scholarly journals An Experimental Investigation of Al2O3-40% TiO2 Powder Amalgamated via Atmospheric Plasma Spray Coating onto SS316 Substrate and Parameter Optimization Using TLBO Algorithm

2020 ◽  
Author(s):  
Thankam Sreekumar Rajesh
Keyword(s):  
Experimental Investigation ◽  
Parameter Optimization ◽  
Plasma Spray ◽  
Spray Coating ◽  
Atmospheric Plasma Spray ◽  
Atmospheric Plasma ◽  
Tio2 Powder ◽  
Plasma Spray Coating ◽  
Tlbo Algorithm

Parametric optimization of atmospheric plasma spray coating using fuzzy TOPSIS hybrid technique

2021 ◽  
Vol 867 ◽  
pp. 159074
Author(s):  
B. Swain ◽  
M. Priyadarshini ◽  
S.S. Mohapatra ◽  
Ram K. Gupta ◽  
Ajit Behera
Keyword(s):  
Plasma Spray ◽  
Parametric Optimization ◽  
Spray Coating ◽  
Fuzzy Topsis ◽  
Atmospheric Plasma Spray ◽  
Atmospheric Plasma ◽  
Hybrid Technique ◽  
Plasma Spray Coating

scholarly journals The influence of powder feed rate on mechanical properties of atmospheric plasma spray (APS) Al-12Si coating

2019 ◽  
Vol 58 (1) ◽  
pp. 75-81
Author(s):  
Mihailo Mrdak ◽  
Bojan Medjo ◽  
Darko Veljić ◽  
Miodrag Arsić ◽  
Marko Rakin
Keyword(s):  
Mechanical Properties ◽  
Plasma Spray ◽  
Spray Coating ◽  
Fracture Morphology ◽  
Optical Microscope ◽  
Atmospheric Plasma Spray ◽  
Atmospheric Plasma ◽  
Powder Feed ◽  
Feed Control ◽  
Powder Particles

Abstract In this paper, structural and mechanical properties of APS - atmospheric plasma spray coating Al-12Si are presented. The aim of the research was the optimisation of the flow of powder to produce layers with optimal mechanical and structural properties that will be applied to the worn out parts of airplanes. Three groups of samples were produced, by utilising three powder feed rates: 30 g/min, 45 g/min and 60 g/min. Evaluation of layers’ microhardness was done using HV0.3 method and the bond strengthwas determined by testing of tensile strength. Surface morphology of the deposited powder particles was examined on SEM (Scanning Electron Microscope). The microstructure of the coating with the best measured mechanical properties was subsequently examined in etched condition on optical microscope and SEM (in accordance with the standard PN 585005, Pratt & Whitney). Also, fracture morphology of this coating in deposited state was examined using SEM. It was found that powder feed control with atmospheric plasma spraying can produce dense layers of Al-12Si coating with good bond strength.

Sign in / Sign up

Export Citation Format

Share Document