Electron glass signatures up to room temperature in disordered insulators

This paper describes the observation of non-equilibrium field effects at room temperature in four disordered insulating systems: granular Al, discontinuous Au, amorphous NbSi and amorphous InOx thin films. The use of wide enough gate voltage ranges and a cautious analysis of the data allow us to uncover memory dips, the advocated hallmark of the electron glass, in the four systems. These memory dips are found to relax slowly over days of measurements under gate voltage changes, reflecting the impossibility for the systems to reach an equilibrium state within experimentally accessible times. Our findings demonstrate that these electrical glassy effects, so far essentially reported at cryogenic temperatures, actually extend up to room temperature.

Probing dark exciton navigation through a local strain landscape in a WSe2 monolayer

In WSe2 monolayers, strain has been used to control the energy of excitons, induce funneling, and realize single-photon sources. Here, we developed a technique for probing the dynamics of free excitons in nanoscale strain landscapes in such monolayers. A nanosculpted tapered optical fiber is used to simultaneously generate strain and probe the near-field optical response of WSe2 monolayers at 5 K. When the monolayer is pushed by the fiber, its lowest energy states shift by as much as 390 meV (>20% of the bandgap of a WSe2 monolayer). Polarization and lifetime measurements of these red-shifting peaks indicate they originate from dark excitons. We conclude free dark excitons are funneled to high-strain regions during their long lifetime and are the principal participants in drift and diffusion at cryogenic temperatures. This insight supports proposals on the origin of single-photon sources in WSe2 and demonstrates a route towards exciton traps for exciton condensation.

Excitonic absorption and defect-related emission in three-dimensional MoS2 pyramids

In this work, we study the excitonic absorption and cathodoluminescence emission of MoS2 micro-pyramids grown by chemical vapor deposition on SiO2 substrates, obtained at room and cryogenic temperatures.

Voltage Followers for the Design of Sallen-Key Active Rc-Filters

In this paper consider the circuitry of voltage followers (VF) with unity-gain, intended for practical use in active Sallen-Key RC-filters (LPF, HPF, BPF, RF). The results of research and computer modeling of radiation-resistant and low-temperature VF in the LTSpice environment on models of CJFET transistors operating under the influence of neutron flux up to 10e14 n/cm2 and cryogenic temperatures up to -197°C are presented.

Drag Voltages in a Superconductor/Insulator/Ferromagnet Trilayer

The interaction between two spatially separated systems is of strong interest in order to study a wide class of unconventional effects at cryogenic temperatures. Here we report on drag transverse voltage effects in multilayered systems containing superconducting and ferromagnetic materials. The sample under test is a conventional superconductor/insulator/ferromagnet (S/I/F) trilayer in a cross configuration. S/F as well as S/N (here N stands for normal metal) bilayers in the same geometry are also analyzed for comparison. Current–voltage (I–V) characteristics measured at T = 4.2 K in the presence of a perpendicular magnetic field show strong peculiarities related to the interaction between the layers. The results are interpreted in terms of interaction effects between the layers.

Natural Oil-Based Rigid Polyurethane Foam Thermal Insulation Applicable at Cryogenic Temperatures

This paper presents research into the preparation of rigid polyurethane foams with bio-polyols from rapeseed and tall oil. Rigid polyurethane foams were designed with a cryogenic insulation application for aerospace in mind. The polyurethane systems containing non-renewable diethylene glycol (DEG) were modified by replacing it with rapeseed oil-based low functional polyol (LF), obtained by a two-step reaction of epoxidation and oxirane ring opening with 1-hexanol. It was observed that as the proportion of the LF polyol in the polyurethane system increased, so too did the apparent density of the foam material. An increase in the value of the thermal conductivity coefficient was associated with an increase in the value of apparent density. Mechanical tests showed that the rigid polyurethane foam had higher compressive strength at cryogenic temperatures compared with the values obtained at room temperature. The adhesion test indicated that the foams subjected to cryo-shock obtained similar values of adhesion strength to the materials that were not subjected to this test. The results obtained were higher than 0.1 MPa, which is a favourable value for foam materials in low-temperature applications.