releasing effect
Recently Published Documents


TOTAL DOCUMENTS

171
(FIVE YEARS 11)

H-INDEX

30
(FIVE YEARS 2)

2021 ◽  
Vol 2021 ◽  
pp. 1-16
Author(s):  
Xingen Ma ◽  
Manchao He ◽  
Xuewei Sun ◽  
Jianfeng Li ◽  
Gang He ◽  
...  

Gob-side entry retaining technology with roof cutting (GERRC) has been widely used in flat and near-flat coal seam conditions, but its application under inclined coal seam is still very deficient. In order to further improve the application system of GERRC and overcome the application difficulties under special geological conditions, this paper takes the 43073 working face of Yixin coal mine as an example to research the GERRC with upper roadway under gently inclined thick coal seam. Firstly, the difficulties in the upper entry retaining with inclined coal seam are analyzed and the corresponding key technologies and system designs are put forward. Subsequently, the roof cutting and upper entry retaining are designed in detail according to geological conditions of test working face, and the roof cutting and pressure releasing effect is analyzed by numerical simulation to expound the stress distribution and pressure releasing mechanism of surrounding rock. Finally, the upper entry retaining field test is carried out to verify the feasibility and applicability of the technology and related designs. Through field monitoring, it is found that the weighting step increases significantly, the weighting strength decreases effectively on the roof cutting side, and the pressure relief effect is obvious. Meanwhile, the maximum roof to floor convergence is 361 mm and the maximum shrinkage of both sides is 280 mm, so the retained entry can meet the reuse requirement of adjacent working face.


2021 ◽  
Vol 2021 ◽  
pp. 1-14
Author(s):  
Xingen Ma ◽  
Manchao He ◽  
Weidong Li ◽  
Yilong Wang ◽  
Lifeng Li ◽  
...  

The first weighting control is one of the difficult problems that cannot be avoided in the safe and efficient production of longwall mining face. To optimize the existing pressure releasing technology of open-off cut, the open-off cut roof cutting pressure releasing (OCRCPR) technology is put forward on the basis of roof cutting pressure releasing gob-side entry retaining (RCPRGER) technology. Firstly, the mechanism of the technology and the design method of related key parameters are summarized. Then the pressure releasing effect of OCRCPR and the stress environment change under this technology are analyzed by mechanics calculation and numerical simulation, respectively, which verify the feasibility of the OCRCPR technology from the theoretical level. Finally, a test mining face is taken as an example to implement the field test. The field test results show that the OCRCPR can effectively shorten the first weighting step and weaken the first weighting strength and has a good pressure releasing effect.


ChemNanoMat ◽  
2021 ◽  
Vol 7 (4) ◽  
pp. 467-475
Author(s):  
Yu Du ◽  
Zongxian Yang ◽  
Liuyang Bai ◽  
Fei Ding ◽  
Huacheng Jin ◽  
...  

2021 ◽  
Author(s):  
M. Israr Khan ◽  
Abdul Hameed ◽  
Komal Rao ◽  
Muhammad Imran ◽  
Muhammad Raza Shah ◽  
...  

2020 ◽  
Vol 223 (15) ◽  
pp. jeb225151 ◽  
Author(s):  
Hamish Richard Charlton ◽  
David John Merritt

ABSTRACTArachnocampa larvae utilise bioluminescence to lure small arthropod prey into their web-like silk snares. The luciferin–luciferase light-producing reaction occurs in a specialised light organ composed of Malpighian tubule cells in association with a tracheal mass. The accepted model for bioluminescence regulation is that light is actively repressed during the non-glowing period and released when glowing through the night. The model is based upon foregoing observations that carbon dioxide (CO2) – a commonly used insect anaesthetic – produces elevated light output in whole, live larvae as well as isolated light organs. Alternative anaesthetics were reported to have a similar light-releasing effect. We set out to test this model in Arachnocampa flava larvae by exposing them to a range of anaesthetics and gas mixtures. The anaesthetics isoflurane, ethyl acetate and diethyl ether did not produce high bioluminescence responses in the same way as CO2. Ligation and dissection experiments localised the CO2 response to the light organ rather than it being a response to general anaesthesia. Exposure to hypoxia through the introduction of nitrogen gas combined with CO2 exposures highlighted that continuity between the longitudinal tracheal trunks and the light organ tracheal mass is necessary for recovery of the CO2-induced light response. The physiological basis of the CO2-induced bioluminescence increase remains unresolved, but is most likely related to access of oxygen to the photocytes. The results suggest that the repression model for bioluminescence control can be rejected. An alternative is proposed based on neural upregulation modulating bioluminescence intensity.


2020 ◽  
Author(s):  
Hamish Richard Charlton ◽  
David John Merritt

AbstractArachnocampa larvae utilise bioluminescence to lure small arthropod prey into their web-like silk snares. The luciferin-luciferase light-producing reaction occurs in a specialised light organ composed of Malpighian tubule cells in association with a tracheal mass. The accepted model for bioluminescence regulation is that light is actively repressed during the non-glowing period and released when glowing through the night. The model is based upon foregoing observations that carbon dioxide (CO2) – a commonly-used insect anaesthetic – produces elevated light output in whole, live larvae as well as isolated light organs. Alternative anaesthetics were reported to have a similar light-releasing effect. We set out to test this model in Arachnocampa flava larvae by exposing them to a range of anaesthetics and gas mixtures. The anaesthetics isoflurane, ethyl acetate, and diethyl ether did not produce high bioluminescence responses in the same way as CO2. Ligation and dissection experiments localised the CO2 response to the light organ rather than it being a response to general anaesthesia. Exposure to hypoxia through the introduction of nitrogen gas combined with CO2 exposures highlighted that continuity between the longitudinal tracheal trunks and the light organ tracheal mass is necessary for recovery of the CO2-induced light response. The physiological basis of the CO2-induced bioluminescence increase remains unresolved but is most likely related to access of oxygen to the photocytes. The results suggest that the repression model for bioluminescence control can be rejected. An alternative is proposed based on neural upregulation modulating bioluminescence intensity.Summary StatementCO2 was thought to act as an anaesthetic producing elevated bioluminescence in Arachnocampa. Here we show it acts directly on the light organ and does not act as an anaesthetic.


Nanomaterials ◽  
2019 ◽  
Vol 9 (4) ◽  
pp. 591 ◽  
Author(s):  
Jungin Bae ◽  
Woo-Sung Son ◽  
Kyung-Hyeon Yoo ◽  
Seog-Young Yoon ◽  
Moon-Kyoung Bae ◽  
...  

Dentin hypersensitivity (DH) is one of the most common clinical conditions usually associated with exposed dentinal surfaces. In this study, we identified the effectiveness of poly(amidoamine) (PAMAM) dendrimer-coated mesoporous bioactive glass nanoparticles (MBN) (PAMAM@MBN) on DH treatment, examining the ion-releasing effect, dentin remineralization, and the occluding effect of dentinal tubules. We synthesized MBN and PAMAM@MBN. After soaking each sample in simulated body fluid (SBF), we observed ion-releasing effects and dentin remineralization effects for 30 days. Also, we prepared 30 premolars to find the ratio of occluded dentinal tubules after applying MBN and PAMAM@MBN, respectively. The results showed that PAMAM did not disrupt the calcium ion-releasing ability or the dentin remineralization of MBN. The PAMAM@MBN showed a better occluding effect for dentinal tubules than that of MBN (p < 0.05). In terms of dentinal tubule occlusion, the gap between MBN was well occluded due to PAMAM. This implies that PAMAM@MBN could be effectively used in dentinal tubule sealing and remineralization.


Sign in / Sign up

Export Citation Format

Share Document