scholarly journals The COTUR project: Remote sensing of offshore turbulence for wind energy application

2021 ◽  
Author(s):  
Etienne Cheynet ◽  
Martin Flügge ◽  
Joachim Reuder ◽  
Jasna B. Jakobsen ◽  
Yngve Heggelund ◽  
...  
Keyword(s):  
Remote Sensing ◽  
Boundary Layer ◽  
Surface Layer ◽  
Atmospheric Boundary Layer ◽  
Wind Turbines ◽  
Microwave Radiometer ◽  
Wind Load ◽  
Offshore Wind ◽  
Offshore Wind Turbines ◽  
Sensing Technology

Abstract. The paper presents the measurement strategy and dataset collected during the COTUR (COherence of TURbulence with lidars) campaign. This field experiment took place from February 2019 to April 2020 on the southwestern coast of Norway. The coherence quantifies the spatial correlation of eddies and is little known in the marine atmospheric boundary layer. The study was motivated by the need to better characterize the lateral coherence, which partly governs the dynamic wind load on multi-megawatt offshore wind turbines. During the COTUR campaign, the coherence was studied using land-based remote sensing technology. The instrument setup consisted of three long-range scanning Doppler wind lidars, one Doppler wind lidar profiler and one passive microwave radiometer. Both the WindScanner software and Lidar Planner software were used jointly to simultaneously orient the three scanner heads into the mean wind direction, which was provided by the lidar wind profiler. The radiometer instrument complemented these measurements by providing temperature and humidity profiles in the atmospheric boundary layer. The preliminary results show an undocumented variation of the lateral coherence with the distance from the coast. The scanning beams were pointed slightly upwards to record turbulence characteristics both within and above the surface layer, providing further insight on the applicability of surface-layer scaling to model the turbulent wind load on offshore wind turbines.

scholarly journals The COTUR project: remote sensing of offshore turbulence for wind energy application

2021 ◽  
Vol 14 (9) ◽  
pp. 6137-6157
Author(s):  
Etienne Cheynet ◽  
Martin Flügge ◽  
Joachim Reuder ◽  
Jasna B. Jakobsen ◽  
Yngve Heggelund ◽  
...  
Keyword(s):  
Remote Sensing ◽  
Boundary Layer ◽  
Surface Layer ◽  
Atmospheric Boundary Layer ◽  
Wind Turbines ◽  
Microwave Radiometer ◽  
Wind Load ◽  
Offshore Wind ◽  
Data Set ◽  
Offshore Wind Turbines

Abstract. The paper presents the measurement strategy and data set collected during the COTUR (COherence of TURbulence with lidars) campaign. This field experiment took place from February 2019 to April 2020 on the southwestern coast of Norway. The coherence quantifies the spatial correlation of eddies and is little known in the marine atmospheric boundary layer. The study was motivated by the need to better characterize the lateral coherence, which partly governs the dynamic wind load on multi-megawatt offshore wind turbines. During the COTUR campaign, the coherence was studied using land-based remote sensing technology. The instrument setup consisted of three long-range scanning Doppler wind lidars, one Doppler wind lidar profiler and one passive microwave radiometer. Both the WindScanner software and LidarPlanner software were used jointly to simultaneously orient the three scanner heads into the mean wind direction, which was provided by the lidar wind profiler. The radiometer instrument complemented these measurements by providing temperature and humidity profiles in the atmospheric boundary layer. The scanning beams were pointed slightly upwards to record turbulence characteristics both within and above the surface layer, providing further insight on the applicability of surface-layer scaling to model the turbulent wind load on offshore wind turbines. The preliminary results show limited variations of the lateral coherence with the scanning distance. A slight increase in the identified Davenport decay coefficient with the height is partly due to the limited pointing accuracy of the instruments. These results underline the importance of achieving pointing errors under 0.1∘ to study properly the lateral coherence of turbulence at scanning distances of several kilometres.

Atmospheric boundary layer parameters retrieval from Stepped Frequency Microwave Radiometer measurements in tropical cyclones

2020 ◽  
Author(s):  
Nikita Rusakov ◽  
Evgeny Poplavsky ◽  
Olga Ermakova ◽  
Yuliya Troitskaya ◽  
Daniil Sergeev ◽  
...  
Keyword(s):  
Remote Sensing ◽  
Boundary Layer ◽  
Atmospheric Boundary Layer ◽  
Microwave Radiometer ◽  
Remote Sensing Data ◽  
Field Measurements ◽  
Radar Signal ◽  
Time And Space ◽  
Sensing Data ◽  
Radar Images

<p>Active microwave sensing using satellite instruments has great advantages, since in this range the absorption by clouds and atmospheric gases is noticeably reduced, it allows for round-the-clock and all-weather monitoring of the ocean. One of the main problems is concerned with obtaining the dependency between the RCS of radar signal scattered by the wavy water surface and the parameters of the atmospheric boundary layer in hurricane conditions. To obtain this dependence, we used field measurements of wind speed in a hurricane from falling NOAA GPS-sondes and SAR images from the Sentinel-1 satellite. However, there is the problem of correct collocation of remote sensing data with field measurements of the atmospheric boundary layer parameters, since they are separated in time and space. In this regard, the amount of data suitable for analysis is very limited, which forces us to look for new data sources for processing. A six-channel SFMR radiometer is also installed on board of NOAA research aircraft that measures the emissivity of the ocean surface beneath the aircraft. Thus, it becomes possible to relate the radiometric measurements of SFMR with the parameters of the atmospheric boundary layer in a tropical cyclone obtained from wind velocity profiles, since they are carried out as close as possible in time and space. Using this relation, the SFMR data and the hurricane radar images were analyzed together and an alternative method was found for constructing the dependence of the RCS on the parameters of the boundary layer.</p><p>This work was supported by the RFBR projects No. 19-05-00249, 19-05-00366, 18-35-20068 (remote sensing data analysis) and RSF No. 19-17-00209 (GPS-sondes data assimilation and processing).</p><p> </p>

scholarly journals Comparison Among the Atmospheric Boundary Layer Height Estimated From Three Different Tracers

2020 ◽  
Vol 237 ◽  
pp. 03009
Author(s):  
Gregori de Arruda Moreira ◽  
Fábio Juliano da Silva Lopes ◽  
Juan Luis Guerrero-Rascado ◽  
Pablo Ortiz-Amezcua ◽  
Alberto Cazorla ◽  
...  
Keyword(s):  
Remote Sensing ◽  
Boundary Layer ◽  
Atmospheric Boundary Layer ◽  
Microwave Radiometer ◽  
Doppler Lidar ◽  
Boundary Layer Height ◽  
Sensing Systems ◽  
Remote Sensing Systems ◽  
Lowermost Part ◽  
Atmospheric Boundary Layer Height

The Atmospheric Boundary Layer (ABL) is the lowermost part of the troposphere. In this work, we analysed the combination of ABL height estimated continuously by three different remote sensing systems: a ceilometer, a Doppler lidar and a passive Microwave Radiometer, during a summer campaign, which was held in Granada from June to August 2016. This study demonstrates as the combined utilization of remote sensing systems, based on different tracers, can provide detailed information about the height of ABL and their sublayers.

Pitch Angle Control of Floating Offshore Wind Turbines by H∞ Control

2014 ◽  
Vol 134 (8) ◽  
pp. 1096-1103 ◽  
Author(s):  
Sho Tsujimoto ◽  
Ségolène Dessort ◽  
Naoyuki Hara ◽  
Keiji Konishi
Keyword(s):  
Wind Turbines ◽  
Pitch Angle ◽  
Offshore Wind ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines

scholarly journals Maintenance Planning of Offshore Wind Turbine Using Condition Monitoring Information

2009 ◽  
Author(s):  
Jose´ G. Rangel-Rami´rez ◽  
John D. So̸rensen
Keyword(s):  
Condition Monitoring ◽  
Wind Turbines ◽  
Wind Farm ◽  
Offshore Structures ◽  
Offshore Wind ◽  
Offshore Wind Turbine ◽  
Maintenance Planning ◽  
Offshore Wind Turbines ◽  
Inspection And Maintenance ◽  
Monitoring Information

Deterioration processes such as fatigue and corrosion are typically affecting offshore structures. To “control” this deterioration, inspection and maintenance activities are developed. Probabilistic methodologies represent an important tool to identify the suitable strategy to inspect and control the deterioration in structures such as offshore wind turbines (OWT). Besides these methods, the integration of condition monitoring information (CMI) can optimize the mitigation activities as an updating tool. In this paper, a framework for risk-based inspection and maintenance planning (RBI) is applied for OWT incorporating CMI, addressing this analysis to fatigue prone details in welded steel joints at jacket or tripod steel support structures for offshore wind turbines. The increase of turbulence in wind farms is taken into account by using a code-based turbulence model. Further, additional modes t integrate CMI in the RBI approach for optimal planning of inspection and maintenance. As part of the results, the life cycle reliabilities and inspection times are calculated, showing that earlier inspections are needed at in-wind farm sites. This is expected due to the wake turbulence increasing the wind load. With the integration of CMI by means Bayesian inference, a slightly change of first inspection times are coming up, influenced by the reduction of the uncertainty and harsher or milder external agents.

Sign in / Sign up

Export Citation Format

Share Document