Mechanical characterization and creep strengthening of AZ91 magnesium alloy by addition of yttrium oxide nanoparticles

In the current research, the authors have attempted to improve the mechanical properties and creep behavior of the magnesium alloy Mg–9Al–1Zn (AZ91) in three different stress levels. To this end, the present study investigated experimentally the addition effects of different values of yttrium oxide nanoparticles to the AZ91. In this regard, weight percentages of 0.5%, 1%, 1.5%, and 2% nanoparticles were added to the material using the vortex casting method. Then, various test specimens were fabricated based on the ASTM standards by utilizing a Computer Numerical Control lathe machine. Different experiments were performed, and the results of different groups were compared with each other. The results revealed that the addition of yttrium oxide (Y2O3) nanoparticles increases the strength of AZ91 magnesium alloy until the nanoparticles do not clump in the microstructure. In other words, the tensile strength of the nanocomposite increased by adding nanoparticles up to 1.5%, but by adding 2% of nanoparticles, we found that the tensile strength is lower than that of pure magnesium. Moreover, one of the most important achievements of this study is that if the nanoparticles do not clump in the material microstructure, the addition of Y2O3 increases the rate of stable creep (the secondary creep stage). Also, the experimental results indicated that the highest stable creep rate is related to the nanocomposite with 1.5% yttrium oxide nanoparticles. Furthermore, the maximum hardness of the material was obtained in the same case.

Al0.5CoCrFeNi2 High Entropy Alloy Particle Reinforced AZ91 Magnesium Alloy-Based Composite Processed by Spark Plasma Sintering

In this study, AZ91 magnesium-alloy-based metal matrix composites (MMCs) reinforced with 10 wt% of Al0.5CoCrFeNi2 high-entropy alloy (HEA) particles and SiC particles were prepared by a spark plasma sintering (SPS) process at 300 °C. The effects of reinforcements on the microstructure and mechanical properties of AZ91-based MMCs were studied. The results showed that AZ91–HEA composite consisted of α-Mg, Mg17Al12 and FCC phases. No interfacial reaction layer was observed between HEA particles and the Mg matrix. After adding HEA into AZ91, the compressive yield strength (C.Y.S) of the AZ91–HEA composite increased by 17% without degradation of failure strain. In addition, the increment in C.Y.S brought by HEA was comparable to that contributed by commonly used SiC reinforcement (15%). A relatively low porosity in the composite and enhanced interfacial bonding between the α-Mg matrix and HEA particles make HEA a potential reinforcement material in MMCs.

Fretting wear behavior of micro-arc oxidation coating fabricated on AZ91magnesium alloy

In this study, the effect mechanisms between the fretting wear behavior and properties of micro-arc oxidation (MAO) coatings fabricated by different anodic voltages (AVs) on AZ91 magnesium alloy were investigated. The microstructure and macroscopic mechanical properties of the MAO coatings were analyzed by various characterization means. The evolution rule of fretting wear behaviors was carried out through sliding fretting wear experiment under different test parameters. The results showed that the increased in AV increased the MAO coating surface roughness and elastic modulus. The fretting wear resistance of magnesium alloy also enhanced after treatment by MAO, and the improvement effect was positively correlated to AV. Further studies revealed that the wear mechanisms of AZ91 magnesium alloy were oxidation wear and fatigue spalling, and that of MAO coating was mixed abrasive wear and fatigue spalling.