Analysis on Surface Displacement Caused by Groundwater Seepage of Shield-Tunneling

2012 ◽  
Vol 170-173 ◽  
pp. 1740-1743
Author(s):  
Hai Xia Sun ◽  
Hai Jun Sang ◽  
Hai Yu Wu
Keyword(s):  
Pore Water Pressure ◽  
Water Pressure ◽  
Surface Displacement ◽  
Tunnel Engineering ◽  
Shield Tunneling ◽  
Seepage Field ◽  
Simulation Data ◽  
Groundwater Seepage ◽  
Set Up ◽  
Pressure Changes

Seepage is one of the unfavorable factors inducing construction accident. It is essential to analyze the influence to the displacement from seepage by the variety of the parameter of seepage. Set up simulation model by software Abaqus. This text studied the law on the displacement of groundwater during construction considering the influence of groundwater seepage, and contrasted the simulation data with groundwater and without groundwater. The pore water pressure changes because of the influence to seepage field from excavation. the displacement curves head for the same on different porosity. The settlement increase and the swell decrease with the addition of porosity. It is obvious that the displacement with groundwater is lager than without groundwater. A suggestion is made that the tunnel engineering should be designed with considering the influence of groundwater.

scholarly journals Experimental Study on the Failure Mechanism of Tunnel Surrounding Rock under Different Groundwater Seepage Paths

Geofluids ◽  
2021 ◽  
Vol 2021 ◽  
pp. 1-17
Author(s):  
Yingchao Wang ◽  
Yang Liu ◽  
Yongliang Li ◽  
Wen Jiang ◽  
Yueming Wang
Keyword(s):  
Failure Mechanism ◽  
Water Flow ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Water Flow Rate ◽  
Surrounding Rock ◽  
Tunnel Engineering ◽  
Measuring Point ◽  
Groundwater Seepage

The influence of groundwater on tunnel engineering is very complicated. Due to the complexity of water flow water pressure transfer and uncertain defects in the stratum, all of which are key factors with regard to the design of tunnel engineering. Therefore, the variation of surrounding rock during excavation and the deformation and failure of soft surrounding rock under different seepage paths of underground water after excavation systematically. Experimental results showed that the stress change of surrounding rock caused by tunnel excavation can be divided into 3 stages: stress redistribution, stress adjustment, and stress rebalancing. In the process of water pressure loading, water flow rate is closely related to the experimental phenomenon. The between stable loading water pressure pore water pressure of the tunnel surrounding rock and the distance from the measuring point to the edge of the tunnel obey the exponential function of the decreasing growth gradient. With the increase of loading pressure, the pore water pressure and stress at the top of the tunnel increase, and the coupling of stress field and seepage field on both sides of surrounding rock more and more intense. The failure process of the tunnel can be divided into 6 stages according to the damage degree. The final failure pattern of the surrounding rock of the tunnel is mainly determined by the disturbed area of excavation. The arched failure area and the collapse-through failure area are composed of three regions. The surrounding rock is characterized by a dynamic pressure arch in the process of seepage failure, but it is more prone to collapse failure at low water pressure. The results of this study are the progressive failure mechanism of tunnel under different groundwater seepage paths and would be of great significance to the prevention of long-range disasters.

scholarly journals Numerical Simulation on the Whole Sinking Process of Open Caisson with an Improved SPH Method

2021 ◽  
Vol 2021 ◽  
pp. 1-9
Author(s):  
Jiahe Zhang
Keyword(s):  
Pore Water Pressure ◽  
Water Pressure ◽  
Dynamic Change ◽  
Soil Pressure ◽  
Shield Tunneling ◽  
Material Interfaces ◽  
Engineering Problems ◽  
Domain Truncation ◽  
Particle Hydrodynamics ◽  
Sph Simulation

The phenomena of dynamic change in the material interfaces and mechanical properties are often involved in the caisson construction. Using conventional methods to simulate these phenomena is quite difficult due to the extremely large deformation. In this study, we proposed an improved soil-water-caisson interaction algorithm with the method of smoothed-particle hydrodynamics (SPH). This algorithm dealt with the support domain truncation of the particles near the blade and applied δ − SPH to avoid the pressure fluctuation. Meanwhile, the application of dynamic particles birth and death method could simulate the whole sinking process of an open caisson with underwater soil excavation. According to the comparison between SPH simulation and centrifuge test, the distribution of sidewall effective soil pressure was consistent, which indicated promising applicability of the algorithm. It should be noted that the considerable excess pore water pressure appeared in the surrounding soil under the blade. With the dissipation of the pressure over time, the effective soil stress increased correspondingly, and it would lead to the increasing difficulty of the sinking process. Therefore, the caisson should be avoided to stop for a long time during the sinking process or it would cause the stagnation of sinking. This algorithm could simulate engineering problems involving underwater construction effectively and provide theoretical and technical support for underwater excavation, shield tunneling, and other engineering problems.

Infiltration characteristics of two instrumented residual soil slopes

2003 ◽  
Vol 40 (5) ◽  
pp. 1012-1032 ◽  
Author(s):  
Illias Tsaparas ◽  
Harianto Rahardjo ◽  
David G Toll ◽  
Eng-Choon Leong
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Field Measurements ◽  
Residual Soil ◽  
Rainfall Runoff ◽  
Rainfall Events ◽  
Pore Water Pressures ◽  
Soil Slopes ◽  
Pressure Changes

This paper presents the analysis of a 12 month long field study of the infiltration characteristics of two residual soil slopes in Singapore. The field measurements consist of rainfall data, runoff data of natural and simulated rainfall events, and pore-water pressure changes during infiltration at several depths and at several locations on the two slopes. The analysis of the field measurements identifies the total rainfall and the initial pore-water pressures within the two slopes as the controlling parameters for the changes in the pore-water pressures within the slopes during infiltration.Key words: infiltration, rainfall, runoff, pore-water pressure, field measurements.

Downslope movements at shallow depths related to cyclic pore-pressure changes

1993 ◽  
Vol 30 (3) ◽  
pp. 464-475 ◽  
Author(s):  
K.D. Eigenbrod
Keyword(s):  
Pore Water ◽  
Slip Surface ◽  
Pore Water Pressure ◽  
Limit Equilibrium ◽  
Water Pressure ◽  
Ground Surface ◽  
Soil Mass ◽  
Passive Resistance ◽  
Pressure Changes ◽  
Timber Piles

Slow, shallow ground movements in a slope near Yellowknife caused excessive tilting of timber piles that supported an engineering structure. To avoid damage to the structure, the pile foundations had to be replaced by rigid concrete piers that were designed to resist the forces of the moving soil mass. Downhill movements were rather slow and, during an initial inspection, were indicated only by soil that was pushed up against a series of piles on their uphill sides, while gaps had formed on their downhill sides. No open cracks or bulging was observed on the slope. A stability analysis indicated that the slope was not in a state of limit equilibrium. To obtain a better understanding of the creep movements in the slope and their effect on the rigid concrete piers, extensive instrumentation was carried out after the construction of the piers. This included slope indicators, piezometers, thermistors, and total-pressure cells against one of the concrete piers. In addition, a triaxial testing program was undertaken in which the effect of cyclic pore-water pressure changes on the long-term deformations of the shallow clay layer was investigated. From the data collected in the field and laboratory, it could be concluded that (i) tilting of the original timber piles was caused by downslope movements related to cyclic pore-water increases; (ii) the lateral soil movements increased almost linearly with depth from 2 m below the ground surface, with no indication of a slip surface; and (iii) the pressures exerted by the moving soil mass against the rigid concrete piers within the soil mass were equal to the passive resistance activated within the moving soil mass. Key words : soil creep, slope movements, soil pressures, pore-water pressures, freezing pressures, permafrost, cyclic loading.

In Situ Study on Soil Disturbance Induced by Shield Tunneling in Tianjin

2013 ◽  
Vol 368-370 ◽  
pp. 1674-1677
Author(s):  
Yong Hua Cao ◽  
Xiao Qiang Kou
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Soil Disturbance ◽  
Ground Settlement ◽  
Soil Pressure ◽  
Shield Tunneling ◽  
Tunnel Face ◽  
Tunneling Process

In urban environment, the soil disturbance induced by shield tunneling can be sensitive because it can cause deformation of the ground and damage the near structure. To study this disturbance in the construction process of Tianjin metro line No.3, in-situ monitoring of pore water pressure, soil pressure and ground settlement were conducted. The pore water pressure was monitored for the soil around the tunnel. The soil pressure was monitored for the soil around the tunnel and on the tunnel face. It was revealed that the pore water pressure and soil pressure changed twice in the tunneling process and these changes were induced by cutting face and grouting at the shield tail. The soil pressure on the tunnel face reached its maximal value when the distance between the cutting face and the sensor elements was around the diameter of the tunnel. Ground settlement developed in the tunneling process. The shape of ultimate settlement trough is closed to the one obtained by Pecks method.

Mini suction probe for matric suction measurements

2002 ◽  
Vol 39 (6) ◽  
pp. 1427-1432 ◽  
Author(s):  
Inge Meilani ◽  
Harianto Rahardjo ◽  
Eng-Choon Leong ◽  
Delwyn G Fredlund
Keyword(s):  
Pore Water ◽  
Unsaturated Soils ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Matric Suction ◽  
Lateral Direction ◽  
Triaxial Apparatus ◽  
Specimen Height ◽  
Pressure Changes ◽  
Accurate Reading

A modified triaxial apparatus with mini suction probes was fabricated to study the matric suction along the specimen height during unsaturated triaxial testing. Three mini suction probes were placed at 3/4, 1/2, and 1/4 height of the specimen, each at 120° apart in the lateral direction. This paper presents the development of the mini probe for matric suction measurements. Evaluation of the performance shows that the fabricated mini probe provides a rapid response and accurate reading under negative and positive pore-water pressure changes. Matric suctions as high as 400 kPa were successfully measured on soil specimens over a time span of 15 h. On the other hand, the mini suction probes were also found to be able to measure a matric suction of 200 kPa for a longer period of 155 h.Key words: matric suction, mini suction probe, triaxial, unsaturated soils, mid-height pore-water pressure measurement.

Sign in / Sign up

Export Citation Format

Share Document