Grain Boundary Migration and Grain Growth Texture Evolution in Zn in a High Magnetic Field

2011 ◽  
Vol 702-703 ◽  
pp. 635-638
Author(s):  
Christoph Günster ◽  
Dmitri A. Molodov ◽  
Günter Gottstein
Keyword(s):  
Magnetic Field ◽  
Grain Boundary ◽  
Grain Growth ◽  
Texture Evolution ◽  
Boundary Migration ◽  
Activation Parameters ◽  
Boundary Plane ◽  
Grain Boundary Migration ◽  
Cold Rolled

The magnetically driven motion of planar symmetrical and asymmetrical <> tilt grain boundaries in high purity (99,995%) zinc bicrystals was measured in-situ by means of a po­la­rization microscopy probe in the temperature range between 330°C and 415°C and the corres­pon­ding migration activation parameters were obtained. The results revealed that grain boundary mobi­lity essentially depends on the misorientation angle and the inclination of the boundary plane. The magnetic annealing of the cold rolled (90%) Zn-1.1%Al sheet specimens resulted in an asymmetry of the two major texture components. This effect is attributed to a magnetic driving force for grain growth. The grain microstructure evolution was also essentially affected by a magnetic field.

Magnetically Controlled Grain Boundary Migration and Microstructure Evolution in Zn

2013 ◽  
Vol 333 ◽  
pp. 101-106
Author(s):  
Dmitri A. Molodov ◽  
Christoph Günster ◽  
Günter Gottstein
Keyword(s):  
Magnetic Field ◽  
Grain Boundary ◽  
Grain Boundaries ◽  
Microstructure Evolution ◽  
Boundary Migration ◽  
Grain Boundary Migration ◽  
Boundary Mobility ◽  
Grain Boundary Mobility ◽  
Cold Rolled

The migration of planar grain boundaries induced by a magnetic field was measured in specially grown zinc bicrystals (99.995%). Particularly, symmetrical and asymmetrical <> tilt grain boundaries with rotation angles in the range between 60° and 90° were investigated. Boundary migration was measured in-situ in the temperature range between 330°C and 415°C and the absolute values of grain boundary mobility were obtained. The results revealed that grain boundary mobility essentially depends on the misorientation angle and the inclination of the boundary plane. An application of a magnetic field during the annealing of cold rolled (90%) Zn-1.1%Al sheet specimens substantially affected the texture and microstructure evolution. This effect is attributed to the additional magnetic driving force for grain growth arising due to the magnetic anisotropy of zinc.

In Situ Measurements of Magnetically Driven Grain Boundary Migration in Zn Bicrystals

2012 ◽  
Vol 715-716 ◽  
pp. 467-472
Author(s):  
Christoph Günster ◽  
Dmitri A. Molodov ◽  
Günter Gottstein
Keyword(s):  
Grain Boundary ◽  
Activation Enthalpy ◽  
Boundary Migration ◽  
Activation Parameters ◽  
Grain Boundary Migration ◽  
Boundary Mobility ◽  
Exponential Factor ◽  
Grain Boundary Mobility ◽  
Enthalpy Changes

The results of investigations of magnetically driven grain boundary migration in high purity (99.995%) zinc bicrystals are presented. In-situ measurements were conducted by means of a specially designed and fabricated polarization microscopy probe. The migration of planar tilt grain boundaries with various misorientation angles in the range between 60° and 90° was studied. The absolute grain boundary mobility and its temperature dependence was measured in the regime between 330°C and 415°C and the corresponding migration activation parameters were determined. The results revealed that there is a pronounced misorientation dependence of grain boundary mobility in the investigated angular range. The migration activation enthalpy was found to vary between 1.18 eV and 2.15 eV. The obtained activation parameters comply with the compensation law, i.e. the migration activation enthalpy changes linearly with the logarithm of the pre-exponential factor.

Mechanisms of New Orientation Formation during Recrystallization of Old Deformed Aluminium Bicrystals

2005 ◽  
Vol 495-497 ◽  
pp. 1249-1254 ◽  
Author(s):  
Henryk Paul ◽  
Julian H. Driver ◽  
Arnaud Lens
Keyword(s):  
Grain Boundary ◽  
Boundary Migration ◽  
Grain Boundary Migration ◽  
Pure Aluminium ◽  
Local Orientation ◽  
Sample Heating ◽  
Orientation Mapping ◽  
Grain Orientations ◽  
Slip Planes

The crystallography of recrystallization nucleation has been investigated in channel-die deformed pure aluminium bicrystals with {100}<011>/{110}<001> and {100}<001>/{110}<001> orientations. The new grain orientations and misorientations were followed by systematic local orientation measurements using SEM and semi-automatic measurements in a TEM. In particular, orientation mapping combined with in-situ sample heating was used to investigate the formation and growth of new grains and their crystallographic orientation changes at very early stages of recrystallization. Grain boundary migration and ‘consumption’ of the as-deformed areas was always favoured along directions parallel to the traces of the {111} slip planes that had been most active during deformation. The orientations of the first formed nuclei were misoriented with respect to the orientations identified within the neighbouring deformed areas by α(<111>, <112>, or <100>)relations.

Texture and Ductility of Ni3Al Foils

2011 ◽  
Vol 306-307 ◽  
pp. 116-119
Author(s):  
Masahiko Demura ◽  
Ya Xu ◽  
Toshiyuki Hirano
Keyword(s):  
Grain Boundary ◽  
Grain Growth ◽  
Memory Effect ◽  
Texture Evolution ◽  
High Mobility ◽  
Two Stage ◽  
Texture Memory ◽  
Highly Effective ◽  
Cold Rolled

This article presents the texture evolution and the ductility improvement of the cold-rolled foils of boron-free Ni3Al during the recrystallization and the subsequent grain growth. The cold-rolled foils had sharp {110} textures. After the recrystallization at 873K/0.5h, the texture was disintegrated with several texture components. Interestingly, most of them had a single rotation relationship. i.e. 40˚ around <111>. With the progress of the grain growth, however, the texture returned to the sharp, cold-rolled textures. This two-stage texture evolution, called as “Texture memory effect”, was explained assuming a high mobility of the grain boundary with the 40˚<111> rotation relationship. The texture returning was highly effective to improve the ductility of the foils.

scholarly journals In Situ Hvem Study of Ion Irradiation-Induced Grain Growth in Au Thin Films

1988 ◽  
Vol 128 ◽  
Author(s):  
Joyce C. Liu ◽  
Jian Li ◽  
J. W. Mayer ◽  
Charles W. Allen ◽  
Lynn E. Rehn
Keyword(s):  
Grain Growth ◽  
Room Temperature ◽  
Ion Irradiation ◽  
Boundary Migration ◽  
Grain Boundary Migration ◽  
Average Grain Size ◽  
In Situ Observations ◽  
Au Thin Films ◽  
Grain Coalescence

ABSTRACTIn situ observations of 1.5 MeV Xe+ ion irradiated Au films at room temperature and at 150°C reveal the evolution of grain growth: the average grain size increases by the mechanisms of grain boundary migration and grain coalescence.

Microstructure and Mechanical Properties of Mo2FeB2 Based Cermets Containing SiC Whisker

2012 ◽  
Vol 625 ◽  
pp. 304-307 ◽  
Author(s):  
Hai Zhou Yu ◽  
Wen Jun Liu ◽  
Lian Ying ◽  
Min You
Keyword(s):  
Mechanical Properties ◽  
Fracture Toughness ◽  
Grain Boundary ◽  
Grain Growth ◽  
Rupture Strength ◽  
Boundary Migration ◽  
Grain Boundary Migration ◽  
Hard Phase ◽  
Maximum Hardness ◽  
Vacuum Sintering

Four series of cermets with the SiC whisker content between 0 and 1.0 wt.% were prepared by vacuum sintering. The transverse rupture strength (TRS), hardness (HRA) and fracture toughness (KIC) were also measured. The SiC whiskeraddition was located at the grain boundaries, which prevented grain boundary migration and restrained the grain growth. However, an increasing SiC whisker content decreased the wettability of the binder on the Mo2FeB2 hard phase. The highest TRS and fracture toughness was found for the cermets with 0.5 wt.% SiC whisker addition, whereas the cermets without SiC whisker addition exhibited the maximum hardness.

In situ atomistic observation of grain boundary migration subjected to defect interaction

2020 ◽  
Vol 199 ◽  
pp. 42-52 ◽  
Author(s):  
Q. Zhu ◽  
S.C. Zhao ◽  
C. Deng ◽  
X.H. An ◽  
K.X. Song ◽  
...  
Keyword(s):  
Grain Boundary ◽  
Boundary Migration ◽  
Grain Boundary Migration ◽  
Defect Interaction

Effect of Strong Magnetic Field on the Discontinuous and Continuous Precipitation in AZ91 Mg Alloy

2005 ◽  
Vol 488-489 ◽  
pp. 849-852 ◽  
Author(s):  
Jie Dong ◽  
Z.F. Li ◽  
Xiao Qing Zeng ◽  
Chen Lu ◽  
Wen Jiang Ding
Keyword(s):  
Magnetic Field ◽  
Grain Boundary ◽  
Aging Process ◽  
Volume Diffusion ◽  
Discontinuous Precipitation ◽  
Boundary Migration ◽  
Grain Boundary Migration ◽  
Az91 Magnesium Alloy ◽  
Continuous Precipitation ◽  
Az91 Magnesium

A strong static magnetic field (SSMF) of about 10 T was introduced to the aging process of AZ91 magnesium alloy. Comparing with conventional aging, in the first stage of aging with SSMF, discontinuous precipitation of Mg17Al12 at grain boundary was accelerated. The magnetically induced grain boundary migration might be responsible for this acceleration effect. The density of the Mg17Al12 continuous precipitates inside the grains was increased and the precipitation plates became thinner in SSMF pre-aged specimens, which might be ascribed to the retarded volume diffusion resulted from the SSMF.

Sign in / Sign up

Export Citation Format

Share Document