New Low-Frame-Rate Compensating Pixel Circuit Based on Low-Temperature Poly-Si and Oxide TFTs for High-Pixel-Density Portable AMOLED Displays

A new low-frame-rate active-matrix organic light-emitting diode (AMOLED) pixel circuit with low-temperature poly-Si and oxide (LTPO) thin-film transistors (TFTs) for portable displays with high pixel density is reported. The proposed pixel circuit has the excellent ability to compensate for the threshold voltage variation of the driving TFT (ΔVTH_DTFT). By the results of simulation based on a fabricated LTPS TFT and a-IZTO TFT, we found that the error rates of the OLED current were all lower than 2.71% over the range of input data voltages when ΔVTH_DTFT = ±0.33 V, and a low frame rate of 1 Hz could be achieved with no flicker phenomenon. Moreover, with only one capacitor and two signal lines in the pixel circuit, a high pixel density and narrow bezel are expected to be realized. We revealed that the proposed 7T1C pixel circuit with low driving voltage and low frame rate is suitable for portable displays.

In-Pixel CTIA & Readout Circuitry for an Active CMOS Image Sensor

This work aims to design and simulate an in-pixel Capacitive Transimpedance Amplifier (CTIA) and peripheral circuitry that ensures pixel reading. Each pixel circuit is composed of four transistors using 90nm CMOS technology with a supply voltage of 1.8 V and is part of an array of pixels that make up a CMOS image sensor with peripheral circuitry. Pixel output is sent to a delta difference sampling (DDS) circuit to filter reset voltages. The Gain Margin achieved for the in-pixel CTIA is 44dB and 91dB for the Phase Margin. We also present measured pixel parameters and give a comparison with prior work. The timing and readout circuitry is also described.