scholarly journals Effect of Electric Field on Dielectric Constant and Loss Tangent in ADP Crystal

2017 ◽  
Vol 6 (2) ◽  
2014 ◽  
Vol 17 (4) ◽  
pp. 109-113 ◽  
Author(s):  
Ján Novák ◽  
Ivan Vitázek

Abstract This work contains the results of measuring the electrical properties of sunflower achenes. The interest in electrical properties of biological materials resulted in engineering research in this field. The results of measurements are used for determining the moisture content, the surface level of liquid and grainy materials, for controlling the presence of pests in grain storage, for the quantitative determination of mechanical damage, in the application of dielectric heating, and in many other areas. Electrical measurements of these materials are of fundamental importance in relation to the analysis of quantity of absorbed water and dielectric heating characteristics. It is a well-known fact that electrical properties of materials, namely dielectric constant and conductivity, are affected by the moisture content of material. This fact is important for the design of many commercial moisturetesting instruments for agricultural products. The knowledge of dielectric properties of materials is necessary for the application of dielectric heating. The aim of this work was to measure conductivity, dielectric constant and loss tangent on samples of sunflower achenes, the electrical properties of which had not been sufficiently measured. Measurements were performed under variable moisture content and the frequency of electric field ranging from 1 MHz to 16 MHz, using a Q meter with coaxial probe. It was concluded that conductivity, dielectric constant and loss tangent increased with increasing moisture content, and dielectric constant and loss tangent decreased as the frequency of electric field increased.


2018 ◽  
Vol 21 (1) ◽  
pp. 18-23
Author(s):  
Ján Novák

AbstractThis paper contains the results of the electric properties measurement of lentil set. Electric measurements with use of these materials are of fundamental importance in relation to the analysis of quantity of absorbed water and dielectric heating characteristics. The aim of this paper was to perform the measurements of conductivity, dielectric constant and loss tangent on samples of lentil, the electrical properties of which had not been sufficiently measured. Measurements were performed under various moisture contents, and the frequency of electric field ranged from 1 MHz to 16 MHz, using a Q meter with coaxial probe. It was concluded that conductivity, relative permittivity and loss tangent increased with an increase in moisture content, and dielectric constant and loss tangent decreased as the frequency of electric field increased.


2013 ◽  
Vol 16 (2) ◽  
pp. 43-46
Author(s):  
Ján Novák

Abstract This work contains the results of measuring the electrical properties of popcorn grains. Interest in electrical properties of biological materials resulted in engineering research in this field. The results of measurements are used for determining the moisture content, the surface level of liquid and grainy materials, for controlling the presence of pests in grain storage, for a quantitative determination of mechanical damage, in applications of dielectric heating, and in many other cases. Electrical measurements on these materials are of fundamental importance in relation to the analysis of quantity of absorbed water and dielectric heating characteristics. It is a well-known fact that electrical properties of materials, namely dielectric constant and conductivity, are affected by the moisture content of material. This fact is important for the design of many commercial moisture-testing instruments for agricultural products. The knowledge of dielectric properties of materials is necessary for the application of dielectric heating. The aim of this work was to perform the measurements of conductivity, dielectric constant and loss tangent on samples of popcorn grains, the electrical properties of which had not been sufficiently measured. Measurements were performed under variable moisture content and the frequency of electric field in the range from 1 MHz to 16 MHz, using a Q meter with a coaxial probe. It was concluded that conductivity, dielectric constant and loss tangent increased with increase of moisture content, and dielectric constant and loss factor decreased as the frequency of electric field increased.


Author(s):  
A. Ege Engin ◽  
Abdemanaf Tambawala ◽  
Madhavan Swaminathan ◽  
Swapan Bhattacharya ◽  
Pranabes Pramanik ◽  
...  

2016 ◽  
Vol 78 (6-2) ◽  
Author(s):  
See Khee Yee ◽  
Samsul Haimi Dahlan ◽  
Mohd Zarar Mohd Jenu ◽  
Chee Kiong Sia

This paper presents the method to predict the shielding effectiveness of cement powder mixed with different amount of graphite powder. Cement mixed with different percentage of graphite is prepared. Their dielectric constant and loss tangent are measured based on the transmission/reflection technique using APC7 connector. The measured data is fed into Artificial Neural Network (ANN) for training. When the training process is completed the neural network is used to predict the dielectric constant and loss tangent of cement-graphite mixture that contains different amount of graphite. The comparison shows that the trained neural network is very successful to predict the dielectric constant and loss tangent of cement-graphite mixture. The proposed graphical user interface has made the process of shielding effectiveness prediction becomes more user friendly especially for those designers who are not familiar with the analytical calculation of shielding effectiveness and dielectric measurement.


2012 ◽  
Vol 512-515 ◽  
pp. 1180-1183
Author(s):  
Qian Qian Jia ◽  
Hui Ming Ji ◽  
Shan Liu ◽  
Xiao Lei Li ◽  
Zheng Guo Jin

The (Ba, Sr)TiO3 (hereafter BST) ceramics are promising candidate for applying in tunable devices. MgO coated BST-Mg2TiO4 (BSTM-MT) composite ceramics were prepared to obtain the low dielectric constant, low dielectric loss, good dielectric constant temperature stability, and high tunability of BST ceramics. The Ba0.55Sr0.40Ca0.05TiO3 nanoparticles were coated with MgO using the precipitation method and then mixed with Mg2TiO4 powders to fabricate BSTM-MT composite ceramics. The morphologies, phases, elements, and dielectric properties of the sintered ceramics were investigated. The core-shell structure of BST powder wrapped with MgO was clearly observed from the TEM image. After sintered at 1100 °C for 2 h, the composite ceramics expressed dense microstructures from SEM images and two main phases BST and Mg2TiO4 were detected in the XRD patterns. The dielectric constant and loss tangent were both reduced after the coating. The reduced dielectric constant and loss tangent of BSTM-MT were 190, 0.0011 (2MHz), respectively. The ceramics exhibited the diffuse phase transition near the Curie temperature and the Curie temperature shifted from 10 °C to 5 °C after the coating. Since the continuous Ti-O bonds were disconnected with the MgO coating, the tunability was reduced to 15.14 % under a DC bias field of 1.1 kV/mm. The optimistic dielectric properties made it useful for the application of tunable capacitors and phase shifters.


2019 ◽  
Vol 29 (7) ◽  
pp. 501-503 ◽  
Author(s):  
Kangmin Zhou ◽  
Sylvain Caroopen ◽  
Yan Delorme ◽  
Michele Batrung ◽  
Maurice Gheudin ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document