves from earthquakes and in waterborne waves from shallow‐water explosions. Two further instances are cited in which dispersion theory has been used in analyzing seismic data. In the seismic refraction survey of Bikini Atoll, information on the first 400 feet of sediments below the lagoon bottom could not be obtained from ground wave first arrival times because shot‐detector distances were too great. Dispersion in the water waves, however, gave data on speed variations in the bottom sediments which made possible inferences on the recent geological history of the atoll. Recent systematic observations on ground roll from explosions in shot holes have shown dispersion in the surface waves which is similar in many ways to that observed in Rayleigh waves from distant earthquakes. Classical wave theory attributes Rayleigh wave dispersion to the modification of the waves by a surface layer. In the case of earthquakes, this layer is the earth’s crust. In the case of waves from shot‐holes, it is the low‐speed weathered zone. A comparison of observed ground roll dispersion with theory shows qualitative agreement, but it brings out discrepancies attributable to the fact that neither the theory for liquids nor for conventional solids applies exactly to unconsolidated near‐surface rocks. Additional experimental and theoretical study of this type of surface wave dispersion may provide useful information on the properties of the surface zone and add to our knowledge of the mechanism by which ground roll is generated in seismic shooting.

scholarly journals Mapping the Distribution of Buried Glacier Ice – An Example From Lago Delle Locce, Monte Rosa, Italian Alps

1986 ◽  
Vol 8 ◽  
pp. 78-81 ◽  
Author(s):  
W. Haeberli ◽  
F. Epifani
Keyword(s):  
Snow Cover ◽  
Seismic Refraction ◽  
Italian Alps ◽  
Frozen Ground ◽  
Near Surface ◽  
Winter Snow ◽  
Glacier Ice ◽  
Geoelectrical Resistivity ◽  
Monte Rosa

Techniques for mapping the distribution of buried glacier ice are discussed and the results, from a study carried out within the framework of flood protection work in the Italian Alps, are presented. Bottom temperatures of the winter snow cover (BTS) primarily indicate the heat flow conditions in the underlying ground and mainly depend on the presence or absence of an ice layer beneath the surface. Determination of BTS values is therefore an inexpensive method for quickly mapping the near-surface underground ice in areas where there is 1 m or more of winter snow cover. At greater depths, and/or when more detail is required, geoelectrical resistivity soundings and seismic refraction soundings are most commonly used to investigate underground ice. A combination of the two sounding techniques allows the vertical extent and the main characteristics (frozen ground, dead glacier ice) to be determined in at least a semi-quantitative way. Complications mainly arise from irregularity in the horizontal extension of the studied underground ice bodies, and they may have to be overcome by expensive core drillings and borehole measurements. Widespread occurrence of buried glacier ice was observed in morainic deposits, surrounding an ice-dammed lake near Macugnaga, Italy.

Tunnel detection at Yuma Proving Ground, Arizona, USA — Part 1: 2D full-waveform inversion experiment

Geophysics ◽  
2019 ◽  
Vol 84 (1) ◽  
pp. B95-B105 ◽  
Author(s):  
Yao Wang ◽  
Richard D. Miller ◽  
Shelby L. Peterie ◽  
Steven D. Sloan ◽  
Mark L. Moran ◽  
...  
Keyword(s):  
Surface Wave ◽  
Waveform Inversion ◽  
Velocity Profiles ◽  
Infinite Length ◽  
Full Waveform Inversion ◽  
S Wave ◽  
Near Surface ◽  
Tunnel Detection ◽  
Full Waveform ◽  
Wave Methods

We have applied time domain 2D full-waveform inversion (FWI) to detect a known 10 m deep wood-framed tunnel at Yuma Proving Ground, Arizona. The acquired seismic data consist of a series of 2D survey lines that are perpendicular to the long axis of the tunnel. With the use of an initial model estimated from surface wave methods, a void-detection-oriented FWI workflow was applied. A straightforward [Formula: see text] quotient masking method was used to reduce the inversion artifacts and improve confidence in identifying anomalies that possess a high [Formula: see text] ratio. Using near-surface FWI, [Formula: see text] and [Formula: see text] velocity profiles were obtained with void anomalies that are easily interpreted. The inverted velocity profiles depict the tunnel as a low-velocity anomaly at the correct location and depth. A comparison of the observed and simulated waveforms demonstrates the reliability of inverted models. Because the known tunnel has a uniform shape and for our purposes an infinite length, we apply 1D interpolation to the inverted [Formula: see text] profiles to generate a pseudo 3D (2.5D) volume. Based on this research, we conclude the following: (1) FWI is effective in near-surface tunnel detection when high resolution is necessary. (2) Surface-wave methods can provide accurate initial S-wave velocity [Formula: see text] models for near-surface 2D FWI.

Effects of near-surface waveguides on shallow high-resolution seismic refraction and reflection data

1996 ◽  
Vol 23 (5) ◽  
pp. 495-498 ◽  
Author(s):  
J. O. A. Robertsson ◽  
K. Holliger ◽  
A. G. Green ◽  
A. Pugin ◽  
R. De Iaco
Keyword(s):  
High Resolution ◽  
Seismic Refraction ◽  
Near Surface ◽  
Reflection Data

Near‐surface VSstructure by inversion of surface wave estimated from ambient seismic noise

2015 ◽  
Vol 13 (5) ◽  
pp. 447-455 ◽  
Author(s):  
Taghi Shirzad ◽  
Z. Hossein Shomali ◽  
Mojtaba Naghavi ◽  
Rahim Norouzi
Keyword(s):  
Surface Wave ◽  
Seismic Noise ◽  
Ambient Seismic Noise ◽  
Near Surface

3D elastic full-waveform inversion of surface waves in the presence of irregular topography using an envelope-based misfit function

Geophysics ◽  
2018 ◽  
Vol 83 (1) ◽  
pp. R1-R11 ◽  
Author(s):  
Dmitry Borisov ◽  
Ryan Modrak ◽  
Fuchun Gao ◽  
Jeroen Tromp
Keyword(s):  
Surface Wave ◽  
Objective Function ◽  
Surface Waves ◽  
Large Scale ◽  
Body Wave ◽  
Waveform Inversion ◽  
Full Waveform Inversion ◽  
S Wave ◽  
Near Surface ◽  
Full Waveform

Full-waveform inversion (FWI) is a powerful method for estimating the earth’s material properties. We demonstrate that surface-wave-driven FWI is well-suited to recovering near-surface structures and effective at providing S-wave speed starting models for use in conventional body-wave FWI. Using a synthetic example based on the SEG Advanced Modeling phase II foothills model, we started with an envelope-based objective function to invert for shallow large-scale heterogeneities. Then we used a waveform-difference objective function to obtain a higher-resolution model. To accurately model surface waves in the presence of complex tomography, we used a spectral-element wave-propagation solver. Envelope misfit functions are found to be effective at minimizing cycle-skipping issues in surface-wave inversions, and surface waves themselves are found to be useful for constraining complex near-surface features.

Sign in / Sign up

Export Citation Format

Share Document