Research on Braking Energy Recovery Strategy of Pure Electric Vehicle

2021 ◽  
Author(s):  
Zujie Yang ◽  
Tan Gangfeng ◽  
Hongwei Ling ◽  
Puchun Zeng ◽  
Changxi Li ◽  
...  
2011 ◽  
Vol 55-57 ◽  
pp. 1560-1565
Author(s):  
Ping Sun ◽  
Xiu Min Yu ◽  
Wen Suo Yi ◽  
Hua Jie Ding ◽  
Jin Guang Liang

The energy utilization is crucial for electric or hybrid vehicles to solve the problem of braking energy recovery, especially of low speed energy recovery. In this paper, the energy transform model of electric vehicle in braking state is analyzed, and the half bridge control main circuit was selected. The energy recovery strategies and methods on the breaking process of low speed were researched. The concrete realization of parameters decision and system control was given. The results show that the energy recovery strategy and electric vehicle model can improve the energy transform efficiency in low speed state.


2019 ◽  
Vol 103 (1) ◽  
pp. 003685041987776 ◽  
Author(s):  
Shengqin Li ◽  
Bo Yu ◽  
Xinyuan Feng

Electric vehicles can convert the kinetic energy of the vehicle into electric energy for recycling. A reasonable braking force distribution strategy is the key to ensure braking stability and the energy recovery rate. For an electric vehicle, based on the ECE regulation curve and ideal braking force distribution (I curve), the braking force distribution strategy of the front and rear axles is designed to study the braking energy recovery control strategy. The fuzzy control method is adopted while the charging power limit of the battery is considered to correct the regenerative braking torque of the motor, the ratio of the regenerative braking force of the motor to the front axle braking force is designed according to different braking strengths, then the braking force distribution and braking energy recovery control strategies for regenerative braking and friction braking are developed. The simulation model of combined vehicle and energy recovery control strategy is established by Simulink and Cruise software. The braking energy recovery control strategy of this article is verified under different braking conditions and New European Driving Cycle conditions. The results show that the control strategy proposed in this article meets the requirements of braking stability. Under the condition of initial state of charge of 75%, the variation of state of charge of braking control strategy in this article is reduced by 8.22%, and the state of charge of braking strategy based on I curve reduces by 9.12%. The braking force distribution curves of the front and rear axle are in line with the braking characteristics, can effectively recover the braking energy, and improve the battery state of charge. Taking the using range of 95%–5% of battery state of charge as calculation target, the cruising range of vehicle with braking control strategy of this article increases to 136.64 km, which showed that the braking control strategy in this article could increase the cruising range of the electric vehicle.


2012 ◽  
Vol 490-495 ◽  
pp. 195-202 ◽  
Author(s):  
Xiao Bing Ning ◽  
Yao Ting Xu ◽  
Qiu Cheng Wang ◽  
Jue Jiang Chen

In order to increase the regenerative braking energy recovery and the dynamic performance of vehicle start and acceleration in the stage of brake, the hydraulic braking energy recovery system was used with the storage battery braking energy recovery system after comparing kinds of regenerative braking recovery plan and energy storage method. The system was used to do simulation and analysis in vehicle dynamic performance and energy recovery efficiency under the PID control and ECE-15 cycle. The system simulation and analysis results show that using hydraulic regenerative braking system in pure electric vehicle can significantly improve the ability of vehicle’s start-acceleration and the increase in vehicle driving range of around 28%.


Sign in / Sign up

Export Citation Format

Share Document