scholarly journals Study of the Dispersive Component of the Surface Energy of Polylactides by Inverse Gas Chromatography at Infinite Dilution

2020 ◽  
Vol 11 (03) ◽  
pp. 129-136
Author(s):  
Carla Zarazir ◽  
Mohamad Rajab ◽  
Houssam Obeid ◽  
Joumana Toufaily ◽  
Imad Toufeili ◽  
...  
2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Tayssir Hamieh ◽  
Ali Ali Ahmad ◽  
Thibault Roques-Carmes ◽  
Joumana Toufaily

AbstractThe thermodynamic surface properties and Lewis acid–base constants of H-β-zeolite supported rhodium catalysts were determined by using the inverse gas chromatography technique at infinite dilution. The effect of the temperature and the rhodium percentage supported by zeolite on the acid base properties in Lewis terms of the various catalysts were studied. The dispersive component of the surface energy of Rh/H-β-zeolite was calculated by using both the Dorris and Gray method and the straight-line method. We highlighted the role of the surface areas of n-alkanes on the determination of the surface energy of catalysts. To this aim various molecular models of n-alkanes were tested, namely Kiselev, cylindrical, Van der Waals, Redlich–Kwong, geometric and spherical models. An important deviation in the values of the dispersive component of the surface energy $${\gamma }_{s}^{d}$$ γ s d determined by the classical and new methods was emphasized. A non-linear dependency of $${\gamma }_{s}^{d}$$ γ s d with the specific surface area of catalysts was highlighted showing a local maximum at 1%Rh. The study of RTlnVn and the specific free energy ∆Gsp(T) of n-alkanes and polar solvents adsorbed on the various catalysts revealed the important change in the acid properties of catalysts with both the temperature and the rhodium percentage. The results proved strong amphoteric behavior of all catalysts of the rhodium supported by H-β-zeolite that actively react with the amphoteric solvents (methanol, acetone, tri-CE and tetra-CE), acid (chloroform) and base (ether) molecules. It was shown that the Guttmann method generally used to determine the acid base constants KA and KD revealed some irregularities with a linear regression coefficient not very satisfactory. The accurate determination of the acid–base constants KA, KD and K of the various catalysts was obtained by applying Hamieh’s model (linear regression coefficients approaching r2 ≈ 1.000). It was proved that all acid base constants determined by this model strongly depends on the rhodium percentage and the specific surface area of the catalysts.


1999 ◽  
Vol 104 (1) ◽  
pp. 51-59 ◽  
Author(s):  
Mohamed M Chehimi ◽  
Marie-Laure Abel ◽  
Christian Perruchot ◽  
Michel Delamar ◽  
Stuart F Lascelles ◽  
...  

1997 ◽  
Vol 70 (5) ◽  
pp. 759-768 ◽  
Author(s):  
Hans Darmstadt ◽  
Christian Roy ◽  
Serge Kaliaguine ◽  
Helga Cormier

Abstract The surface properties of carbon blacks obtained by vacuum pyrolysis of different used rubbers (CBp) and of commercial carbon blacks were measured by inverse gas chromatography (IGC). The dispersive component of the surface energy (γsd) and the specific interaction (Isp) of the recovered CBp were lower than γsd and Isp of the virgin carbon black initially present in the rubber. However, γsd and Isp of recovered medium surface area carbon black and of virgin low-surface-area carbon black were comparable. During the pyrolysis, carbonaceous deposits are formed on the CBp surface. A correlation between γsd and Isp and the amount of the carbonaceous deposits, measured by ESCA, was found, suggesting that the formation of these deposits is responsible for the decrease of γsd and Isp.


2008 ◽  
Vol 1214 (1-2) ◽  
pp. 121-127 ◽  
Author(s):  
M. Pérez-Mendoza ◽  
M.C. Almazán-Almazán ◽  
L. Méndez-Liñán ◽  
M. Domingo-García ◽  
F.J. López-Garzón

2008 ◽  
Vol 112 (12) ◽  
pp. 3773-3785 ◽  
Author(s):  
Fabrice Mutelet ◽  
Jean-Noël Jaubert ◽  
Marek Rogalski ◽  
Julie Harmand ◽  
Michèle Sindt ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document