STRUCTURE AND ELECTROPHYSICAL PROPERTIES OF PVDF+PbS/CdS NANOCOMPOSITES

In the given paper were investigated structure and electrophysical properties of PVDF+PbS/CdS nanocomposites. Distribution and the size of PbS and CdS nanoparticles in the polymer matrix has been studied by scanning electron microscopy (JEOL JSM-7600 F). The structure of the nanocomposite samples was investigated by the X-ray diffraction spectroscopy. The dependence of dielectric permittivity at frequency and temperature was investigated. It was shown that the dielectric permittivity of PVDF+PbS/CdS nanocomposite samples was increase in small nanoparticles content. Further increase in the concentration of the filler leads to decrease in the dielectric permittivity. The subsequent decrease in dielectric permittivity at higher nanoparticles content can be explained by the increase in defects in the structure of the nanocomposite.

Synthesis and Photocatalytic Activity of TiO2/CdS Nanocomposites with Co-exposed Anatase Highly Reactive Facets

In this work, TiO2/CdS nanocomposites with co-exposed {101}/[111]-facets (NH4F-TiO2/CdS), {101}/{010} facets (FMA-TiO2/CdS), and {101}/{010}/[111]-facets (HF-TiO2/CdS and Urea-TiO2/CdS) were successfully synthesized through a one-pot solvothermal method by using [Ti4O9]2− colloidal solution containing CdS crystals as the precursor. The crystal structure, morphology, specific surface area, pore size distribution, separation, and recombination of photogenerated electrons/holes of the TiO2/CdS nanocomposites were characterized. The photocatalytic activity and cycling performance of the TiO2/CdS nanocomposites were also investigated. The results showed that as-prepared FMA-TiO2/CdS with co-exposed {101}/{010} facets exhibited the highest photocatalytic activity in the process of photocatalytic degradation of methyl orange (MO), and its degradation efficiency was 88.4%. The rate constants of FMA-TiO2/CdS was 0.0167 min−1, which was 55.7, 4.0, 3.7, 3.5, 3.3, and 1.9 times of No catalyst, CdS, HF-TiO2/CdS, NH4F-TiO2/CdS, CM-TiO2, Urea-TiO2/CdS, respectively. The highest photocatalytic activity of FMA-TiO2/CdS could be attributed to the synergistic effects of the largest surface energy, co-exposed {101}/{010} facets, the lowest photoluminescence intensity, lower charge-transfer resistance, and a higher charge-transfer efficiency.

Facile decoration of CdS nanoparticles on TiO2: robust photocatalytic activity under LED illumination

A facile approach is presented to obtain visible-light-active TiO2/CdS nanocomposites with visible-light photocatalytic activity. Ordered nanospheres of TiO2 (with anatase as the main crystalline phase) were synthesized using evaporation-induced self-assembly (EIS) with P123 block polymer without any hazardous additives. Then, a rapid microwave (MW) protocol was used to obtain visible-light-absorbing nanocomposites between TiO2 and CdS in just 10 s. Based on Rietveld refinements of X-ray diffractrograms and elemental analysis it was found that nanoparticles of CdS are mainly decorated between the nanospheres of TiO2, which can simultaneously improve light absorption and suppress the unwanted photo-corrosion effects. The prepared nanocomposites were put to test for the removal of malachite green as a model pollutant from aqueous media under irradiation. The results revealed, that excessive loading results in unwanted surface covering and less than ideal activity, but for the sample with optimized loading, about 86 and 77% of the pollutant was degraded after 100 min of illumination at room temperature under the xenon short-arc and LED illumination, respectively.