Voltammetric Determination of Diazepam on Antimony Film Screen-Printed Electrode in Pharmaceutical Formulations

Background: Diazepam belongs to the group of 1,4-benzodiapines. It is used for the treatment of anxiety, convulsions and as a muscle relaxant. The presence of 4,5-azomethine group enables its electrochemical detection Introduction: A screen-printed electrode modified with antimony film was used for the determination of diazepam in pharmaceutical preparations Methods: Electrode modification was done by ex-situ deposition of antimony on commercially available screen-printed electrode. Parameters affecting the electroanalytical response of the sensor, such as deposition potential, deposition time, and antimony concentration, were examined and optimized. The modified electrode showed enhanced electroactivity for diazepam reduction compared to unmodified electrode. Under optimal conditions, linear sweep voltammetry was used for the determination of analyte Results: The sensor showed linear dependence in the range from 0.5 to 10 μmol/L, the correlation coefficient was 0.9992. The limit of detection was 0.33 μmol/L, corresponding limit of quantification was 1.08 μmol/L. Modification enabled determination of diazepam in the presence of oxygen. Conclusion: The modified electrode was used for the determination of diazepam in tablets. Results confirmed the applicability of the electrochemical sensor

Disposable Injection Molded Conductive Electrodes Modified with Antimony Film for the Electrochemical Determination of Trace Pb(II) and Cd(II)

This work describes a novel electrochemical sensor fabricated by an injection molding process. This device features a conductive polymer electrode encased in a plastic holder and electroplated in situ with a thin antimony film. The antimony film sensor was applied to the determination of Pb(II) and Cd(II) by anodic stripping voltammetry (ASV). The deposition of Sb on the sensor was studied by cyclic voltammetry (CV) and microscopy. The experimental variables (concentration of the antimony plating solution, deposition potential and time, stripping waveform) were investigated, and the potential interferences were studied and addressed. The limits of detection were 0.95 μg L−1 for Pb(II) and 1.3 for Cd(II) (at 240 s of preconcentration) and the within-sensor percentage relative standard deviations were 4.2% and 4.9%, respectively, at the 25 μg L−1 level (n = 8). Finally, the sensor was applied to the determination of Pb(II) and Cd(II) in a phosphorite sample and a lake water sample.