Measurement of the spatial-energy distribution of neutrons in the irradiation channel of the critical facility

One of the basic installations of the Republican State Enterprise “Institute of Nuclear Physics” of the Ministry of Energy of the Republic of Kazakhstan is a critical assembly, which is a zero-power reactor. Desalinated water and beryllium serve as moderators and neutrons reflectors. The energy spectrum of neutrons in the core is thermal. The main purpose and area of application is the modeling and study of the neutronic characteristics of the cores of water-moderated research reactors of various types. The paper presents the results of experimental measurements of the spatial-energy distribution of neutrons in the dry, central channel of the critical assembly. Measurements of the neutron flux were carried out using activation foils for three energy groups of neutrons: thermal, epithermal, and fast. The measured thermal neutrons flux in the irradiation channel is ~ 3·108 cm‒2s‒1, and fast neutrons flux (with energies above 0.7 MeV) is ~ 8·108 cm‒2s‒1. The fraction of thermal neutrons in the integral flux was 0.23%, and the fraction of fast neutrons was 0.62%. In the axial distribution of thermal and fast neutrons, the maximum value of the neutron flux is 50 mm below the midplane of the core.

Conceptual design of critical assembly using Low enriched uranium fuel and moderated light wate

Critical assembly is a very important facility to serve for fundamental reactor physics research, application of neutron source, training and education. In nuclear engineering, critical assembly is a facility for carrying out measurement of reactor physics parameters, creating benchmark problem, validation of neutron physics calculation tool in computer codes and nuclear data. Basing on concept using commercial Nuclear Power Plant (NPP) fuels such as PWR (AP-1000) and VVER-1000 fuel rods with limited 2 meter in length and fully controlled by water level, the conceptual design of the critical assembly has been carried out in neutronic, thermal hydraulics and safety analysis. Ten benchmark critical core configurations of critical assembly are established and investigated to show safety during normal opeartion and accident conditions. Design calculation results show that NPP fuels are fully adequate for critical assembly operating under nominal power 100W and having average neutron flux about 3×109 neutron/cm2.s.