scholarly journals UV-Vis Band-Stop Filter Based on Plasmon Resonance for Fluorescent Microscopic Applications

2016 ◽  
Vol 247 (3) ◽  
pp. 13-22 ◽  
Author(s):  
R.S. Smerdov ◽  
V.V. Loboda ◽  
Y.M. Spivak ◽  
V.A. Moshnikov
Keyword(s):  
Plasmon Resonance ◽  
Band Stop Filter

scholarly journals Fabrication and characterization of plasmonic band-stop filter using Ag grating

2020 ◽  
Vol 238 ◽  
pp. 05006
Author(s):  
Atsushi Motogaito ◽  
Ryoga Tanaka ◽  
Kazumasa Hiramatsu
Keyword(s):  
Surface Plasmon Resonance ◽  
Surface Plasmon ◽  
Plasmon Resonance ◽  
Analysis Method ◽  
Grid Structure ◽  
Wire Grid ◽  
Near Ultraviolet ◽  
Band Stop Filter ◽  
Fabrication And Characterization

This study proposes a plasmonic band-stop filter with surface plasmon resonance in a doublelayer wire grid structure targeting short-wavelength visible and near-ultraviolet regions for applications in ultraviolet photography. Using Ag and Al, the rigorous coupling wave of analysis method revealed that the maximum absorption was approximately 90% at 450 nm and 375 nm. The experiments using Ag produced similar results in a simulation. These results demonstrate that plasmonic band-stop filters in the visible and near-UV region can be realized at 450 nm and 375 nm using Ag or Al.

Comparison of sensitivity of the refractometric methods of frustrated total internal reflection and surface plasmon resonance

2020 ◽  
pp. 44-49
Author(s):  
I. N. Pavlov
Keyword(s):  
Surface Plasmon Resonance ◽  
Surface Plasmon ◽  
Plasmon Resonance ◽  
Total Internal Reflection ◽  
Resonance Method ◽  
Internal Reflection ◽  
Optical Methods ◽  
Thin Boundary Layer ◽  
Experimental Conditions ◽  
Frustrated Total Internal Reflection

Two optical methods, namely surface plasmon resonance imaging and frustrated total internal reflection, are described in the paper in terms of comparing their sensitivity to change of refractive index of a thin boundary layer of an investigated medium. It is shown that, despite the fact that the theoretically calculated sensitivity is higher for the frustrated total internal reflection method, and the fact that usually in practice the surface plasmon resonance method, on the contrary, is considered more sensitive, under the same experimental conditions both methods show a similar result.

Surface Plasmon Resonance Based Sensitive Immunosensor for Benzaldehyde Detection

2010 ◽  
Vol 130 (7) ◽  
pp. 269-274 ◽  
Author(s):  
Takeshi Onodera ◽  
Takuzo Shimizu ◽  
Norio Miura ◽  
Kiyoshi Matsumoto ◽  
Kiyoshi Toko
Keyword(s):  
Surface Plasmon Resonance ◽  
Surface Plasmon ◽  
Plasmon Resonance

Evaluation of a PAH/PSS Layer-by-Layer Deposited Film Using a Quartz-Crystal-Microbalance and Surface-Plasmon-Resonance Hybrid Sensor

2015 ◽  
Vol E98.C (2) ◽  
pp. 136-138 ◽  
Author(s):  
Keisuke KAWACHI ◽  
Kazunari SHINBO ◽  
Yasuo OHDAIRA ◽  
Akira BABA ◽  
Keizo KATO ◽  
...  
Keyword(s):  
Surface Plasmon Resonance ◽  
Surface Plasmon ◽  
Quartz Crystal Microbalance ◽  
Plasmon Resonance ◽  
Quartz Crystal ◽  
Layer By Layer ◽  
Deposited Film ◽  
Resonance Hybrid

High Sensitivity of Phase-based Surface Plasmon Resonance in Nano-cylinder Array

PIERS Online ◽  
2008 ◽  
Vol 4 (7) ◽  
pp. 746-750 ◽  
Author(s):  
Bing-Hung Chen ◽  
Yih-Chau Wang ◽  
Jia-Hng Lin
Keyword(s):  
Surface Plasmon Resonance ◽  
Surface Plasmon ◽  
Plasmon Resonance ◽  
High Sensitivity ◽  
Cylinder Array
Sign in / Sign up

Export Citation Format

Share Document