scholarly journals Mapping the Distribution of Buried Glacier Ice – An Example From Lago Delle Locce, Monte Rosa, Italian Alps

1986 ◽  
Vol 8 ◽  
pp. 78-81 ◽  
Author(s):  
W. Haeberli ◽  
F. Epifani

Techniques for mapping the distribution of buried glacier ice are discussed and the results, from a study carried out within the framework of flood protection work in the Italian Alps, are presented. Bottom temperatures of the winter snow cover (BTS) primarily indicate the heat flow conditions in the underlying ground and mainly depend on the presence or absence of an ice layer beneath the surface. Determination of BTS values is therefore an inexpensive method for quickly mapping the near-surface underground ice in areas where there is 1 m or more of winter snow cover. At greater depths, and/or when more detail is required, geoelectrical resistivity soundings and seismic refraction soundings are most commonly used to investigate underground ice. A combination of the two sounding techniques allows the vertical extent and the main characteristics (frozen ground, dead glacier ice) to be determined in at least a semi-quantitative way. Complications mainly arise from irregularity in the horizontal extension of the studied underground ice bodies, and they may have to be overcome by expensive core drillings and borehole measurements. Widespread occurrence of buried glacier ice was observed in morainic deposits, surrounding an ice-dammed lake near Macugnaga, Italy.

1986 ◽  
Vol 8 ◽  
pp. 78-81 ◽  
Author(s):  
W. Haeberli ◽  
F. Epifani

Techniques for mapping the distribution of buried glacier ice are discussed and the results, from a study carried out within the framework of flood protection work in the Italian Alps, are presented. Bottom temperatures of the winter snow cover (BTS) primarily indicate the heat flow conditions in the underlying ground and mainly depend on the presence or absence of an ice layer beneath the surface. Determination of BTS values is therefore an inexpensive method for quickly mapping the near-surface underground ice in areas where there is 1 m or more of winter snow cover. At greater depths, and/or when more detail is required, geoelectrical resistivity soundings and seismic refraction soundings are most commonly used to investigate underground ice. A combination of the two sounding techniques allows the vertical extent and the main characteristics (frozen ground, dead glacier ice) to be determined in at least a semi-quantitative way. Complications mainly arise from irregularity in the horizontal extension of the studied underground ice bodies, and they may have to be overcome by expensive core drillings and borehole measurements. Widespread occurrence of buried glacier ice was observed in morainic deposits, surrounding an ice-dammed lake near Macugnaga, Italy.


2021 ◽  
Vol 13 (11) ◽  
pp. 2045
Author(s):  
Anaí Caparó Bellido ◽  
Bradley C. Rundquist

Snow cover is an important variable in both climatological and hydrological studies because of its relationship to environmental energy and mass flux. However, variability in snow cover can confound satellite-based efforts to monitor vegetation phenology. This research explores the utility of the PhenoCam Network cameras to estimate Fractional Snow Cover (FSC) in grassland. The goal is to operationalize FSC estimates from PhenoCams to inform and improve the satellite-based determination of phenological metrics. The study site is the Oakville Prairie Biological Field Station, located near Grand Forks, North Dakota. We developed a semi-automated process to estimate FSC from PhenoCam images through Python coding. Compared with previous research employing RGB images only, our use of the monochrome RGB + NIR (near-infrared) reduced pixel misclassification and increased accuracy. The results had an average RMSE of less than 8% FSC compared to visual estimates. Our pixel-based accuracy assessment showed that the overall accuracy of the images selected for validation was 92%. This is a promising outcome, although not every PhenoCam Network system has NIR capability.


1977 ◽  
Vol 14 (3) ◽  
pp. 431-443 ◽  
Author(s):  
Maurice K.-Seguin

The various parameters used to predict on a regional scale the lateral and vertical extension of permafrost are the following: surface temperature, thermal conductivity of rocks, and geothermal flow configuration. Locally this type of data is generally not sufficient and far too inaccurate. The use of geophysical methods at the surface and in boreholes in addition to existing thermal data helps to improve the degree of accuracy in the prediction of spatial distribution of permafrost in a given area. These geophysical methods include seismic refraction, electrical resistivity, and spontaneous and induced polarizations.Because of the properties of permafrost, seismic refraction at surface is useful only to determine the top of the permafrost whereas electrical resistivity (electric logging near surface) allows the determination of the upper and lower limits of permafrost. Seismic refraction, resistivity, and spontaneous and induced polarizations in boreholes were deemed more promising to determine masses or lenses of permafrost.Moreover, it was possible to correlate temperature and electrical resistivity measurements in boreholes, thus allowing the drawing of isothermal curves from electric logging in areas of continuous and discontinuous permafrost, at least when it is 'marginal'.The data for this study were obtained from the experimental station at Schefferville, Québec. [Journal Translation]


2016 ◽  
Vol 37 (2) ◽  
pp. 193-218 ◽  
Author(s):  
Michał Laska ◽  
Bartłomiej Luks ◽  
Tomasz Budzik

AbstractThis paper presents a detailed study of melting processes conducted on Hansbreen – a tidewater glacier terminating in the Hornsund fjord, Spitsbergen. The fieldwork was carried out from April to July 2010. The study included observations of meltwater distribution within snow profiles in different locations and determination of its penetration time to the glacier ice surface. In addition, the variability of the snow temperature and heat transfer within the snow cover were measured. The main objective concerns the impact of meltwater on the diversity of physical characteristics of the snow cover and its melting dynamics. The obtained results indicate a time delay between the beginning of the melting processes and meltwater reaching the ice surface. The time necessary for meltwater to percolate through the entire snowpack in both, the ablation zone and the equilibrium line zone amounted toc.12 days, despite a much greater snow depth at the upper site. An elongated retention of meltwater in the lower part of the glacier was caused by a higher amount of icy layers (ice formationsandmelt-freeze crusts), resulting from winter thaws, which delayed water penetration. For this reason, a reconstruction ofrain-on-snowevents was carried out. Such results give new insight into the processes of the reactivation of the glacier drainage system and the release of freshwater into the sea after the winter period.


2021 ◽  
Vol 18 (1) ◽  
pp. 145-162
Author(s):  
B Butchibabu ◽  
Prosanta Kumar Khan ◽  
P C Jha

Abstract This study aims for the protection of a crude-oil pipeline, buried at a shallow depth, against a probable environmental hazard and pilferage. Both surface and borehole geophysical techniques such as electrical resistivity tomography (ERT), ground penetrating radar (GPR), surface seismic refraction tomography (SRT), cross-hole seismic tomography (CST) and cross-hole seismic profiling (CSP) were used to map the vulnerable zones. Data were acquired using ERT, GPR and SRT along the pipeline for a length of 750 m, and across the pipeline for a length of 4096 m (over 16 profiles of ERT and SRT with a separation of 50 m) for high-resolution imaging of the near-surface features. Borehole techniques, based on six CSP and three CST, were carried out at potentially vulnerable locations up to a depth of 30 m to complement the surface mapping with high-resolution imaging of deeper features. The ERT results revealed the presence of voids or cavities below the pipeline. A major weak zone was identified at the central part of the study area extending significantly deep into the subsurface. CSP and CST results also confirmed the presence of weak zones below the pipeline. The integrated geophysical investigations helped to detect the old workings and a deformation zone in the overburden. These features near the pipeline produced instability leading to deformation in the overburden, and led to subsidence in close vicinity of the concerned area. The area for imminent subsidence, proposed based on the results of the present comprehensive geophysical investigations, was found critical for the pipeline.


1998 ◽  
Vol 35 (2) ◽  
pp. 234-250 ◽  
Author(s):  
JF (Derick) Nixon ◽  
Nick Holl

A geothermal model is described that simulates simultaneous deposition, freezing, and thawing of mine tailings or sequentially placed layers of embankment soil. When layers of soil or mine tailings are placed during winter subfreezing conditions, frozen layers are formed in the soil profile that may persist with time. The following summer, warmer soil placement may not be sufficient to thaw out layers from the preceding winter. Remnant frozen soil layers may persist for many years or decades. The analysis is unique, as it involves a moving upper boundary and different surface snow cover functions applied in winter time. The model is calibrated based on two uranium mines in northern Saskatchewan. The Rabbit Lake scenario involves tailings growth to a height of 120 m over a period of 24 years. At Key Lake, tailings increase in height at a rate of 1.3 m/year. Good agreement between the observed position of frozen layers and those predicted by the model is obtained. Long-term predictions indicate that from 80 to 200 years would be required to thaw out the frozen layers formed during placement, assuming 1992 placement conditions continue. Deposition rates of 1.5-3 m/year give the largest amounts of frozen ground. The amount of frozen ground is sensitive to the assumed snow cover function during winter.Key words: geothermal, model, tailings, freezing, deposition.


Geophysics ◽  
1951 ◽  
Vol 16 (1) ◽  
pp. 63-80 ◽  
Author(s):  
Milton B. Dobrin

A non‐mathematical summary is presented of the published theories and observations on dispersion, i.e., variation of velocity with frequency, in surface waves from earthquakes and in waterborne waves from shallow‐water explosions. Two further instances are cited in which dispersion theory has been used in analyzing seismic data. In the seismic refraction survey of Bikini Atoll, information on the first 400 feet of sediments below the lagoon bottom could not be obtained from ground wave first arrival times because shot‐detector distances were too great. Dispersion in the water waves, however, gave data on speed variations in the bottom sediments which made possible inferences on the recent geological history of the atoll. Recent systematic observations on ground roll from explosions in shot holes have shown dispersion in the surface waves which is similar in many ways to that observed in Rayleigh waves from distant earthquakes. Classical wave theory attributes Rayleigh wave dispersion to the modification of the waves by a surface layer. In the case of earthquakes, this layer is the earth’s crust. In the case of waves from shot‐holes, it is the low‐speed weathered zone. A comparison of observed ground roll dispersion with theory shows qualitative agreement, but it brings out discrepancies attributable to the fact that neither the theory for liquids nor for conventional solids applies exactly to unconsolidated near‐surface rocks. Additional experimental and theoretical study of this type of surface wave dispersion may provide useful information on the properties of the surface zone and add to our knowledge of the mechanism by which ground roll is generated in seismic shooting.


Sign in / Sign up

Export Citation Format

Share Document